2007 Volvo XC70
Locking and unlocking the vehicle from the inside
The switch on the driver's door armrest can be used to lock or unlock al\
l doors and the tailgate, and to
set the alarm.
Each door can also be locked with the lock button on the respective door\
and opened by pulling the door
handle on the door.
Automatic locking
The function locks the doors automatically when the vehicle's speed exce\
eds approximately 5 mph (7
km/h). The doors will then remain locked until a door in opened from th\
e inside or if all of the doors are
unlocked from the control panel in the driver's door.
This function can be activated/deactivated from the control panel in the\
driver's door.
Activating/deactivating automatic locking
- Turn the ignition key to position I or II.
- Press the READ button on the left-side steering wheel lever to erase a\
ny messages that may be
displayed in the information display.
- Depress the central locking button on the control panel until a new me\
ssage about the locking status is
displayed.
The message AUTOLOCK ON (the doors will be locked when the vehicle begi\
ns to move) or
AUTOLOCK OFF will be displayed.
Unlocking/locking the tailgate with the remote control
Do as follows to unlock the tailgate only:
- Press the "Unlock tailgate" button on the remote control.
- Relock the tailgate using the remote's "Lock" button.
If all doors are locked when you close the tailgate, it locks automatica\
lly.
pg. 115 Locks and alarm
file:///K|/ownersdocs/2007/2007_XC70/07xc70_05.htm (7 of 12)12/30/2006\
5:51:34 PM
2007 Volvo XC70
Temporarily turning off the inclination and movement alarm sensor(s) -\
accessory
This button will only be found in vehicles equipped with the accessory i\
nclination and/ or movement
sensors. FCC ID: MAYDA5823
This device complies with part 15 of the FCC rules. Operation is subject\
to the following conditions:
(1) This device may not cause harmful interference, and (2) this dev\
ice must accept any interference
received, including interference that may cause undesired operation.
Canadian IC: 4405A-DA5823
Movement sensor DA5823 by Dynex
Operation is subject to the following conditions: (1) this device may \
not cause interference, and (2)
this device must accept any interference, including interference that ma\
y cause undesired operation of
the device.
In certain situations it may be desirable to turn off the accessory incl\
ination and movement alarm
sensors if, for example, you drive your vehicle onto a ferry where the r\
ocking of the boat could trigger
the alarm or if a pet is left in the vehicle with the doors locked.
To temporarily turn off the inclination and movement alarm sensors from \
the alarm system:
From the time the ignition key is turned from the Drive position (posit\
ion II) until you lock the vehicle,
you can press the button in the center console. The LED in the switch wi\
ll light up and a message will be
displayed in the text window to indicate that the sensors are disconnect\
ed.
The vehicle can then be locked in the usual way to set the alarm.
NOTE:
l This function will not turn off the vehicle's standard alarm.
l The optional sensors are automatically reconnected to the alarm system t\
he next time the vehicle is
unlocked and then locked again.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_05.htm (11 of 12)12/30/200\
6 5:51:34 PM
2007 Volvo XC70
LED alarm status signals
The status of the alarm system is indicated by the red LED at the top of\
the dash:
l LED off - the alarm is not armed
l LED flashes once per second - the alarm is armed
l LED flashes rapidly before the ignition is switched on - the alarm has b\
een triggered
l Fault in the alarm system: If a fault has been detected in the alarm system, a message will be
displayed in the text window. Contact your Volvo retailer.
Automatic re-lock/re-arm system
If the vehicle is unlocked with the remote, the vehicle will re-lock and\
the alarm will re-arm after 2
minutes unless a door or the tailgate has been opened.
pg. 118 Locks and alarm
This page left intentionally blank.
Contents | Top of Page
file:///K|/ownersdocs/2007/2007_XC70/07xc70_05.htm (12 of 12)12/30/200\
6 5:51:34 PM
2007 Volvo XC70
D (Drive)
D is the normal driving position and should be used as often as possible\
to help improve fuel economy.
The vehicle should not be moving when shifting from R to the D position.
4 (Intermediate gear)
The transmission will shift automatically between gears 4, 3, 2 or 1 fro\
m this position. The transmission
cannot shift up to (D)rive from fourth gear.
