2008.5 Peugeot 1007 Dag Owner's Manual

9
123
CHANGING A FUSE
The fuse boxes are located under the
fascia on the left-hand side and in the
engine compartment next to the bat-
tery.
Correct
Removing and fitting a fuse
Before changing a fuse you must fi nd
out the cause of the fault and have it
put right. The fuse numbers are indi-
cated on the fuse box.

Incorrect * The maxi fuses provide ad-
ditional protection for the
electrical systems. All work
must be carried out by a
PEUGEOT dealer.

Always replace a faulty
fuse with one of the same
rating. Fascia fuse box

 Turn the screw a quarter of a turn,
then tilt the cover to open it.

 Turn the lever a quarter of a turn,
then push and tilt the box to gain
access to the fuses.
RatingFunctions
FH1*-Not used.
FH2*40 ATrailer Fuse Box.
FH3*20 AHeated seats.
FH4*20 AAudio amplifi er.
FH5*5 A"Sesame" doors control unit.

9
123
CHANGING A FUSE
The fuse boxes are located under the
fascia on the left-hand side and in the
engine compartment next to the bat-
tery.
Correct
Removing and fitting a fuse
Before changing a fuse you must fi nd
out the cause of the fault and have it
put right. The fuse numbers are indi-
cated on the fuse box.

Incorrect * The maxi fuses provide ad-
ditional protection for the
electrical systems. All work
must be carried out by a
PEUGEOT dealer.

Always replace a faulty
fuse with one of the same
rating. Fascia fuse box

 Turn the screw a quarter of a turn,
then tilt the cover to open it.

 Turn the lever a quarter of a turn,
then push and tilt the box to gain
access to the fuses.
RatingFunctions
FH1*-Not used.
FH2*40 ATrailer Fuse Box.
FH3*20 AHeated seats.
FH4*20 AAudio amplifi er.
FH5*5 A"Sesame" doors control unit.

9
124
Fuse N°RatingFunctions
115 ARear wiper.
35 AAir bags and pre-tensioners control unit.
410 ADiagnostic socket - Clutch switch - Steering wheel angle sensor - Particle emission fi lter pump.
530 AElectric windows - Sunroof.
6-Not used.
75 ACourtesy light - Glove box lighting.
820 ATyre under-infl ation detection control unit - Electric mirror folding - Alarm siren - Multifunction display - Alarm control unit - Audio equipment - Aud io/telephone.
930 AAudio equipment - Lighter/12 V socket (100 W max).
1015 ASteering wheel controls.
1115 ADiagnostic socket - Low current ignition switch - Motorised strikers.
1215 AAir bags and pre-tensioners control unit - Rain/brightness sensor.
135 AABS relay - Speed sensor - Engine Fuse Box - "2 Tronic" gear lever - Brake swit ch.
1415 AParking assistance control unit - "Sesame" doors control unit and switches - Instrument panel - Seat belt warning lights bar - Air conditioning control panel - Headlamp adjustment - Hands-free kit.
1530 ALocking - Deadlocking - Unlocking.
1740 ARear screen and exterior mirrors demisting.
SH-PARC shunt.

9
125
Engine compartment fuse box

 Unclip the cover to gain access to
the fuses.
 Once the work has been carried
out, close the cover very carefully.
Fuse N°RatingFunctions
MF1**50 AFan assembly.
MF2**30 AABS/ESP control unit.
MF3**30 AABS/ESP control unit.
MF4**60 ABuilt-in Systems Interface supply.
MF5**60 ABuilt-in Systems Interface supply.
MF6**30 A"2 Tronic" gearbox control unit.
MF7**80 APassenger compartment fuse box - "Sesame" doors control unit.
MF8**80 AElectric power steering.
Your vehicle's electrical sys-tem is designed to operate with standard or optional equipment.
** The maxi fuses provide addi-tional protection for the electrical systems. All work must be car-ried out by a PEUGEOT dealer.
Before installing other electrical equipment or accessories on your vehicle, contact a PEUGEOT dealer.
Some electrical accessories or the way in which they are fi tted may have damaging effects on the operation of your vehicle (audio, control and elec-trical load circuits).
PEUGEOT will not accept responsi-bility for the cost incurred in repairing your vehicle or for rectifying malfunc-tions resulting from the installation of auxiliary accessories not supplied and not recommended by PEUGEOT and not installed in accordance with its instructions, in particular where the equipment in question consumes more than 10 milliamperes.

9
126
Fuse N°RatingFunctions
120 AEngine control unit supply and fan assembly control - Engine control unit main relay - Injection control unit (Diesel) - Injection pump (Diesel) - Air heating solenoid valves (Diesel) - Air fl ow sensor (Diesel).
215 AHorn.
310 AFront and rear wash-wipe pump.
420 AHeadlamp wash pump.
515 AFuel pump (petrol).
610 APower steering control unit - Water in diesel sensor - Vehicle spe ed sensor.
710 ASwitching and protection unit (Diesel) - Engine coolant level detector (Diesel).
825 AStarter.
910 AABS/ESP control unit - ABS cut-off relay - Brake switch.
1030 A
Engine control unit actuators (petrol: ignition coils, oxygen se nsors, injectors, purge canister and variable timing solenoid valves, controlled thermosta t) (Diesel: injection control unit, air fl ow sensor, injection pump, diesel high pressure regulator, EGR and Turbo pressure regulation solenoid valves) - Blow-by heaters - Diesel heate r.
1140 AAir blowers.
1230 AWindscreen wipers (low/high speed).
1340 A(ignition positive) Built-In Systems Interface.
14-Not used.
1510 ARight main beam headlamp.
1610 ALeft main beam headlamp.
1715 ALeft dipped headlamp.
1815 ARight dipped headlamp.

