2007 VOLVO XC70 brake

2007 Volvo XC70
Setting speed
Press + or - to set the current speed. CRUISE-ON will be displayed in th\
e information window in the
instrument panel.
Increasing or decreasing speed
Use + or - in the following ways to increase or decrease the vehicle's s\
peed:
l Press and hold down + or - until the vehicle reaches the desired speed. \
l Press + or - for approximately a half second and release the button to i\
ncrease or decrease vehicle
speed by approximately 1 mph (1.6 km/h).
NOTE: Cruise control will not function at speeds below approximately 20 mph (\
30 km/h).
Braking
l Cruise control is automatically disengaged when the brake pedal is depre\
ssed. The currently set speed
is stored in memory.
l Pressing resume will return the vehicle to the previously set speed.
Acceleration
Momentary acceleration, such as when passing another vehicle, does not a\
ffect cruise control operation.
The vehicle will automatically return to the previously set speed when y\
ou release the accelerator pedal.
Disengaging cruise control
To disengage cruise control, press the CRUISE button. CRUISE or CRUISE-O\
N will no longer be
displayed in the information window in the instrument panel.
NOTE: Cruise control is automatically disengaged if:
l the engine is switched off
l the gear selector is placed in (N)eutral
l the wheels start to spin or lock
l if an increase in speed is maintained for more than one minute
file:///K|/ownersdocs/2007/2007_XC70/07xc70_02.htm (23 of 35)12/30/200\
6 5:51:30 PM

2007 Volvo XC70
l if the vehicle's speed falls below approximately 20 mph (30 km/h).
pg. 63 Instruments and controls
Cruise control
Temporarily disengaging cruise control
l Press 0 to temporarily disengage cruise control. CRUISE will be displaye\
d in the information window
in the instrument panel.
l Press the brake pedal.
Press "resume"
to return to the previously set speed.
WARNING!
Cruise control should not be used in heavy traffic or when driving on we\
t or slippery roads, or when
driving on unpaved or uneven road surfaces. Cruise control may not maint\
ain set speed on steep
downgrades.
pg. 64 Instruments and controls
Parking brake, auxiliary socket/cigarette lighter
Parking brake (hand brake)
The lever is located between the front seats. The brake is applied to th\
e rear wheels.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_02.htm (24 of 35)12/30/200\
6 5:51:30 PM

2007 Volvo XC70
When applying the parking brake
- Press firmly on the brake pedal.
- Pull up the parking brake lever as far as possible.
WARNING!
Always apply the parking brake fully when the vehicle is parked. The ind\
icator light will light up
even if the parking brake has only been partially applied. Always pull u\
p the lever as far as possible.
- Release the brake pedal and ensure that the vehicle is at a standstill\
.
- Put the gear selector in P (automatic transmission) or in 1st gear (\
manual transmission).
Parking on a hill
l If the vehicle is pointing uphill, turn the front wheels so that they po\
int away from the curb.
l If the vehicle is pointing downhill, turn the front wheels so that they \
point toward the curb.
Releasing the parking brake
- Press firmly on the brake pedal.
- Pull the lever up slightly, press the button at the end of the lever a\
nd lower the lever completely.
Auxiliary sockets
The 12 volt sockets can be used to plug in certain accessories such as c\
ellular telephones, etc. The key
must be in position I (or higher) for the auxiliary socket to function\
.
NOTE: The cover should be folded down when the auxiliary socket is not in use.\

Cigarette lighter/ashtrays
file:///K|/ownersdocs/2007/2007_XC70/07xc70_02.htm (25 of 35)12/30/200\
6 5:51:30 PM

2007 Volvo XC70
cushion up or down.
3. Raise/lower seat height: pump the seat up or down.
4. Lumbar support: turn the control for firmer or softer lumbar support.\

5. Backrest tilt: turn the control to adjust the angle of the backrest. \
6. Control panel for optional power seat (see
page 86 for more information).
WARNING!
l Do not adjust the seat while driving. The seat should be adjusted so tha\
t the brake pedal can be
depressed fully. In addition, position the seat as far rearward as comfo\
rt and control allow.
l Check that the seat is securely locked into position after adjusting.
pg. 85 Interior
Front seats
Folding the backrests in the front seat
The front passenger seat backrest can be folded to a horizontal position\
to make room for a long load.
Fold the backrest as follows:
- Move the seat as far back as possible.
- Adjust the backrest to the upright position.
- Lift the catches on the rear of the backrest.
- Without releasing the catches, push the backrest forward.
- Move the seat as far forward as possible so that the head restraint sl\
ides under the glove compartment.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_04.htm (2 of 29)12/30/2006\
5:51:33 PM