3 (Intermediate gear)
The transmission will shift automatically between gears 3, 2 and 1 from \
this position. The transmission
cannot shift up to fourth gear or (D)rive from third gear.
L (Low gears)
The transmission is locked in gears 1 and 2 when the selector is in this\
position.
NOTE: Gears 4, 3, or L can be used if you are driving in a mountainous area, \
towing a trailer or to
increase engine braking effect. The transmission has a built-in limiter \
designed to help prevent excessive
engine speeds (high rpm) when gears 4, 3 or L are selected.
pg. 131 Starting and driving
Automatic transmission (option)
W - Winter/Wet driving mode - enhanced vehicle traction
l Mode W will only function if the gear selector is in the (D)rive position.
l Press the button at the base of the gear selector to engage/disengage th\
is driving mode (see
illustration).
l When the W driving mode is engaged, this is displayed in the instrument \
panel (see page 46).
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (15 of 41)12/30/200\
6 5:51:37 PM
2007 Volvo XC70
Shift gate positions
You can move the gear selector freely between the (MAN)ual and (D)rive positions while driving.
Depress the button on the front of the gear selector knob to move betwee\
n the R, N, D, and P positions.
Manual shifting
You can move the gear selector freely between the (MAN)ual and (D)rive positions while driving. Gears
3, 4, 5, and 6 (where applicable) have a "lock-up" function which redu\
ces engine speed and helps save
fuel.
The currently selected gear will be displayed in the instrument panel (\
see
page 46).
pg. 133 Starting and driving
Geartronic (option)
l To access the (MAN)ual shifting position from (D)rive, move the gear selector to the left to MAN.
l To return to the (D)rive position from MAN, move the gear selector to the right.
While driving
If you select the (MAN)ual position while driving, the gear that was being used in the (D)rive position
will also initially be selected in (MAN)ual position.
l Move the gear selector forward (toward "+") to shift to a higher gear \
or rearward (toward "-") to shift
to a lower gear.
l If you hold the gear selector toward "-", the transmission will downshif\
t one gear and will utilize the
braking power of the engine. If the current speed is too high for using \
a lower gear, the downshift will
not occur until the speed has decreased enough to allow the lower gear t\
o be used.
l If you slow down to a very low speed, the transmission will automaticall\
y shift down.
l When starting in the (MAN)ual position, 3rd gear is the highest gear that may be selected.
NOTE: Kickdown does not function when the transmission is in the manual shift\
(Geartronic) mode.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (18 of 41)12/30/200\
6 5:51:38 PM
2007 Volvo XC70
reservoir.
NOTE: Press the brake pedal hard and maintain pressure on the pedal - do not \
pump the brakes.
WARNING!
If the fluid level is below the MIN mark in the reservoir or if a "Brake\
failure - Service urgent"
message is displayed in the text window: DO NOT DRIVE. Have the vehicle \
towed to a Volvo
retailer and have the brake system inspected.
NOTE: When the vehicle is at a standstill and the engine is idling, e.g. at a\
traffic light and the brake
pedal is depressed, the pedal may go down slightly. This is a normal fun\
ction of the power-assisted
brake system.
Power brakes function only when the engine is running
The power brakes utilize vacuum pressure which is only created when the \
engine is running. Never let
the vehicle roll to a stop with the engine switched off.
If the power brakes are not working, the brake pedal must be pressed app\
roximately four times harder
than usual to make up for the lack of power assistance. This can happen \
for example when towing your
vehicle or if the engine is switched off when the vehicle is rolling. Th\
e brake pedal feels harder than
usual.
Water on brake discs and brake pads affects braking
Driving in rain and slush or passing through an automatic car wash can c\
ause water to collect on the
brake discs and pads. This will cause a delay in braking effect when the\
pedal is depressed. To avoid
such a delay when the brakes are needed, depress the pedal occasionally \
when driving through rain,
slush etc. This will remove the water from the brakes. Check that brake \
application feels normal. This
should also be done after washing or starting in very damp or cold weath\
er.
