Page 210 of 268
2007 Volvo XC90
Replacing the turn signal bulb
- Turn the lamp holder approximately 1/4 turn counterclockwise and pull \
it out of the headlight housing.
- Press in the bulb slightly and pull it out of the holder.
- Align the guide lugs on the side of the base of the new bulb in the gr\
ooves in the holder. Press it in and
turn it slightly clockwise.
- Press the lamp holder into the place in the headlight housing and turn\
it approximately 1/4 turn
clockwise.
Front fog lights
Avoid touching the glass on the bulb
with your fingers.
- Switch off the ignition.
- Turn the bulb holder slightly counterclockwise to release it.
- Replace the bulb. The shape of the foot of the bulb corresponds to the\
shape of the bulb holder.
- Reinstall the bulb holder by turning it slightly clockwise. The side o\
f the holder marked "TOP" should
face upward.
pg. 198 Maintenance
Replacing bulbs
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (24 of 37)12/30/200\
6 5:53:50 PM
Page 212 of 268

2007 Volvo XC90
- Place the tail light housing on a soft cloth to avoid scratching the l\
ens.
- Turn the lamp holder(s) counterclockwise and pull out.
- Turn signal, back-up light, brake light bulbs: Turn the bulb countercl\
ockwise and remove it.
- Parking light bulbs: Pull the bulb straight out.
- Insert a new bulb.
- Place the lamp holder in the groove and turn clockwise.
- Press wiring back into place.
- Align the tail light housing with the holes for the retaining bolts an\
d press it into place.
- Tighten the retaining bolts.
- Reinsert the side and corner panels.
pg. 199 Maintenance
Replacing bulbs
Rear fog light
- Switch off the ignition.
- Carefully insert a small screwdriver (see illustration above).
- Pry out the lamp housing.
- Turn the bulb holder counterclockwise and remove it.
- Turn the bulb counterclockwise and remove it.
- Insert a new bulb and press the lamp housing back into place.
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (26 of 37)12/30/200\
6 5:53:50 PM
Page 214 of 268
2007 Volvo XC90
Vanity mirror lights
- Carefully insert a screwdriver and pry out the lens.
- Pry out the bulb and replace it.
- Carefully press the lower edge of lens onto the four tabs and press th\
e upper edge of the lens into place.
License plate lights
- Switch off the ignition.
- Loosen the screws with a Torx screwdriver.
- Turn the bulb holder counterclockwise and pull it out.
- Pull out the defective bulb and insert a new one.
- Reinsert the bulb holder into the housing and turn it clockwise.
- Reinstall the housing and screw it into place.
NOTE: Other bulbs may be difficult for you to replace yourself. Let an author\
ized Volvo retailer
replace these bulbs if necessary.
pg. 201 Maintenance
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (28 of 37)12/30/200\
6 5:53:50 PM
Page 217 of 268

2007 Volvo XC90
18. -
19. Engine control module feed, engine relay 5
20. Parking lights 15
21. -
pg. 203 Maintenance
Fuses
Fuses in the passenger compartment
Fuses are located inside the access panel on the edge of the dashboard, \
on the driver's side. There are
also a number of spare fuses. When replacing a blown fuse, be sure to re\
place it with a new one of the
same color and amperage (written on the fuse).
No. Amperage
1. Blower - climate system 30
2. Audio amplifier 30
3. Power driver's seat (option) 25
4. Power passenger's seat (option) 25
5. Driver's door - central locking, power windows, door mirror 25
6. Front passenger's door - central locking, power windows, door mirror \
25
7. -
8. Radio, CD player, Rear Seat Entertainment (RSE) 15
9. Volvo Navigation System (option), Sirius satellite radio (option)\
10
10. On-board diagnostics, headlight switch, steering wheel angle sensor,\
steering wheel
module 5
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (31 of 37)12/30/200\
6 5:53:51 PM
Page 222 of 268
2007 Volvo XC90
16. -
17. Accessory audio 5
18. -
19. Rear window wiper 15
20. Trailer wiring (15-feed) 20
21. -
22. -
23. All Wheel Drive 7.5
24. -
25. -
26. Park assist 5
27. Main fuse: trailer wiring, park assist, All Wheel Drive 30
28. Central locking system 15
29. Driver's side trailer lighting: parking lights, turn signal 25
30. Passenger's side trailer lighting: brake light, fog light, turn sign\
al 25
pg. 206 Maintenance
Fuses
No.Amperage
31. Main fuse: fuses 37 and 38 40
32. -
33. -
34. -
35. -
36. -
37. Heated rear window 20
38. Heated rear window 20
file:///K|/ownersdocs/2007/2007_XC90/07xc90_09.htm (36 of 37)12/30/200\
6 5:53:51 PM
Page 225 of 268

