Page 216 of 269

6
DO-IT-YOURSELF MAINTENANCE
9
!!
!
CHECKING THE ENGINE COOLANT
G050A01CM-DAT
WARNING:
Do not remove the radiator cap when the engine is hot. When the engineis hot, the engine coolant is under pressure and may erupt through the opening if the cap is removed. Youcould be seriously burned if you do not observe this precaution. Do not remove the radiator cap until theradiator is cool to touch.
WARNING:
Used motor oil may cause irritation or cancer of the skin if left in contact with the skin for prolonged periods of time. Wash your hands thoroughly with soap and warm water as soon as possible after handling used oil.
CAUTION:
Slowly pour the recommended oil
using by a funnel. Do not overfill not to damage engine.
!
WARNING:
Be very careful not to touch the radiator hose when adding the en- gine oil as it may be hot enough toburn you.
! CAUTION:
o Engine coolant can damage the finish of your car. If you spill engine coolant on the car, wash it off thoroughly with clean water.
o The engine in your vehicle has aluminum engine parts and must be protected by an ethylene-gly-col base coolant to prevent corro- sion and freezing. And, do not use the hard (tap) water. The hard water can cause engine damage from corrosion, overheating or freezing.
1. Remove the oil filler cap by turning
it counterclockwise.
2. Add oil, then check the level again. Do not overfill.
3. Replace the cap by turning it clock- wise.
NOTE: It is recommended that the engine
oil and oil filter should be changed by an authorised Hyundai dealer.
CM-aust-6.p65 5/19/2008, 6:38 PM
9
Page 218 of 269
6
DO-IT-YOURSELF MAINTENANCE
11
!
!
CHANGING THE AIR CLEANER FILTER
G070A03Y-AAT The replacement of air filter is per-
formed in the following manner.
1. Unsnap the clips around the cover.
2. When this is done, the cover can be lifted off, the old filter removed and the new filter put in its place.
Genuine Hyundai replacement parts
are recommended.
WARNING:
The cooling fan is controlled byengine coolant temperature and may sometimes operate even when the engine is not running. Use extremecaution when working near the blades of the cooling fan so that you are not injured by a rotating fanblade. As the engine coolant tem- perature decreases, the fan will au- tomatically shut off. This is a nor-mal condition.
WARNING:
Remove the radiator cap when the
radiator is cool.
OCM055005OCM055007R
CM-aust-6.p65 5/19/2008, 6:38 PM
11
Page 221 of 269

6DO-IT-YOURSELF MAINTENANCE
14
!
FILLING THE WASHER RESERVOIR
G090A01CM-DAT The washer fluid reservoir supplies
fluid to the windshield washer system. A good quality washer fluid should beused to fill the washer reservoir. The fluid level should be checked more frequently during inclement weather orwhenever the washer system is in frequent use. The capacity of the washer reservoir is 4.6 litres.
2. Pull up the wiper blade until you
hear an audible "click" to engage in the end of the wiper arm.
NOTE: Do not allow the wiper arm to fall against the windshield. HHR5051
OCM055028LCAUTION:
o Radiator anti-freeze (engine cool- ant) should not be used in the washer system because it willdamage the car's finish.
o The washer should not be oper-
ated if the washer reservoir isempty. This can damage the washer fluid pump.
!
WARNING:
o Windshield washer fluid agents contain some amounts of alcohol and can be flammable under cer-tain circumstances. Do not allow sparks of flame to contact the washer fluid or the washer fluidreservoir. Damage to the vehicle or its occupants could occur.
o Windshield washer fluid is poi- sonous to humans and animals. Do not drink windshield washerfluid. Serious injury or death could occur.
CM-aust-6.p65 5/19/2008, 6:38 PM
14
Page 222 of 269

