2008 MITSUBISHI SHOGUN jump start

6-2 For emergencies
6
If the vehicle breaks down
E00800100505
If the vehicle breaks down on th
e road, move it to the shoulder
and use the hazard warning flashers and/or the warning triangle etc.Refer to “Hazard warning fl
asher switch” on page 3-66.
If the engine stops/failsVehicle operation and control are
affected if the engine stops.
Before moving the vehicle to a
safe area, be aware of the fol-
lowing:●
The brake booster becomes inoperative and the pedal effort will increase. Press down the brake pedal harder than usual.
●
Since the power steering pump is no longer operative, the steering wheel feels
heavy when turning it. Turn the wheel
with more effort than usual.
Emergency starting
E00800501287
If the engine cannot be started
because the battery is weak or
dead, the battery from another ve
hicle can be used with jumper
cables to start the engine.
WARNING
!●
To start the engine using
jumper cables connected to
another vehicles, perfor
m the correct procedures
according to the instructio
n below. Incorrect proce-
dures could result in a fire or explosion or damage to the vehicles.CAUTION
!●
Do not attempt to start the engine by pulling or pushing the vehicle. It could damage your vehicle.
●
Always wear protective eye goggles when working near the battery.
●
Keep the battery out of the reach of children.
BK-BK2008E1ENUK.en-uk-Section9.fm Page 2 Wednesday, January 9, 2008 4:46 PM

For emergencies
6-3
6
1. Get the vehicles close en
ough so the jumper cables can
reach, but be sure the vehicles
aren’t touching each other.
2. Set the parking brake firmly
on each vehicle. Put an auto-
matic transmission in “P” (PARK) or a manual transmis- sion in “N” (Neutral). Turn
off the ignition switch.
3. Turn off all lamps, heater
and other electrical loads.
4. Make sure battery electrolyte is at the proper level.
Refer to “Battery” on page 8-16.
CAUTION
!●
Check the other vehicle. It
must have a 12-volt bat-
tery. If the other system isn’t 12-volt, shorting can dam- age both vehicles. WARNING
!●
Turn off the ignition on
both vehicles beforehand.
Make sure that the cables or your clothes cannot be caught by the fan or dr
ive belt. Personal injury
could result.
WARNING
!●
If electrolyte fluid is not vi
sible, or appears to be fro-
zen, Do Not Attempt Jump Starting! A battery might rupture or
explode if the tempera-
ture is below the freezing poin
t or if it is not filled to
the proper level.
BK-BK2008E1ENUK.en-uk-Section9.fm Page 3 Wednesday, January 9, 2008 4:46 PM

For emergencies
6-5
6
7. Start the engine in the vehicle which has the booster bat-
tery, let the engine idle a few minutes, then start the engine in the vehicle with the discharged battery.
8. After the engine is started,
disconnect the cables in the
reverse order and keep the engine running for several min- utes.
WARNING
!●
Be sure to observe the connecting sequence of
→
→
→ .
●
Make sure that the conn
ection is made to the
appointed position (shown in the illustration). If theconnection is made directly to the negative side of the battery, the inflammable gasses generated from the battery might catch fire and explode.
●
When connecting the jump
er cable, do not connect
the positive (+) cable to the negative (
–) terminal.
Otherwise sparks might ca
use explosion of the bat-
tery.CAUTION
!●
Use care not to get the ju
mper cable caught in the
cooling fan or other rotating
part in the engine com-
partment.
●
Use the proper cables suitab
le for the battery size to
prevent overheating of the cables.
●
Check the jumper cables fo
r damage and corrosion
before use.
CAUTION
!●
Keep the engine of the ve
hicle giving assistance run-
ning.WARNING
!●
If the battery has to be ch
arged while fitted in the
vehicle, disconnect the
vehicle side negative (
–) ter-
minal connected to the battery.
●
Keep sparks, cigarettes an
d flames away from the
battery because the battery
may produce an explo-
sion.
●
Use adequate ventilation when charging or using the battery in an enclosed space.
●
Remove all the caps before charging the battery.
●
Electrolyte is corrosive diluted sulphuric acid. If electrolyte (battery ac
id) comes into contact with
your hands, eyes, clothes and the painted surface ofyour vehicle, it should be thoroughly flushed with water. If electrolyte gets in your eyes, flush them with water immediately
and thoroughly, and get
prompt medical attention.
BK-BK2008E1ENUK.en-uk-Section9.fm Page 5 Wednesday, January 9, 2008 4:46 PM

Alphabetical index 4Heated mirror 4-14 Heated seats 2-12High-beam indicator lamp 3-12High-mounted stop lampBulb capacity 8-36Replacement 8-48Hinges and latches lubrication 8-28Horn switch 3-78
I
If the vehicle breaks down 6-2Ignition switch 4-14Indicator and warning lamps 3-10Indicator lamps 3-12Inside rear-view mirror 4-9Inspection and maintenance following rough road operation 4-53Installation of accessories 6Installation position for warning triangle 5-107Instruments 3-2Interior lamp switch 5-85Interior lamps 5-85
J
JackStorage 6-11Jack handle 6-15Storage 6-11Jump starting (Eme
rgency starting) 6-2
K
Keyless entry system 1-5 Keys 1-2
L
Labeling 9-2Lamp monitor buzzer 3-60Lamps (headlamps, fog lamp, etc.) auto-cutout function 3-60Leakage (Fuel, engine coolant, oil and exhaust gas) 8-27Licence plate lampsBulb capacity 8-36Replacement 8-49Low fuel warning lamp 3-8Lubricants 9-16Luggage compartment lamp 5-88Bulb capacity 8-38Replacement 8-52Luggage floor box 5-97Luggage hooks 5-105LW/MW/FM electronic tuning radio with CD autochanger5-43LW/MW/FM electronic tuning radio with CD player 5-20
M
Making a flat seat 2-35Making a luggage area 2-19Manual transmission 4-23Fluid 9-16
BK-BK2008E1ENUK.en-ukIX.fm Page 4 Thursday, January 10, 2008 7:53 AM