2007 Volvo XC90
1. Model plate
Vehicle Identification Number (VIN). Codes for color and upholstery, e\
tc.
2. Child safety lock labels
1
3. Federal Motor Vehicle Safety Standards (FMVSS) specifications (USA\
) and Ministry of
Transport (CMVSS) standards (Canada)
Your Volvo is designed to meet all applicable safety standards, as evide\
nced by the certification label on
the facing side of the driver's door. For further information regarding \
these regulations, please consult
your Volvo retailer.
4. Loads and Tire Pressures
The appearance of the decal will vary, depending on the market for which\
the vehicle is intended.
l Canadian models: upper decal
l U.S. models: lower decal
5. Vehicle Identification Number (VIN)
The VIN plate is located on the top left surface of the dashboard. The V\
IN is also stamped on the right
hand door pillar. The Vehicle Identification Number (VIN) should alway\
s be quoted in all
correspondence concerning your vehicle with the retailer and when orderi\
ng parts.
6. Vehicle Emission Control Information/ Vacuum hose routing
Your Volvo is designed to meet all applicable emission standards, as evi\
denced by the certification label
on the underside of the hood. For further information regarding these re\
gulations, please consult your
Volvo retailer.
file:///K|/ownersdocs/2007/2007_XC90/07xc90_10.htm (2 of 10)12/30/2006\
5:53:52 PM
Page 226 of 268
2007 Volvo XC90
1. Not on vehicles equipped with the optional power child safety locks. \
pg. 209 Specifications
Weights
Gross vehicle weight1 USA
Canada
5-seat, 6-cyl, FWD 5750
lbs -
5-seat, 6-cyl, AWD 5900
lbs 2680 kg
5-seat, 8-cyl, AWD 5900
lbs 2680 kg
7-seat, 6-cyl, FWD 5915
lbs -
7-seat, 6-cyl, AWD 6080
lbs 2760 kg
7-seat, 8-cyl, AWD 6100
lbs 2770 kg
Capacity weight
5-seat models 1160
lbs 525 kg
7-seat models 1210
lbs 550 kg
Permissible axle weight,
front*
5-seat, 6-cyl, FWD 770 lbs -
5-seat, 6-cyl, AWD 2880
lbs 1310 kg
5-seat, 8-cyl, AWD 2930
lbs 1330 kg
7-seat, 6-cyl, FWD 2770
lbs -
7-seat, 6-cyl, AWD 2880
lbs 1310 kg
file:///K|/ownersdocs/2007/2007_XC90/07xc90_10.htm (3 of 10)12/30/2006\
5:53:52 PM
Page 231 of 268

2007 Volvo XC90
pg. 214 Specifications
Suspension
the support frame. Power-assisted rack and pinion steering. Safety type \
steering column.
pg. 215 Specifications
Three-way catalytic converter
Points to keep in mind
l Keep your engine properly tuned. Certain engine malfunctions, particular\
ly involving the electrical,
fuel or distributor ignition systems, may cause unusually high three-way\
catalytic converter
temperatures. Do not continue to operate your vehicle if you detect engi\
ne misfire, noticeable loss of
power or other unusual operating conditions, such as engine overheating \
or backfiring. A properly tuned
engine will help avoid malfunctions that could damage the three-way cata\
lytic converter.
l Do not park your vehicle over combustible materials, such as grass or le\
aves, which can come into
contact with the hot exhaust system and cause such materials to ignite u\
nder certain wind and weather
conditions.
l Excessive starter cranking (in excess of one minute), or an intermitte\
ntly firing or flooded engine can
cause three-way catalytic converter or exhaust system overheating.
l Remember that tampering or unauthorized modifications to the engine, the\
Electronic Control
Module, or the vehicle may be illegal and can cause three-way catalytic \
converter or exhaust system
overheating. This includes:
- Altering fuel injection setting or components.
- Altering emission system components or location or removing components\
.
- Repeated use of leaded fuel.
NOTE: Unleaded fuel is required for vehicles with three-way catalytic convert\
ers.
pg. 216 Specifications
Electrical system
12-volt system with voltage controlled generator. Single wire system in \
which the chassis and engine
block are used as conductors, grounded on the chassis.
Battery 3.2 6-cyl. V8
Voltage 12 V 12 V
file:///K|/ownersdocs/2007/2007_XC90/07xc90_10.htm (8 of 10)12/30/2006\
5:53:52 PM