2008 MERCEDES-BENZ C300 ignition

225 Controls in detail
Audio system
Functional restrictions
You will not be able to use the telephone,
or you may have to wait a while, in the fol-
lowing situations:

If the telephone is switched off.

If the telephone is not connected via
the Bluetooth® interface to the audio
system.

The telephone must not be locked.

If the telephone has not yet logged into
the network.
The telephone automatically tries to
log into a network. If no network is
available, you will also not be able to
make a “911” emergency call.
If you attempt to make an outgoing call,
the
No Service message will appear for
a short while.

If you switch off the audio system in the
middle of a call, e. g. by switching off
the ignition, that call will be cut off. You
can prevent this from happening as fol-
lows:

Switch the phone to “private mode”
before switching the audio system
off (see telephone operating in-
structions).Activating the telephone
Prerequisites for the telephone
For making calls using the audio system
via the Bluetooth
® interface, you will need
a Bluetooth® enabled telephone.
Before attempting to make or receive calls
via the Bluetooth
® interface, check your
phone's hands-free profile. It must support
version 1.0 or higher (see telephone oper-
ating instructions).
iNot all telephones on the market are suit-
able. Further information on suitable telephones
and on connecting Bluetooth
® enabled tele-
phones to the audio system are available from an
authorized Mercedes-Benz Center.

252 Controls in detail
Dual-zone automatic climate control
Deactivating the climate control
system
Deactivating: Press button´
(
page 250).
The indicator lamp in the button comes
on.
Reactivating: Make sure the ignition is
switched on.
Press button´ (page 250) again.
The indicator lamp in the button goes
out.The previous settings are once
again in effect.
or,
Press buttonU (page 250) while
the engine is running.
The indicator lamp in the button comes
on. The air volume and air distribution
are adjusted automatically.
iKeep the air intake grille in front of the wind-
shield free of snow and debris.
Do not obstruct air flow by placing objects on the
air flow-through exhaust slots below the rear
window.
iIf the vehicle interior is hot, ventilate the in-
terior before driving off, see “Summer opening
feature” (
page 123). The climate control will
then adjust the interior temperature to the set
value much faster.
Warning!G
When the climate control is switched off, the
outside air supply and circulation are also
switched off. Only choose this setting for a
short time. Otherwise the windows could
fog up, impairing visibility and endangering
you and others.

256 Controls in detail
Dual-zone automatic climate control
Maximum cooling MAX COOL
(USA only)
You can use this setting to provide the fast-
est possible cooling of the vehicle interior
(when windows and tilt/sliding sunroof or
tilt/sliding panel* are closed).
Activating: Press button3
(
page 250).
The indicator lamp in the button comes
on.
The air conditioning switches
automatically to the following functions:

maximum cooling

maximum blowing power

the air recirculation mode is switched
on
Deactivating: Press button3
(
page 250) again.
The indicator lamp in the button goes
out. The previous settings are once
again in effect.
Rear window defroster
Activating: Switch on the ignition.
Press button¯ (page 250).
The indicator lamp in the button comes
on.
iTo switch the maximum cooling function off,
you can also press button ´, U ory
(
page 250).
Warning!G
Any accumulation of snow and ice should be
removed from the rear window before driv-
ing. Visibility could otherwise be impaired,
endangering you and others.
!The rear window defroster uses a large
amount of power. To keep battery drain to a min-
imum, switch off the defroster as soon as the
rear window is clear.

261 Controls in detail
3-zone automatic climate control* (Canada only)
Deactivating climate control system
Deactivating: Press button´
(
page 259).
The indicator lamp in the button comes
on.
Reactivating: Make sure the ignition is
switched on.
Press button´ (page 259) again.
The indicator lamp in the button goes
out.The previous settings are once
again in effect.
or,
Press buttonU (page 259) while
the engine is running.
The indicator lamp in the button comes
on. The air volume and air distribution
are adjusted automatically.Operating climate control system in
automatic mode
Activating: Press buttonU
(
page 259) while the engine is run-
ning.
The indicator lamp in the button comes
on. The air volume and air distribution
are adjusted automatically.
Use temperature controls1 and8
(
page 259) to separately adjust the
air temperature on each side of the
passenger compartment.
The temperature of the vehicle interior
is adjusted automatically.
Warning!G
When the climate control is switched off, the
outside air supply and circulation are also
switched off. Only choose this setting for a
short time. Otherwise the windows could
fog up, impairing visibility and endangering
you and others.
iWhen operating the climate control system
in automatic mode, you will only rarely need to
adjust the temperature, air volume and air distri-
bution.
In automatic mode, cooling with dehumidify is
switched on. This function can be switched off if
necessary.

