2008 MITSUBISHI SHOGUN isofix

Seat and seat belts
2-47
2
●
Before purchasing a child restraint system, try installing it in the rear seat to make sure there is a good fit. Because of the location of the seat belt
buckles and the shape of the
seat cushion, it may be difficult to securely install somemanufacturer’s child restraint systems. If the child restraint system
can be pulled forward or to
either side easily on the seat cushion after the seat belt hasbeen tightened, choose anot
her manufacturer’s child
restraint system.
NOTE●
Depending on the seating position in the vehicle and the child restraint system that you have, the child restraint can be attached using one of the following two locations: • To the lower anchorage in th
e rear seat (3-door models)/
second seat (5-door models) ONLY if the child restraint has ISOFIX mountings (See page 2-54). • To the seat belt (See page 2-57).
Older children
E00406700147
Children who have outgrown the child restraint system should be seated in the rear seat an
d wear combination lap shoulder
belt.The lap portion of the belt should be snug and positioned low on the abdomen so that it is below the top of the hip-bone. Oth- erwise, the belt could intrude into the child’s abdomen duringan accident and cause injury.
WARNING
!●
When installing a child rest
raint system, refer to the
instructions provided by
the manufacturer of the
restraint system. Failure to do so can result in severeor fatal injury to your child.
●
After installation, push and pull the child restraint system back and fort
h, and side to side, to see that it
is positively secured. If
the child restraint system is
not installed securely, it may cause injury to the child or other occupants in
the case of accident or
sudden stops.
●
When the child restraint system is not in use, keep your child restraint system
secured with the seat belt
or remove it from the vehicle in order to prevent it from being thrown around inside the vehicle during an accident.
BK-BK2008E1ENUK.en-uk-Section5.fm Page
47 Wednesday, January 9, 2008 4:28 PM

2-48 Seat and seat belts
2
Suitability for various ISOFIX positions
E00411400038
Mass Group
Size class
Fixture
Vehicle ISOFIX positions
Front Passenger
Rear / second Outboard
Rear Centre
Left side
Right side
Carrycot F ISO/L1 X X IL X
GISO/L2X IL X X
XXXX
0 - Up to 10 kg E ISO/R1 X IL IL X
XXXX
0+ - Up to 13 kg
EISO/R1X IL
IL, IL*
2
X
D ISO/R2 X IL IL X C ISO/R3 X IL IL X
XXXX
I - 9 to 18 kg D ISO/R2 X IL IL X
C ISO/R3 X IL IL XBISO/F2X IUF IUF X B1 ISO/F2X X
IUF, IL*
1
IUF, IL*
1
X
AISO/F3X IUF IUF X
XXXX
II- 15 to 25 kg XXXXIII- 22 to 36 kg XXXXBK-BK2008E1ENUK.en-uk-Section5.fm Page
48 Wednesday, January 9, 2008 4:28 PM

Seat and seat belts
2-49
2
Key of letters to be inserted in the table above:●
IUF- Suitable for ISOFIX forward child
restraints systems of universal categor
y approved for use in the mass group.
●
IL- Suitable for particular ISOFIX child restra
int systems (CRS) given
in the attached list.
These ISOFIX CRS are those of the “specific vehi
cle”, “restricted” or “s
emiuniversal” categories.
●
X- ISOFIX position not suitable for ISOFIX child restra
int systems in this mass group and/or this size class.
IL (Genuine part information)

NOTE●
MITSUBISHI MOTORS Europe B.V. reserves the right to changes without any prior announcement. For detailed information, consult your MITSUBISHI MOTORS Authorized Service Point.
Genuine part No.
ECE No.
*1
MZ313045 E1-04301133
*2
MZ313589 E1-04301146
BK-BK2008E1ENUK.en-uk-Section5.fm Page
49 Wednesday, January 9, 2008 4:28 PM

2-54 Seat and seat belts
2
Installing a child restra
int system to the lower
anchorage (ISOFIX child restraint mountings) and tether anchorage*
E00408900169
Lower anchorage locationYour vehicle’s rear seat (3-doo
r models) / second seat (5-door
models) is fitted with lower an
chorages for attaching a child
restraint system with ISOFIX mountings.
Tether anchorage locationsThere are 2 attachment points on
the floor, located behind the
rear seat (3-door models) / seco
nd seat (5-door models). These
are for securing a child restrain
t system tether strap to both of
the 2 rear (3-door models) / second (5-door models) seatingpositions in your vehicle.
WARNING
!●
Child restraint anchorages
are designed to with-
stand only those loads im
posed by correctly fitted
child restraints. Under no
circumstances are they to
be used for adult seat belts, or harnesses, or for attaching other items or
equipment to the vehicle.
BK-BK2008E1ENUK.en-uk-Section5.fm Page
54 Wednesday, January 9, 2008 4:28 PM

Seat and seat belts
2-55
2
Child restraint system with ISOFIX mountingsThe child restraint system is de
signed only for seats that incor-
porate lower anchorages. Retain the child restraint system using the lower anchorages. It is not necessary to retain the child restraint system using thevehicle’s seat belts.
To install 1. Remove any foreign material in or around the connectors
and ensure the vehicle seat belt is in its normal storage position.
2. Push the child restraint syst
em’s connectors (A) into the
slit (B) in accordance with the instructions provided by the child restraint system’s manufacturer.
A: Child restraint system connectors
A: Connector B: Slit C: Vehicle seatbackD: Vehicle seat cushion E: Lower anchorage
BK-BK2008E1ENUK.en-uk-Section5.fm Page
55 Wednesday, January 9, 2008 4:28 PM