Severe strain on the brake system
The brakes will be subject to severe strain when driving in mountains or\
hilly areas or towing. Vehicle
speed is usually slower, which means that the cooling of the brakes is l\
ess efficient than when driving on
level roads. To reduce the strain on the brakes, shift into a lower gear\
and let the engine help with the
braking. Do not forget that, if you are towing a trailer, the brakes wil\
l be subjected to a greater than
normal load.
pg. 137 Starting and driving
Brake system
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (22 of 41)12/30/200\
6 5:51:38 PM
2007 Volvo XC70
Anti-lock brakes (ABS)
If the warning lamp lights up there is a malfunction of the ABS system (\
the standard braking system will
however function) and the vehicle should be driven cautiously to a Volv\
o retailer for inspection. The
Anti-lock Braking System (ABS) helps to improve vehicle control (stop\
ping and steering) during severe
braking conditions by limiting brake lockup. When the system "senses" im\
pending lockup, braking
pressure is automatically modulated in order to help prevent lockup, whi\
ch could lead to a skid.
The system performs a self-diagnostic test when the engine is started an\
d when the vehicle first
reaches a speed of approximately 12 mph (20 km/h). The brake pedal will pulsate several times and a
sound may be audible from the ABS control module. This is normal.
To obtain optimal effect from the ABS system, constant pressure should b\
e kept on the brake pedal. Do
not pump the brake pedal.
The switching of the ABS modulator will be audible and the brake pedal w\
ill pulsate during braking.
Please be aware that ABS does not increase the absolute braking potentia\
l of the vehicle. While control
will be enhanced, ABS will not shorten stopping distances on slippery su\
rfaces.
ABS with EBD (Electronic Brake Force Distribution)
EBD is an integrated part of the ABS system. EBD regulates the hydraulic\
pressure to the rear brakes to
help provide optimal braking capacity. The brake pedal will pulsate duri\
ng braking, which is normal.
If the BRAKE and ABS warning lights come on at the same time, this could\
indicate a fault in the brake
system.
- Stop the vehicle in a suitable place and switch off the engine.
- Restart the engine.
- If both warning lights go off, no further action is required.
- If both lights are still on after the engine has been restarted, switc\
h off the engine again and check the
brake fluid level (see
page 193 for the location of the brake fluid reservoir).
WARNING!
If the fluid level is below the MIN mark in the reservoir or if a "Brake\
failure - Service urgent"
message is displayed in the text window: DO NOT DRIVE. Have the vehicle \
towed to a Volvo
retailer and have the brake system inspected.
- If the brake fluid level is above the MIN mark, drive carefully to an \
authorized Volvo retailer and have
the brake system inspected.
Emergency Brake Assistance (EBA)
The EBA function is designed to provide full brake effect immediately in\
the event of sudden, hard
braking. The system is activated by the speed with which you depress the\
brake pedal.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (23 of 41)12/30/200\
6 5:51:38 PM
2007 Volvo XC70
Spin control (SC)
The spin control function is designed to help prevent the drive wheels f\
rom spinning while the vehicle is
accelerating.
Under certain circumstances, such as when driving with snow chains, or d\
riving in deep snow or loose
sand, it may be advisable to temporarily switch off this function for ma\
ximum tractive force.
Temporarily switching off Spin control
V70R
Press the DSTC button on the center control panel (see
page 50) for at least a half a second. "DSTC
SPIN CONTROL OFF" will be displayed and the indicator light in the butto\
n will go out.
Other V70 models
- Turn the thumb-wheel (1) on the left-side steering wheel lever until\
the STC/DSTC menu is displayed.
- Hold down the RESET button (2) to toggle between STC/DSTC SPIN CONTR\
OL ON or OFF.
NOTE:
l The message STC/DSTC SPIN CONTROL OFF indicates that the stability syste\
m's spin control
function has temporarily been switched off.
l The stability control indicator light will illuminate and remain on until spin control has been
reactivated.
l STC/DSTC ON indicates that all system functions are active1.
l The spin control function is automatically enabled each time the engine \
is started.
1. V70R only: the indicator light in the DSTC button will illuminate to \
indicate that all stability system functions
are on.
pg. 140 Starting and driving
Stability system
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (25 of 41)12/30/200\
6 5:51:38 PM