2008.5 Citroen C3 PICASSO DAG Owner's Manual

!
75
LAYOUT
To avoid any risk of jamming of the
pedals:
- only use mats which are suited to the fi xings already present in
the vehicle; it is imperative that
these are used,
- never fi t one mat on top of another.
MAT
Removable component which protects
the carpet against exterior dirt. Refitting
To refi t the mat on the driver’s side:

 position the mat correctly,

 refi t the fi xings by pressing,

 check that the mat is secured cor-
rectly.
Fitting
When fi tting the mat for the fi rst time,
use only the fi xings provided in the
wallet attached.
Removal
To remove the mat on the driver’s side:


move the seat as far back as possible,

 unclip the fi xings,

 remove the mat.
CARD HOLDER
It is located at the top of the dashboard
central panel.
It allows you to store toll cards or parking
tickets for example.

!
i
74
LAYOUT
STORAGE DRAWER
It is located under the front passenger
seat.
LIGHTER/12 V ACCESSORIES SOCKET
This can either be used as a lighter, or a
12 V accessories socket:

 To use the lighter, press it in and
wait a few seconds until it pops out
automatically.

 To connect a 12 V accessory (max
power: 100 Watts), remove the lighter
and connect a suitable adaptor.
REMOVABLE ASHTRAY

 Pull the cover to open the ashtray.

 To empty it, remove the ashtray by
pulling it upwards.
Opening

 Raise the front of the drawer and pull it.
Do not place heavy objects in the
drawers.
If you are using the lighter, there is
a 12 V accessory socket located
behind the central console.

!
75
LAYOUT
To avoid any risk of jamming of the
pedals:
- only use mats which are suited to the fi xings already present in
the vehicle; it is imperative that
these are used,
- never fi t one mat on top of another.
MAT
Removable component which protects
the carpet against exterior dirt. Refitting
To refi t the mat on the driver’s side:

 position the mat correctly,

 refi t the fi xings by pressing,

 check that the mat is secured cor-
rectly.
Fitting
When fi tting the mat for the fi rst time,
use only the fi xings provided in the
wallet attached.
Removal
To remove the mat on the driver’s side:


move the seat as far back as possible,

 unclip the fi xings,

 remove the mat.
CARD HOLDER
It is located at the top of the dashboard
central panel.
It allows you to store toll cards or parking
tickets for example.

LAYOUT
REAR INTERIOR LAYOUT
They are located on the back of the
front seats.
Two boxes are available, located under
the rear passenger footwells.
To open them, lift the lid using the
groove
A . There is a bottle-holder located at the
rear of the central console.
Storage boxes Seat pockets Bottle-holder

!
77
LAYOUT
It is located at the rear of the central
console if the lighter is installed in the
front.
12 volts socket (100 W max)
Lift up the control to release the table
and unfold it.
Aircraft style tables
Reading lamps are built into the back of
the front seats, behind the tables. With
the ignition on, they light up the top of
the table without inconveniencing other
passengers.
They are only accessible if the table is
unfolded.

 Press the button to switch the light
on or off.
Individual reading lamps
Do not place hard or heavy objects
on the table. They could become
dangerous projectiles in the event
of sharp braking or impact.
As a safety precaution, if too much
pressure is exerted the table will
fold back downwards.

LAYOUT Storage tray
Opening

 Lower the storage shelf.

 Press the fl ap opening control.

 Lower the fl ap.

 Load the objects from inside the
boot.
Ski flap
Device for storing and transporting long
objects.
Side blinds may be available on the
sliding side doors.
Pull the side blind by the tab to install it.
Always guide the blind slowly using
the tab, both when raising and when
lowering.
Side blinds
When unfolded, this provides a storage
area split into 2 sections.

!
77
LAYOUT
It is located at the rear of the central
console if the lighter is installed in the
front.
12 volts socket (100 W max)
Lift up the control to release the table
and unfold it.
Aircraft style tables
Reading lamps are built into the back of
the front seats, behind the tables. With
the ignition on, they light up the top of
the table without inconveniencing other
passengers.
They are only accessible if the table is
unfolded.

 Press the button to switch the light
on or off.
Individual reading lamps
Do not place hard or heavy objects
on the table. They could become
dangerous projectiles in the event
of sharp braking or impact.
As a safety precaution, if too much
pressure is exerted the table will
fold back downwards.

LAYOUT Storage tray
Opening

 Lower the storage shelf.

 Press the fl ap opening control.

 Lower the fl ap.

 Load the objects from inside the
boot.
Ski flap
Device for storing and transporting long
objects.
Side blinds may be available on the
sliding side doors.
Pull the side blind by the tab to install it.
Always guide the blind slowly using
the tab, both when raising and when
lowering.
Side blinds
When unfolded, this provides a storage
area split into 2 sections.