308Section 6 Basic System1. Blower Removal / Installation
1. Disconnect the negative (--) terminal cable from the battery.
2. Remove instrument panel.
3. Remove motor connector.
4. Remove the resistor connector.
5. Remove the band.
6. Remove bolt. Remove blower.
7. The installation is in the reverse order of the removal.
2. Heater Removal / Installation
1. Remove water hose No. 1 and 2.
2. Remove instrument panel.
3. Remove the band.
4. Remove 2 wind door cables.
5. Remove heater.
6. The installation is in the reverse order of
the removal.
3. The Evaporator Removal / Installation
1. Remove evaporator inlet and outlet pipeline.
2. Remove instrument panel.
3. Remove thermistor connector.
4. Remove 2 bands.
3095. Remove evaporator.
6. The installation is in the reverse order of the removal.The Evaporator Installation Guide1. Pack certain SW-100 compressor oil into the refrigerant circuit when installing a new evaporator.
Refill: (approximate)
15ml {15 cc, }Check Evaporator1. Remove evaporator.
2. Remove the evaporator core from the evaporator.
3. Check for crack, damage or oil leakage.
•Replace the evaporator core if any of the above-mentioned fault occurs.
4. Check the fin for bending.
•Flat it with a flat head screwdriver if it is bent.Check Heater1. Remove the heater.
2. Remove heating core from the heater.
3. Check for crack, damage or refrigerant leakage.
•Replace the heating core if any of the above-mentioned faults occurs.
4. Check the fin for bending
•Flat it with a flat head screwdriver if it is bent.
5. Check heater inlet hose and outlet hose for bend or damange.
•Repair the hose if necessary.
