2008 MITSUBISHI GRANDIS lock

2-52 Seat and seat belts
2Seat belt inspection
E00406300550
●Check the belts for cuts, worn or frayed webbing and for
cracked or deformed metallic parts. Replace the belt
assembly if detectable.
●A dirty belt should be cleaned with neutral detergent in
warm water. After rinsing in water, let it dry in the shade.
Do not attempt to bleach or re-dye the belts because this
affects their characteristics.
WARNING
!●For some types of child restraint, the locking clip (A)
should be used to help avoid personal injury during
a collision or sudden manoeuvre.
It must be fitted and used in accordance with the
child restraint manufacturer’s instructions.
The locking clip must be removed when the child
restraint is removed.
WARNING
!●We recommend you to have all seat belt assemblies
including retractors and attaching hardware
inspected after any collision. We recommend that
seat belt assemblies in use during a collision be
replaced unless the collision was minor and the belts
show no damage and continue to operate properly.●Do not attempt to repair or replace any part of the
seat belt assemblies; we recommend you to have this
work done by a MITSUBISHI MOTORS Author-
ized Service Point. Incorrect repair or replacement
could reduce the effectiveness of the belts and could
result in serious injury in the event of a collision.●Once the pre-tensioner has activated, it cannot be
re-used.
It must be replaced together with the retractor.
BK-XP08E1ENUK.en-uk.book Page 52 Monday, August 13, 2007 2:20 PM

2-60 Seat and seat belts
2
To turn an air bag off
E00410600118
To turn an air bag off, follow these steps:
1. Insert the key into the key opening of the appropriate air
bag ON-OFF switch, and turn that air bag ON-OFF switch
to the “OFF” position.
2. Remove the key from the key opening of that air bag
ON-OFF switch.
3. Insert the key into the ignition switch, and turn the igni-
tion to “ON” position.
That air bag off indication lamp, with the word “OFF”
(depending upon which air bag has been turned off) should
illuminate. That will tell you that air bag is OFF, and will NOT
deploy. (Refer to “Front passenger’s air bag off indication
lamp” on page 2-62.)
WARNING
!●To reduce risk of serious or fatal injury:
• Always remove the key from the ignition switch
before operating an air bag ON-OFF switch. Fail-
ure to do so could adversely affect the air bag per-
formance.
• Wait at least 60 seconds to operate the air bag
ON-OFF switch after turning the ignition switch
from “ON” position to “LOCK” position.
The air bag SRS system is designed to retain
enough voltage to deploy the air bag.
• Always remove the key from an air bag ON-OFF
switch after operating that switch. Failure to do so
could lead to improper position of the air bag
ON-OFF switch.
BK-XP08E1ENUK.en-uk.book Page 60 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-5
3
NOTE●Display TRIP and each have a maximum distance
of 999.9 km (999.9 miles).
●Even when the ignition switch has been turned to the
“LOCK” position, pressing the tripmeter reset button
causes the odometer/tripmeter indication to appear for
approximately 30 seconds.
●When disconnecting the battery terminal for a long time,
the memory of tripmeter display TRIP and are
cleared, and the display returns to “0”.
Fuel gauge
E00500700481
The fuel gauge indicates the fuel level in the fuel tank when the
ignition switch is “ON”.Fuel lid markThe fuel lid mark (A) indicates that the fuel tank filler door is
located on the left side of the vehicle (Refer to “Filling the fuel
tank” on page 3).1- Full
0- Empty
CAUTION
!●For petrol-powered vehicles, do not drive with an
extremely low fuel level; running out of fuel could
cause damage to the catalytic converter.
BK-XP08E1ENUK.en-uk.book Page 5 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-7
3
Daytime dipper button
E00508800026
By pressing the daytime dipper button, you can change the
brightness of the backlighting in meters and instrument panel.NOTE●The brightness can be adjusted among 4 levels in accord-
ance with the on/off condition of the tail lamps.NOTE●The meter brightness is memorized and maintained even
if the ignition switch is turned to the “LOCK” position.
BK-XP08E1ENUK.en-uk.book Page 7 Monday, August 13, 2007 2:20 PM

