2008 TOYOTA LAND CRUISER lock

5
When trouble arises
441 5−1. Essential information
nEmergency towing procedure
The engine must be in ACCESSORY mode (engine off) or IGNI−
TION ON mode (engine running).
Put the four−wheel drive control switch in “H4”. (The center differen−
tial is unlocked.)
Put the shift lever in “N”.
Release the parking brake.
CAUTION
nWhile towing
lUse extreme caution when towing the vehicle.
Avoid sudden starts or erratic driving maneuvers which place excessive
stress on the emergency towing hook and the cable or chain.
lIf the engine is not running, the power assist for the brakes and steering
will not function, making steering and braking more difficult.
NOTICE
nTo prevent causing serious damage to the transmission
lNever tow this vehicle wheels on the ground.
l
Use only the front emergency towing hooks or towing eyelets (depending
on vehicles) when towing your vehicle.
STEP1
STEP 2
STEP 3
STEP 4

5
When trouble arises
443 5−1. Essential information
Towing with a wheel lifttype truck
From front
Use a towing dolly under the rear
wheels.
From rear
Use a towing dolly under the
front wheels.
NOTICE
nTo prevent causing serious damage to the transmission
Never tow this vehicle wheels on the ground.
nTo prevent damaging the vehicle
lDo not tow the vehicle with the “ENGINE START STOP” switch off.
The steering lock mechanism is not strong enough to hold the front wheel
straight.
l
When raising the vehicle, ensure adequate ground clearance for towing at
the opposite end of the raised vehicle. Without adequate clearance, the
vehicle could be damaged while being towed.

476
5−2. Steps to take in an emergency
If the engine will not star t
If the engine still does not start after following the correct starting
procedure ( P. 149) or releasing the steering lock ( P. 151), confirm
the following points.
nThe engine will not start when the starter motor operates
normally.
One of the following may be the cause of the problem.
l
There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle.
lThe engine may be flooded.
Try to restart the engine once more following correct starting
procedures. (P. 150)
l
There may be a malfunction inthe engine immobilizer system.
(P. 9 3 )
n
The starter motor turn over slowly, the interior lights and
headlights are dim, or the horn does not sound or sounds at
a low volume.
One of the following may be the cause of the problem.
l
The battery may be discharged. ( P. 484)
lThe battery terminal connections may be loose or corroded.
n
The starter motor does not turn over.
The engine starting system may
be malfunctioning due to an
electrical problem such as an open circuit or a blown fuse. How−
ever, an interim measure is available to start the engine.
( P. 477)

5
When trouble arises
477 5−2. Steps to take in an emergency
Emergency start function
When the engine does not start, the following steps can be used as
an interim measure to start the engine if the “ENGINE START STOP”
switch is functioning normally.
Set the parking brake.
Put the shift lever in “P”.
Set the “ENGINE START ST
OP” switch to ACCESSORY
mode.
Press and hold the “ENGINE START STOP” switch about 15
seconds while depressing the brake pedal firmly.
Even if the engine can be start
ed using the above st eps, the system
may be malfunctioning. Have the vehicle checked by your Toyota
dealer. nThe starter motor does not turn over, the interior lights and
headlights do not turn on, or the horn does not sound.
One of the following may be the cause of the problem.
l
One or both of the battery terminals may be disconnected.
l
The battery may be discharged. ( P. 484)
lThere may be a malfunction in the steering lock system.
Contact your Toyota dealer if the problem cannot be repaired, or if
repair procedures are unknown.
STEP1
STEP 2
STEP 3
STEP 4

478
5−2. Steps to take in an emergency
If the shift lever cannot be shifted from P
If the shift lever cannot be shifted with your foot on the brake, there
may be a problem with the shif
t lock system (a system to prevent
accidental operation of the shift lever). Have the vehicle inspected by
your Toyota dealer immediately.
The following steps may be used as an emergency measure to
ensure that the shift
lever can be shifted.
Set the parking brake.
Set the “ENGINE START STOP” switch to the ACCES−
SORY mode.
Depress the brake pedal.
Pry the cover up with a flat−
head screwdriver or equiva−
lent.
Press the shift lock override
button.
The shift lever can be shifted
while the button is pressed.
STEP1
STEP 2
STEP 3
STEP 4
P
R
N
+
SD
ITY51C041
P
R
N
+
SD
ITY51C042
STEP5

5
When trouble arises
481
5−2. Steps to take in an emergency
If the electronic key does not operate properly
Locking and unlocking the doors and key linked functions
Locks all doors
Closes the windows/moon
roof (turn and hold)
Unlocks all doors
Turning the key rearward
unlocks the driver ’s door.
Turning the key once again
unlocks the other doors.
Opens the windows/moon roof
(turn and hold)
If communication between the electronic key and vehicle is inter
rupted (
P. 26) or the electronic key cannot be used because the
battery is depleted, the smart key system and wireless remote con
trol cannot be used. In such cases,
the doors can be opened or the
engine can be started by following the procedure below.

5
When trouble arises
483 5−2. Steps to take in an emergency
nStopping the engine
Shift the shift lever to “P” and press the “ENGINE START STOP” switch as
you normally do when stopping the engine.
nReplacing the key battery
As this procedure is a temporary measure, it is recommended that the elec−
tronic battery be replaced immediately when the battery depletes. ( P. 410)
nAlarm
Using the mechanical key to lock the doors will not set the alarm system.
If a door is unlocked using the mechanical key when the alarm system is set,
the alarm may be triggered. (
P. 97)

495
6−1. Specifications
6
Vehicle specifications
Vehicle identification
nVehicle identification number
The vehicle identificati on number (VIN) is the legal identifier for your
vehicle. This is the primary identification number for your Toyota. It is
used in registering the ownership of your vehicle.
This number is stamped on the
top left of the instrument panel.
This number is also on the Certi−
fication Label.
nEngine number
The engine number is stamped
on the engine block as shown.
ITY61C001
ITY61C002