2008.5 Citroen C3 PICASSO DAG Owner's Manual

124
PRACTICAL INFORMATION
Interior lighting
Interior lamps (1/W 5 W)
Detach the cover of the interior lamp 1
with a thin screwdriver, close to the but-
ton, to access the faulty bulb.
Map reading lamps (2/W 5 W)
Detach the cover of the interior lamp. To
access the faulty bulb, detach the parti-
tion for the reading lamp 2 concerned,
as necessary. Footwell lamps (W 5 W)
Unclip the cover using a thin screwdriver
to access the faulty bulb.
Boot lamps (W 5 W)
Detach the unit by pushing it rearwards. Torch (Krypton 3.6 V)

 Open the tab.

 Push with a fl at screwdriver in the
hole under the tab and recover the
bulb unit.

 Open the bulb unit fully to change
the bulb.
Exterior mirror lamps (W 5 W)
Unclip the cover using a thin screwdriver
to access the faulty bulb.

i
!
125
PRACTICAL INFORMATION CITROËN will not accept responsi-
bility for the cost incurred in repairing
your vehicle or for rectifying malfunc-
tions resulting from the installation
of accessories not supplied and not
recommended by CITROËN and
not installed in accordance with its
instructions, in particular when the
combined consumption of all of the
additional equipment connected ex-
ceeds 10 milliamperes.
Installing electrical accessories
Your vehicle's electrical system is
designed to operate with standard
or optional equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a CITROËN dealer.
CHANGING A FUSE
Procedure for replacing a faulty fuse
with a new fuse to rectify a failure of the
corresponding function.
Access to the tools
The extraction pliers and the spare fuse
storage compartment are installed on
the back of the fascia fuse box cover.
To gain access to them:

 unclip the cover by pulling on the
side,

 remove the cover completely,

 remove the pliers. Changing a fuse
Before changing a fuse, the cause of
the failure must be identifi ed and recti-
fi ed.

 Identify the faulty fuse by checking
the condition of its fi lament.

 Use the special pliers to extract the
fuse from its housing.

 Always replace the faulty fuse with a
fuse of the same rating.

 Check the correspondence between
the number etched on the box, the
rating etched on the fuse and the ta-
bles below.
Correct Incorrect

126
PRACTICAL INFORMATION
Fascia fuses
The fuse box is placed in the lower sec-
tion of the fascia (left-hand side).
Access to the fuses

 refer to the paragraph "Access to
the tools". Fuse tables

Fuse N° Rating Functions

FH36 5 A Trailer relay unit.

FH37 15 A Trailer accessories socket supply.

FH38 20 A Navigation.

FH39 20 A Heated seats.

FH40 30 A Trailer relay unit.

Fuse N° Rating Functions

F1 15 A Rear wiper.

F2 - Not used.

F3 5 A Air bags and pretensioners control unit.

F4 10 A Steering wheel angle sensor, air conditioning, clutch
switch, particle fi lter pump, diagnostic socket, air-
fl ow meter.

F5 30 A Electric windows panel, passenger's electric window
control, front electric windows motor.

F6 30 A Rear electric windows motor and driver's electric
window motor.

F7 5 A Courtesy and front map reading lights, glove box
lighting, torch, rear reading lights.

127
PRACTICAL INFORMATION

Fuse N° Rating Functions

F8 20 A Multifunction display, audio system, navigation ra dio.

F9 30 A Audio system (fi tted as an option), 12 V socket,
lighter.

F10 15 A Steering wheel controls.

F11 15 A Ignition, diagnostic socket.

F12 15 A Rain/brightness sensor, trailer relay unit.

F13 5 A Main stop switch, engine relay unit.

F14 15 A Parking assistance control unit, seat belt unfastened
warning lamp, airbag control unit, instrument panel,
air conditioning, USB Box.

F15 30 A Locking.

F16 - Not used.

F17 40 A Rear screen and exterior mirrors de-icing.

SH - PARC shunt.

128
PRACTICAL INFORMATION
Engine compartment fuses
The fuse box is placed in the engine
compartment near the battery (left-hand
side).
Access to the fuses

 Unclip the cover.

 Change the fuse (see correspond-
ing paragraph).

 When you have fi nished, close the
cover carefully to guarantee the
sealing of the fuse box. Fuse table

Fuse N° Rating Functions

F1 20 A Engine control unit supply, cooling fan unit control,
multifunction engine control main relay.

F2 15 A Horn.

F3 10 A Front/rear wash-wipe.

F4 20 A Daytime running lamps.

F5 15 A Diesel heater (diesel engine), fuel pump (petrol
engine)

F6 10 A ABS/ESP control unit, ABS/ESP cut-off relay,
secondary stop switch.

F7 10 A Electrical power steering.

F8 25 A Starter control.

F9 10 A Switching and protection unit (Diesel).

F10 30 A Diesel engine injection pump valve, injectors and
ignition coils (petrol engine)

F11 40 A Air conditioning blower.

129
PRACTICAL INFORMATION

Fuse N° Rating Functions

F12 30 A Windscreen wipers slow/fast speed.

F13 40 A Built-in systems interface supply (ignition positive).

F14 30 A Valvetronic supply (petrol).

F15 10 A Right-hand main beam headlamp.

F16 10 A Left-hand main beam headlamp.

F17 15 A Left-hand dipped headlamp.

F18 15 A Right-hand dipped headlamp.

F19 15 A Multifunction engine control supply (petrol engine),
air cooling solenoid valves (Diesel).

F20 10 A Multifunction engine control supply (petrol engine),
Turbo pressure regulation valve (Diesel), engine
coolant level detector (Diesel).

F21 5 A Fan assembly control supply, APC, ABS ESP
relays.

130
PRACTICAL INFORMATION
Table of maxi-fuses

Fuse N° Rating
Functions

MF1 * 60 A Fan assembly.

MF2 * 30 A ABS/ESP control unit.

MF3 * 30 A ABS/ESP control unit.

MF4 * 60 A Built-in Systems Interface (BSI) supply.

MF5 * 60 A Built-in Systems Interface (BSI) supply.

MF6 * - Not used.

MF7 * - Passenger compartment fusebox.

MF8 * - Not used.
* The maxi-fuses provide additional protection for the e lectrical systems. All work on the maxi-fuses must be carried out by a
CITROËN dealer.

131
PRACTICAL INFORMATION
BATTERY
Procedure for charging your battery
when it is fl at or for starting the engine
using another battery.
Access to the battery Starting using another battery

 Connect the red cable to the posi-
tive terminal (+) of the fl at battery A ,
then to the positive terminal (+) of
the slave battery B .

 Connect one end of the green or
black cable to the negative terminal
(-) of the slave battery B .

 Connect the other end of the green
or black cable to the negative termi-
nal (-) of the fl at battery A .

 Start the slave vehicle.

 Operate the starter of the broken
down vehicle and let the engine
run.

 Wait until the engine returns to idle
and disconnect the cables.
The battery is located under the bon-
net.
To gain access to it:

 open the bonnet using the interior
lever, then the exterior lever,

 secure the bonnet strut,

 remove the plastic cover to gain ac-
cess to the two terminals,

 unclip the fuse box to remove the
battery, if necessary.