2009 HUMMER H2 Owners Manual

Power Door Locks
The power door lock switches are located on the
front doors.
Q(Lock):Remove the key from the ignition and press
to lock all of the doors.
K(Unlock):Press once to unlock the driver’s door,
and twice to unlock all of the doors.
Delayed Locking
When locking the doors with the power lock switch or
the keyless entry transmitter and a door or the liftgate
(if equipped) is open, the delayed locking feature
will delay locking the doors until ve seconds after
the last door is closed. Three chimes will sound to
signal that the delayed locking feature is in use.Pressing the power lock switch twice will override
the delayed locking feature and immediately lock
all the doors.
Delayed locking can be programmed using the DIC.
SeeDIC Vehicle Customization on page 3-64.
Programmable Automatic Door
Locks
The vehicle has an automatic power door lock/unlock
feature which can be programmed through the Driver
Information Center (DIC). SeeDIC Vehicle Customization
on page 3-64for more information on DIC programming.
2-11

Rear Door Security Locks
The vehicle may have rear door security locks which
prevent passengers from opening the rear doors
from the inside.
The rear door security
locks are located on the
inside edge of each
rear door. The rear doors
must be open to access
them. The label depicting
lock and unlock positions
is located near the lock.
To set the locks:
1. Insert the key into the security lock slot and turn it
so the slot is in the horizontal position.
2. Close the door.To open a rear door when the security lock is on:
1. Unlock the door by lifting the rear door manual lock,
by pressing the power door lock switch, or if the
vehicle has one, by using the Remote Keyless
Entry (RKE) transmitter.
2. Open the door from the outside.
To cancel the rear door security lock:
1. Unlock the door and open it from the outside.
2. Insert the key into the security lock slot and turn it
so the slot is in the vertical position.
Lockout Protection
This feature protects you from locking your key in the
vehicle when the key is in the ignition and a door is open.
If the driver side power lock switch is pressed when a
door is open and the key is in the ignition, all of the
doors will lock and then the driver door will unlock.
If the passenger side power lock switch is pressed when
a door is open and the key is in the ignition, all of the
doors will lock and then the passenger door will unlock. Security Lock Label
shown
2-12

Liftgate (SUV)
{CAUTION:
It can be dangerous to drive with the liftgate open
because carbon monoxide (CO) gas can come
into your vehicle. You can not see or smell CO.
It can cause unconsciousness and even death.
If you must drive with the liftgate open or if
electrical wiring or other cable connections must
pass through the seal between the body and the
liftgate:
Make sure all other windows are shut.
Turn the fan on your heating or cooling
system to its highest speed and select the
control setting that will force outside air into
your vehicle. SeeDual Automatic Climate
Control System on page 3-22.
If you have air outlets on or under the
instrument panel, open them all the way.
SeeEngine Exhaust on page 2-45.To lock and unlock the liftgate, use any of the power
door lock switches or the Remote Keyless Entry (RKE)
transmitter.
To open the liftgate:
1. Move the spare tire carrier out of the way.
See “Opening the Spare Tire Carrier” under
Tailgate/Spare Tire Carrier on page 2-16.
2. Pull the handle located in the center of the door.
To close the liftgate:
1. Pull the liftgate down until it latches.
2. Move the spare tire carrier back into place.
See “Closing the Spare Tire Carrier” under
Tailgate/Spare Tire Carrier on page 2-16.
2-13

Midgate®(SUT)
{CAUTION:
It can be dangerous to drive with the cargo area
covered and the tailgate and the Midgate®open
because carbon monoxide (CO) gas can come
into your vehicle. You can not see or smell CO.
It can cause unconsciousness and even death.
If you must drive with the cargo covers on and the
tailgate and Midgate
®open or if electrical wiring or
other cable connections must pass through the
seal between the body and the Midgate
®:
Make sure all windows are shut.
Turn the fan on your heating or cooling
system to its highest speed on the setting that
brings in outside air. This will force outside air
into your vehicle. SeeDual Automatic Climate
Control System on page 3-22.
If you have air outlets on or under the
instrument panel, open them all the way.
SeeEngine Exhaust on page 2-45.
The Midgate
®allows you to extend the length of the
vehicle’s cargo area into the cab.
Lowering the Midgate
The Midgate window must be completely lowered for
the Midgate®to be lowered. See “Midgate®Window”
underPower Windows on page 2-20.
Both the Midgate and the Midgate window can be
lowered while the ignition is in either ON/RUN or
ACC/ACCESSORY, or while in Retained Accessory
Power (RAP) mode. SeeRetained Accessory
Power (RAP) on page 2-29for more information.
To lower the Midgate:
1. Fold the rear seats forward. SeeSplit Folding Rear
Seat on page 1-11. The front seats may have to be
moved forward slightly.
2.
K(Midgate Window):Press the bottom part
of this switch to lower the Midgate window.
SeeInstrument Panel Overview on page 3-4
for the location of this switch.
The window can also be operated using the global
express-down button. See “Global Glass Feature”
underPower Windows on page 2-20.
2-14

3. Press either one of the two power Midgate latch
release buttons. The Midgate will move slightly
forward from its closed position. The latch release
buttons operate while the ignition is in ON/RUN,
ACC/ACCESSORY, in RAP mode, or up to
10 minutes after removing the key. If necessary,
press the global express-down button to reactivate
the release buttons for an additional 10 minutes.4. Pull the Midgate inward and down to its fully
lowered position.
5. Flip the auxiliary panel on the top of the Midgate
into position to bridge the gap created by the
hinges in the Midgate. There are two nger holds
on the panel.
Raising the Midgate
To raise the Midgate:
1. Fold the auxiliary panel back into the exterior of the
Midgate. The panel should snap loudly back into
position which means it is secure.
2. Reverse the steps for lowering the Midgate listed
previously. The Midgate must be fully latched on
both sides before the window can be raised.
3. Press the top part of the Midgate window switch to
express-up the window. To stop the window, press
the switch a second time.
2-15

Tailgate/Spare Tire Carrier
Opening the Spare Tire Carrier
To open the spare tire carrier:
1. Press the button on the pin (B), which is attached
to the cable (A), to remove the pin from the latch
nut (C).2. Lift up on the latch on the left side of the vehicle
to release the spare tire carrier from the vehicle.
The handle will stay in the raised position until the
spare tire carrier is closed and latched properly.
{CAUTION:
If you drive with the spare tire carrier unlatched,
you could injure pedestrians or damage the vehicle.
Make sure the carrier is secure before driving.
2-16

3. Swing the spare tire carrier to the side.
Opening the Tailgate
Lift the release handle while pulling the tailgate
toward you. SUT Model Spare Tire Carrier shown,
SUV Model similar
2-17

Closing the Spare Tire Carrier
To close the spare tire carrier:
1. On SUT models swing the tailgate up until it latches
rmly into place.
{CAUTION:
The spare tire carrier must be secured so that it
does not strike and injure someone. Always close
it into the latch forcefully. Make sure that the
release handle is fully closed (down) and that
the cable is attached.
2. Move the spare tire carrier back into place until
it latches, by closing it into the latch forcefully.
The spare tire carrier is latched properly when the
latch handle has lowered to the closed position.3. Reinstall the cable (A) by pushing in the button on
the pin (B) and inserting the pin into the latch bolt
nut (C).
4. Pull on the spare tire carrier to make sure it is rmly
latched.
2-18