2007 Volvo XC70
WARNING!
l Because the driver's seat can be adjusted with the ignition off, childre\
n should never be left
unattended in the vehicle.
l Movement of the seat can be STOPPED at any time by pressing any button o\
n the power seat
control panel.
l Do not adjust the seat while driving. The seat should be adjusted so tha\
t the brake pedal can be
depressed fully. In addition, position the seat as far rearward as comfo\
rt and control allow.
l The seat rails on the floor must not be obstructed in any way when the s\
eat is in motion.
Programming the memory (option)
Three different seating and door mirror positions can be stored in the d\
river seat's memory.
The following example explains how button 1 can be programmed. Buttons 2\
and 3 can be programmed
in the same way.
To program (store) a seat position in button 1:
- Move the seat to the desired position using the seat adjustment contro\
ls (see the previous page).
- Press and hold down the MEM (memory) button.
- With the MEM button depressed, press button 1 briefly to store the sea\
t's current position.
To move the seat to the position that it was in when button 1 was progra\
mmed:
Press and hold down button 1 until the seat stops moving.
As a safety precaution, the seat will stop automatically if the button i\
s released before the seat has
reached the preset position.
pg. 88 Interior
Interior lighting
file:///K|/ownersdocs/2007/2007_XC70/07xc70_04.htm (5 of 29)12/30/2006\
5:51:33 PM

2007 Volvo XC70
Cup holders in the center console - V70
To remove the cup holders:
- Press the cup holder forward (1), while lifting the rear edge (2).\

- Move the cup holder rearward (3), into the groove under the sliding \
cover.
- Angle the front edge of the cup holder upward (4) and lift it out.
Return the cup holder to the storage space in the reverse order.
Cup holders in the center console - XC70
To remove the cup holders:
- Grasp the rear edge of the cup holder and press in the rear side to re\
lease the rear edge.
- Pull up the cup holder's rear edge and the lift it out.
Return the cup holder to the storage space in the reverse order.
NOTE: Avoid pinching the parking brake gaiter.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_04.htm (11 of 29)12/30/200\
6 5:51:33 PM

2007 Volvo XC70
2 0 0 7
VOLVO XC70
Starting and driving

pg. 119 Starting and driving
General information
120
Fuel requirements
121
Starting the car
125
General driving information
127
Manual transmission
129
Automatic transmission (option)
130
Geartronic (option)
132
All Wheel Drive (option)
134
Four-C active chassis system
135
Brake system
136
Stability system
139
Towing
142
Jump starting
144
Towing a trailer
145
Detachable trailer hitch
147
Load carriers (accessory)
148
Cold weather precautions
151
Before a long distance trip
152
Front/rear park assist (option/
accessory)
153
pg. 120 Starting and driving
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (1 of 41)12/30/2006\
5:51:37 PM

2007 Volvo XC70
WARNING!
Before starting, check that the seat, steering wheel and mirrors are adj\
usted properly. Make sure the
brake pedal can be depressed completely. Adjust the seat if necessary. S\
ee page
84 and 86.
- Apply the parking brake (hand brake) if not already set. The gear se\
lector (automatic transmission) is
locked in the (P)ark position (SHIFTLOCK). Manual transmission: the clutch must be fully depressed.
- Without touching the accelerator pedal, turn the ignition key
1 to the starting position. Allow the starter
to operate for up to 10 seconds. Release the key as soon as the engine s\
tarts. If the engine fails to start,
repeat this step.
NOTE:
l If the key blade section of the remote is not fully folded out when star\
ting the vehicle, the immobilizer
function may make it impossible to start the engine.
l After a cold start, idle speed may be noticeably higher than normal for \
a short period. This is done to
help bring components in the emission control system to their normal ope\
rating temperature as quickly
as possible, which enables them to control emissions and help reduce the\
vehicle's impact on the
environment.
l For cold starts at altitudes above 6000 ft (1800 meters), depress the \
accelerator pedal halfway and turn
the key to the starting position. Release the pedal slowly when the engi\
ne starts.
l To release the gear selector from the (P)ark position, the engine must be running (or the ignition key
must be in position II) and the brake pedal must be depressed.
l Select the desired gear. The gear engages after a very slight delay whic\
h is especially noticeable when
selecting R.
NOTE: Your vehicle is equipped with a KEYLOCK system (automatic transmission). When the engine
is switched off, the gear selector must be in the (P)ark position before the key can be removed from the
ignition switch.
When starting in cold weather, the transmission may shift up at slightly\
higher engine speeds than
normal until the automatic transmission fluid reaches normal operating t\
emperature.
1. If two of the keys to your vehicle are close together, e.g. on the sa\
me key ring, when you try to start the
vehicle, this could cause interference in the immobilizer system and res\
ult in the vehicle not starting. If this
should occur, remove one of the keys from the key ring before trying to \
start the vehicle again.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (7 of 41)12/30/2006\
5:51:37 PM