9
127
CHANGING A WINDSCREEN WIPER BLADE
Changing a front wiper blade

 Lift the wiper arm.

 Unclip the blade and remove it.

 Fit the new blade.

 Push back the wiper arm.

Note: the shortest blade is fi tted on
the right-hand wiper arm.
Changing the rear wiper blade

 Lift the wiper arm.

 Unclip the blade and remove it.

 Fit the new blade.

 Push back the wiper arm.
ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (doors, windscreen wipers,
electric windows, courtesy light, audio
equipment, dipped headlamps, etc.)

can only be used for a cumulative
duration of thirty minutes, to prevent
discharging of the battery.
Once the thirty minutes are over, a
message informing you of the switch
to economy mode appears on the
multifunction display and the active
functions are put on standby.
These functions are reactivated
automatically next time the vehicle is
driven.
To resume the use of these functions
immediately, start the engine and let
it run for a few minutes.
The time available to you will then be
double the duration for which the en-
gine is left running. However, this pe-
riod will always be between fi ve and
thirty minutes.

Note: if the telephone is being used
when economy mode starts, it will
still be possible to fi nish the call.
A fl at battery will prevent the
engine from starting.
FITTING/REMOVING THE MAT
When removing the mat on the dri-
ver's side, push the seat as far back
as possible and remove the fi xings.
When refi tting, position the mat
correctly on the pins and clip the
fi xings. Check that the mat is secured
correctly.
To prevent the mat from becoming
caught under the pedals:
- only use mats suited to the fi xings already present in the
vehicle. It is imperative that these
fi xings are used.
- never fi t one mat on top of another.
Placing the wiper blades in the
special position


Less than a minute after switching
off the ignition, operate the wip-
ers stalk to position the wiper
blades in the centre of the wind-
screen.

To return the windscreen wipers
to their normal position, switch on
the ignition and operate the wipers
stalk.

9
128
BATTERY
The batteries contain harmful
substances such as sulphuric
acid and lead. They must be
disposed of in accordance
with regulations and must never be
discarded with household waste.
Take used remote control and vehi-
cle batteries to a special collection
point.
To start the vehicle from
another battery:
-
Connect the red cable to the positive
(+) terminals of the two batteries,
- Connect the green or black ca- ble to the negative (-) terminals
of the two batteries,
- Operate the starter, let the en- gine run,
- Wait for the engine to return to idle, then disconnect the cables.
Before disconnecting the
battery, you must wait for
2 minutes after switching off
the ignition.
Never disconnect a terminal when
the engine is running.
Never charge a battery without fi rst
disconnecting the terminals.
Close the windows, the sunroof and
the doors before disconnecting the
battery. If they do not operate nor-
mally following reconnection of the
battery, they must be reinitialised
(see sections "Sesame doors" and
"Sunroof"). After every reconnection of the bat-
tery:
- switch on the ignition and wait
1 minute before starting to al-
low the electronic systems to be
initialised. If slight diffi culties are
experienced after this, please
contact a PEUGEOT dealer.
-
reinitialise the "2 Tronic" gearbox
(refer to the corresponding section).

A. Flat battery

B. Slave battery
It is advisable to disconnect
the battery if the vehicle is
not to be used for a period
of more than one month.
To charge the battery using a
battery charger:
- Disconnect the battery,
- Follow the instructions for use
given by the battery charger
manufacturer,
- Reconnect starting with the nega- tive (-) terminal,
- Check that the terminals and connectors are clean. If they are
covered with sulphate (white or
greenish deposit), disconnect
them and clean them.

9
129
TOWING YOUR VEHICLE
From the rear:

 Unclip the side of the cover using
the fl at part of the towing eye,

 Screw in the towing eye until it
locks. When towing with the en-
gine switched off, there is no
braking assistance.
Special features of
the "2 Tronic" gearbox
When towing with four wheels on the
ground, the following rules must be
obeyed:
- gear lever in position
N ,
- tow the vehicle at less than 30 mph (50 km/h) over a maxi-
mum distance of 30 miles (50 km).
- do not add oil to the gearbox.
From the front:

 Unclip the bottom of the cover,
using the fl at part of the towing
eye.

 Screw in the towing eye until it
locks. Lifting
(2 wheels only on the road)
It is preferable to raise the vehicle by
the wheels.

Never use the radiator crossmember.
Without lifting
(4 wheels on the road)
You should always use a towbar.
The removable towing eye is stored
in the tool case, located in the left
boot trim.
Vehicles fitted with a manual
gearbox (diesel version)
In the case of vehicles fi tted with a
manual gearbox, the gear lever must
be in the neutral position.
Failure to observe this special condi-
tion may result in damage to certain
braking components and the absence
of braking assistance the next time
the engine is started.