2009 FIAT PANDA ECO mode

QUICK
GUIDE
12
CD PLAYER
INTRODUCTION
FUNCTIONS
AND ADJUSTMENTS
RADIO
FREQUENCY BAND
SELECTION
With the Radio mode active, press the
BAND button briefly and repeatedly to se-
lect the desired reception band.
Each time the button is pressed the fol-
lowing bands are selected cyclically:
“FM1”, “FM2”, “FMT” and “AM”.
Each band is highlighted by the name in the
display.
The last station selected on the respective
frequency band will be tuned into.
The FM band is divided into sections: FM1,
FM2 and FMT; the FMT reception band is
reserved for broadcasters stored automat-
ically using the Autostore function.PRESET BUTTONS
The buttons numbered from 1 to 6 are
used to set the following preselections:
❒18 in the FM band (6 in FM1, 6 in FM2,
6 in FMT);
❒6 in the AM band.
To listen to a preset station, select the de-
sired frequency band and then briefly press
the corresponding preset button (from
1 to 6).
By pressing the preset button for more
than 2 seconds, the tuned station will be
stored. The storing phase is confirmed by
an acoustic signal.
STORING THE LAST STATION
LISTENED TO
The radio automatically stores the last sta-
tion that was selected for each reception
band, which is then tuned into when the
radio is turned on or when the reception
band is changed. INTRODUCTION
When the car radio is turned on, the last
function that was selected before turning
it off (Radio or CD) is activated.
To select the Radio function whilst listen-
ing to a CD, press the SRC button briefly.
Once the Radio mode has been activated,
the display will show the name (RDS sta-
tions only) or the frequency of the se-
lected radio station, the frequency band
selected (e.g. FM1) and the preselect but-
ton number (e.g. P1).
R R
A A
D D
I I
O O
( (
T T
u u
n n
e e
r r
) )
603_97_412 Radio FunPanda EN:MY 09 9-10-2009 13:44 Pagina 12

17 17
INTRODUCTION
QUICK
GUIDE
FUNCTIONS
AND ADJUSTMENTS
RADIO
CD PLAYER
CD PLAYER SELECTION
To activate the CD player built-into the
equipment, proceed as follows:
❒load a CD with the equipment switched
on: the first track will start to play;
or
❒if a CD has already been loaded, turn
on the car radio and then briefly press
the CD button to select the “CD” func-
tion mode: the last track listened to will
start to play.
It is advisable to use original CDs to en-
sure optimum playing. If CD-R/RWs are
used, we recommend using good quality
media that are burned at the slowest
speed possible.CD LOADING/EJECTION
To load the CD, insert it gently into the
slot to activate the motorized loading sys-
tem, which will position it correctly.
Press the
˚button, with the device
turned on, to activate the power CD ejec-
tion system. After ejection, the last audio
source listened to before playing the CD
will be heard.
If the CD is not removed from the radio,
it will automatically be reloaded about 20
seconds later and the Tuner mode will be
tuned into (Radio).
The CD cannot be ejected if the radio is off.
If the ejected CD is loaded without hav-
ing removed it completely from the slot,
the radio will select the CD source. INTRODUCTION
This chapter describes the variants re-
garding the operation of the CD player: as
far as the operation of the radio is con-
cerned, refer to the description in the
“FUNCTIONS AND ADJUSTMENTS“
chapter.
C C
D D
P P
L L
A A
Y Y
E E
R R
603_97_412 Radio FunPanda EN:MY 09 9-10-2009 13:44 Pagina 17

QUICK
GUIDE
18
INTRODUCTION
FUNCTIONS
AND ADJUSTMENTS
RADIO
CD PLAYER
ERROR
MESSAGES
If the CD is not legible (for example a CD-
ROM was loaded or a CD was loaded up-
side down or there is a playback error),
the message “CD ERROR” will appear on
the display for approximately 2 seconds.
When this time has elapsed, the Radio
(Tuner) mode is activated automatically
(the CD is not automatically ejected, press
the
˚button to eject it).
DISPLAY INFORMATION
When the CD player is operating, the fol-
lowing information will appear on the dis-
play that has the following meaning:
“T1”: indicates the CD track number;
“0.42”: indicates the time elapsed since the
start of the track.TRACK SELECTION
(forward/backward)
Briefly press the
¯button to play the pre-
vious CD track and the
˙button to play
the next track. The tracks are selected
cyclically: the first track is selected after
the last track and vice versa.
If the track has been played for more than
3 seconds, pressing the
¯button will
cause the track to be started again from
the beginning. In this case, if you want to
play the previous track, press the button
twice consecutively.
FAST FORWARD/REVERSE
TRACK SELECTION
Keep the
˙button pressed down to fast
forward the selected track and keep the
¯button pressed down to fast rewind the
track. The fast forward/back will stop once
the button is released.PAUSE FUNCTION
To pause the CD player, press the
ON/OFF button briefly. “PAUSE” will be
shown on the display.
To resume listening to the track, press the
ON/OFF button/knob again.
If another audio source is selected, the
pause function is turned off.
CODE CARD
This document certifies ownership of the
car radio. The Code Card contains the
model of the radio and the serial number.
IMPORTANT Keep the Code Card some-
where safe so that the authorities can be
supplied with the relevant information if
the radio is stolen.
603_97_412 Radio FunPanda EN:MY 09 9-10-2009 13:44 Pagina 18