265 Controls in detail
3-zone automatic climate control* (Canada only)
Rear window defroster
Activating: Switch on the ignition.
Press button¯ (page 259).
The indicator lamp in the button comes
on.
Deactivating: Press button¯
(
page 259).
The indicator lamp in the button goes
out.
Air recirculation mode
Switch to air recirculation mode to prevent
unpleasant odors from entering the vehicle
from the outside (e.g. before driving
through a tunnel). This setting cuts off the
intake of outside air and recirculates the
air in the passenger compartment.
!The rear window defroster uses a large
amount of power. To keep battery drain to a min-
imum, switch off the defroster as soon as the
rear window is clear.
iThe rear window defroster is automatically
deactivated after some time of operation de-
pending on the outside temperature.
Warning!G
Any accumulation of snow and ice should be
removed from the rear window before driv-
ing. Visibility could otherwise be impaired,
endangering you and others.
iIf the rear window defroster switches off too
soon and the indicator lamp goes out, this indi-
cates that too many electrical consumers are op-
erating simultaneously and the load on the
battery is reducing available voltage. The system
responds automatically by deactivating the rear
window defroster.
Warning!G
Fogged windows impair visibility, endanger-
ing you and others. If the windows begin to
fog on the inside, switching off the air
recirculation mode immediately should clear
interior window fogging. If interior window
fogging persists, make sure the air
conditioning (
page 267) is activated, or
press buttony.

266 Controls in detail
3-zone automatic climate control* (Canada only)
Activating: Press button,
(
page 259).
The indicator lamp in the button comes
on.
Deactivating: Press button,
(
page 259) again.
The indicator lamp in the button goes
out.
Residual engine heat and ventilation
With the engine switched off, it is possible
to continue to heat or ventilate the interior
for approximately 30 minutes. This feature
makes use of the residual heat produced
by the engine.
Activating: Switch off the ignition.
Press buttonT (page 259).
The indicator lamp in the button comes
on.
Deactivating: Press buttonT
(
page 259) again.
The indicator lamp in the button goes
out.
iThe air recirculation mode is activated auto-
matically at high outside temperatures.
The indicator lamp on button, is not lit when
the air recirculation mode is automatically
switched on.
A quantity of outside air is added after approxi-
mately 30 minutes.
iThe air recirculation mode is deactivated au-
tomatically:

after 5 minutes if the outside temperature is
below approximately 7°C (45°F)

after 5 minutes if the air conditioning is
turned off

after 30 minutes if the outside temperature
is above approximately 5°C (41°F)
iIf you switch on the residual heat function
when outside temperatures are high, only the
ventilation will be switched on.
iRegardless of the selected air volume, the
blower operates at low speed when heating. In
case of ventilation the blower operates at higher
speed.
iHow long the system will provide heating de-
pends on

the coolant temperature

the temperature set by the operator
iThe residual heat is automatically turned off:

when the ignition is switched on

after approximately 30 minutes

if the battery voltage drops

if the coolant temperature is too low

274 Controls in detail
Power tilt/sliding sunroof
1Push up to raise sunroof at rear
2Push back to slide sunroof open
3Pull down to close the sunroof
With the sunroof closed or tilted open, a
screen can be slid into the roof opening to
help provide shade. When sliding the sun-
roof open, the screen will also retract.Screen
Switch on the ignition.
To open, close, raise or lower, move the
switch to resistance point in the re-
quired direction1to3 until the
tilt/sliding sunroof has reached the de-
sired position.
iWhen the tilt/sliding sunroof is open, reso-
nance noises may result in addition to the usual
wind noises. They are caused by minimal pres-
sure changes in the passenger compartment. To
reduce or eliminate these noises, change the po-
sition of the tilt/sliding sunroof or open a side
window slightly.
iYou can also open or close the tilt/sliding
sunroof using the SmartKey, see “Summer open-
ing feature” (
page 123) and “Convenience
closing feature” (
page 124).
iWith the SmartKey in starter switch
position0 or removed from the starter switch,
the tilt/sliding sunroof can be operated

until you open the driver’s or passenger door

for up to approximately 5 minutes

275 Controls in detail
Power tilt/sliding sunroof
Express-operation: To open, close,
raise or lower, move the switch past
the resistance point in the required
direction1to3 and release.
The tilt/sliding sunroof opens or closes
completely.
Stopping during Express-opening/
closing: Move the switch in any direc-
tion.
Synchronizing
The tilt/sliding sunroof must be synchro-
nized

after the tilt/sliding sunroof has been
closed manually

if the tilt/sliding sunroof can only be
opened with a jerking motion

after a malfunction
Switch on the ignition (page 82).
Press and hold the sunroof switch in
the direction of arrow1 until the
tilt/sliding sunroof is fully raised at the
rear.
Keep holding the sunroof switch in the
direction of arrow1 for approximately
1 second.
Check the Express-operation feature
(
page 275).
If the tilt/sliding sunroof opens com-
pletely, the sunroof is synchronized.
Otherwise repeat the above steps.
iIf the movement of the tilt/sliding sunroof is
blocked during the closing procedure, the sun-
roof will stop and reopen slightly.
!Do not open the tilt/sliding sunroof com-
pletely if it is not aligned. Otherwise you could
damage the tilt/sliding sunroof.