3-8 Instruments and controls
3Indicator and warning lamps
E00501501337
1- CRUISE indication lamp* → p. 4-46
2- ASC indication lamp* → p. 4-43
3- Turn-signal indication lamps/Hazard warning indication
lamps → p. 3-9
4- Rear fog lamp indication lamp → p. 3-9
5- Front fog lamp indication lamp → p. 3-9
6- High-beam indication lamp → p. 3-9
7- Diesel particulate filter (DPF) warning lamp (diesel-
powered vehicles)* → p. 4-21
8- Position lamp indication lamp → p. 3-9
9- Automatic headlamp levelling warning lamp* → p. 3-35
10- Diesel preheat indication lamp (diesel-powered vehicles)
→ p. 3-9
11- Charge warning lamp → p. 3-13
12- Oil pressure warning lamp → p. 3-1413- Check engine warning lamp → p. 3-11
14- TCL OFF indication lamp* → p. 4-43
15- SONAR OFF indication lamp* → p. 4-57
16- Anti-lock brake system (ABS) warning lamp → p. 4-38
17- Brake warning lamp → p. 3-10
18- Seat belt reminder/warning lamp → p. 2-35
19- Sports mode indication lamp (vehicles with A/T) → p. 4-32
20- Selector lever position indication lamps
(vehicles with A/T, “N” indication lamp is used also as A/T
warning lamp) → p. 4-28
21- Supplemental restraint system (SRS) warning lamp
→ p. 2-76
22- Door-ajar warning lamp → p. 3-14
23- Low fuel warning lamp → p. 3-6
BK-XP08E1ENUK.en-uk.book Page 8 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-9
3 Indicator lamps
E00501600012
Turn-signal indication lamps/Hazard
warning indication lamps
E00501700169
These indication lamps blink on and off when a
turn-signal lamp is operating.NOTE●If the blinking is too fast, the cause may be
a faulty turn-signal connection or a blown
lamp bulb.
When the hazard warning lamp switch is
pressed, all turn-signal lamps will flash on and
off continuously.High-beam indication lamp
E00501800160
This indication lamp illuminates when the high
beam is used.Front fog lamp indication lamp
E00501900321
This lamp illuminates while the front fog lamps
are on.
Rear fog lamp indication lamp
E00502000101
This lamp illuminates while the rear fog lamp is
on.Position lamp indication lamp
E00508900102
This lamp illuminates with the lamp switch at
“ ” or “ ” positionDiesel preheat indication lamp
(diesel-powered vehicles)
E00502300061
This indication lamp illuminates when the igni-
tion switch is placed in the “ON” position. As
the glow plug becomes hot, the lamp goes out
and the engine can be started. If it does not go off
after a few seconds, we recommend you to have
the vehicle checked.NOTE●If the engine is cold, the diesel preheat indi-
cation lamp is on for a longer time.
●When the engine has not been started within
about 5 seconds after the diesel preheat
indication lamp went out, return the ignition
switch to the “LOCK” position. Then, turn
the switch to the “ON” position to preheat
the engine again.
BK-XP08E1ENUK.en-uk.book Page 9 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-15
3 Multi centre display
E00503600120
When the ignition switch is in the “ACC” position, the digital
clock is displayed in the multi centre display. When the igni-
tion switch is in the “ON” position, the momentary fuel con-
sumption and outside temperature are displayed besides the
digital clock.
WARNING
!●When operating the system for a prolonged period,
make sure the vehicle is parked in a well ventilated
area to avoid the accumulation of toxic fumes inside
and outside of the passenger compartment.
CAUTION
!●The driver should not operate the display while the
vehicle is in motion.●When operating the system, stop the vehicle in a safe
area.
BK-XP08E1ENUK.en-uk.book Page 15 Monday, August 13, 2007 2:20 PM

3-16 Instruments and controls
3
NOTE●The display unit (ex. km or mile) and brightness can be changed as desired. (Refer to “ Display brightness adjustment” on page
3-27 and “Display unit selection” on page 3-29.) When the system cannot provide a definite value for momentary fuel con-
sumption/average fuel consumption/driving range/average speed, it is displayed as “---”.
●The figure of the display varies according to the conditions under which a vehicle is travelling (road conditions, the manner in
which the vehicle is being driven, etc.).
Observe display for reference because the figure of the display may differ from the actual figure.A- Outside temperature → p. 3-20
B- Driving information → p. 3-21
C- Digital clock → p. 3-17
BK-XP08E1ENUK.en-uk.book Page 16 Monday, August 13, 2007 2:20 PM