6
DO-IT-YOURSELF MAINTENANCE
15
!
G110C01CM-GAT Transaxle Fluid Capacity See page 9-4.
WARNING:
The transaxle fluid level should be checked when the engine is at nor-mal operating temperature. This means that the engine, radiator, exhaust system etc., are very hot.Exercise great care not to burn your- self during this procedure.
G110B04A-AAT
Recommended Fluid
Your Hyundai automatic transaxle is specially designed to operate with Hyundai Genuine ATF SP-III, DIA- MOND ATF SP-III, SK ATF SP-III orother brands approved by Hyundai Motor Co., Damage caused by a nonspecified fluid is not covered byyour new vehicle limited warranty.
CHECKING THE TRANSAXLE FLUID (AUTOMATIC)
G110A02E-AAT Transaxle fluid in the automatic transaxle should be changed at those intervals specified in the vehicle main-tenance schedule in Section 5. NOTE: Automatic transaxle fluid is a red in color. As driving distance increases, the fluid color turns darkish redgradually. It is a normal condition and you should not judge the need to replace based upon the changingcolor.You must replace the automatictransaxle fluid in accordance withintervals specified in the vehicle maintenance schedule in section 5.
CM-aust-6.p65 5/19/2008, 6:38 PM
15
Page 226 of 269

6
DO-IT-YOURSELF MAINTENANCE
19CHANGING THE CLIMATE CONTROL AIR FILTER
B145A01CM-DAT
(For Evaporator and Blower Unit)
The climate control air filter is located in the passenger cabin in front of the evaporator unit behind the glove box. It helps to decrease the amount of pollutants entering the car.
1. Open the glove box and remove the adjusting pins on both sides of the glove box.
G140C01A-AAT
Lubrication
To lubricate the compressor and the seals in the system, the air condition-ing should be run for at least 10 min- utes each week. This is particularly important during cool weather whenthe air conditioning system is not oth- erwise in use.
!
G140B01A-AAT
Checking the Air Conditioning Operation
1. Start the engine and let it run at fast
idle for several minutes with the air conditioning set at the maximum cold setting.
2. If the air coming out of the in-dash vents is not cold, have the air con-ditioning system inspected by yourHyundai dealer.
CAUTION:
Running the air conditioning sys-
tem for extended periods of time with a low refrigerant level may dam- age the compressor.
OCM055010R
AIR CONDITIONING CARE
G140A01A-DAT
Keeping the Condenser Clean
The air conditioning condenser (and
engine radiator) should be checked periodically for accumulation of dirt, dead insects, leaves, etc. These caninterfere with maximum cooling effi- ciency. When removing such accumu- lations, brush or hose them away care-fully to avoid bending the cooling fins. Replacement of the filter drier
To comply with local Australian State
codes and Laws the filter drier must be replaced if the system has been opened to the atmosphere for any reason or if during servicing no refrigerant is foundin the system.
CM-aust-6.p65 5/19/2008, 6:38 PM
19
Page 263 of 269

9VEHICLE SPECIFICATIONS
4LUBRICATION CHART
Q'ty (litre)
Drain and refill (With oil filter) : 2.7 V6 : 4.5 3.3 V6 : 5.2 Drain and refill (With oil filter) : 5.9 at Oil Pan : 5.4 (MAX) 3.8 (MIN)
1.75 (Petrol) / 1.85 (Diesel) 2.7 V6 : 8.5 (Petrol) 3.3 V6 : 10.9 (Petrol) 10.9 (Diesel) 0.8 0.9 7 (Petrol) / 8.4 (Diesel) 1 As required
Item
Engine Oil *1 Petrol
Diesel
Engine
(V.G.T *2)
Transaxle Manual Automatic
Transfer caseRear Axle Coolant Power steering gear Brake and clutch fluid
Oil & Grease Standard
API SJ, SL or ABOVE, ILSAC GF-3 or ABOVE
with C.P.F *3 ACEA C3
without C.P.F *3 API CH-4 or Superior
ACEA B4
*1. Refer to the recommended SAE viscosity numbers on page 6-6. *2. V.G.T : Variable Geometry Turbocharger *3. C.P.F : Catalyzed Particulate Filter HYUNDAI GENUINE PARTS MTF 75W/85 (API GL-4) HYUNDAI GENUINE ATF SP-III, DIAMOND ATF SP-III, SK ATF SP-III or other brands approved by Hyundai Motor Co., HYPOID GEAR OIL API GL-5, SAE 75W/90 (SHELL SPIRAX X Equivalent) HYPOID GEAR OIL API GL-5, SAE 75W/90 (SHELL SPIRAX X Equivalent) Ethylene glycol base for aluminum radiator PSF-3 TYPE FLUID DOT 3, DOT 4 or Equivalent
J080A04CM-DAT
CM-aust-9.p65
5/19/2008, 6:41 PM
4