
B. Sliding  moonroof
Manual open: Pull the switch rearward to position 3 and  hold it until the moonroof  has opened to the position of your
choice.
Auto open: Pull the switch as far back as possible (position 4) and  release it to automatically  slide open  the moonroof
to the "comfort"
1 position. Pull the switch rearward again to open  the moonroof  completely.
Manual close:  Push  the switch to position 2 and  hold it until the moonroof  has closed completely  or to the position of
your choice.
Auto close:  Push  the switch forward as far as possible (position 1) and  release it to automatically  close the moonroof.
CAUTION!
- Remove ice and  snow before opening the moonroof.
- Do not operate  the moonroof  if it is frozen closed.
- Never  place heavy objects on the moonroof.
WARNING!
 Never  open/close the moonroof  it is obstructed in any  way when in operation.
 Never  allow a  child to operate  the moonroof.
 Never  extend any  object  or body part through the open  moonroof,  even if the vehicle's ignition is completely
switched off.
 Never  leave a  child alone in a  vehicle.
1. A position where the moonroof  is not quite fully open, which helps alleviate  "rumbling"  wind noise.
pg. 69 Instruments and controls
Power moonroof (option)
ProCarManuals.com 

Climate control maintenance
Special  tools  and  equipment are required to maintain and  carry out repairs on the climate  system. Work of this  type
should only be  done  by a  trained and  qualified Volvo service technician.
Refrigerant
Volvo cares about the environment. The air conditioning system in your vehicle contains a  CFC-free refrigerant -
R134a (HFC134a). This substance will not deplete the ozone layer. The system contains 1.5 lbs (700 g) R134a and
uses PAG  oil.
Climate system blower
The climate  system blower will be  automatically  switched off when the engine is not running (even if the ignition key
is in position I or II) to avoid unnecessary  battery drain. To activate the blower, turn the control to the desired setting.
Passenger compartment blower
Approximately 50 minutes after the ignition is turned off, the blower may come on automatically,  and  run for seven
minutes, to remove condensation in the A/C evaporator.
pg. 73 Climate
Air distribution
Air  distribution
The incoming air is distributed through 14 ventilation points  in the passenger  compartment.
Air  vents in the dash
A. Open
B. Closed
ProCarManuals.com 

pg. 81 Interior
Front seats
Folding the backrests in the front seat
The front  passenger  seat backrest can be  folded to a  horizontal position to make room for a  long load. Fold the
backrest as follows:
- Move the seat as far back as possible.
- Adjust the backrest to the upright position.
- Lift the catches  on the rear of the backrest.
- Without releasing the catches,  push the backrest forward.
- Move the seat as far forward as possible so that the head restraint slides under the glove compartment.
WARNING!
Cover  sharp edges on the load to help prevent injury to occupants. Secure the load to help prevent shifting during
sudden stops.
pg. 82 Interior
Front seats
Power seat - (option on certain models)
Operation
Driver's seat:  The seat can be  adjusted if the ignition key  is in position I, II or if the engine is running. It can also be
adjusted as follows with the ignition off :
 Within several minutes after the driver's door has been unlocked from  the outside, has been opened, and  remains
open.
 Within a  short period if the driver's door has just  been closed.
 Within a  short period if the driver's door has not been opened after the ignition has been switched off.
Passenger seat:  The seat can only be  adjusted if the ignition key  is in position I, II or if the engine is running.
ProCarManuals.com 

Seat adjustment
If your Volvo is equipped with power seats,  the following may be  adjusted with the two switches  at the side of the
seat:
A. Front edge of seat (raise/lower)
B. Front - rear
C. Rear edge of seat (raise/lower)
D. Backrest tilt
NOTE:The power seats  have an  overload protector that activates if a  seat is blocked by any  object.  If this  occurs,
switch off the ignition (key in position 0) and  wait for a  short period before operating the seat again.
Emergency stop
If the seat accidentally begins to move, press any  of the buttons  to stop the seat.
Remote keyless entry system and the driver's seat
The remote control transmitter also controls the position of the electrically  operated  driver's seat in the following way:
- Adjust the seat to your preferences.
- When you leave your vehicle, lock it using the remote control.
The position of the seat is now stored  in the remote control.
Automatic seat adjustment
To move the seat to the position in which  you left it:
- Unlock  the driver's door with the same remote control (the one  used to lock the doors)
- Open the driver's door within 2 minutes. The driver's seat will automatically  move to the position in which  you left it.
NOTE:
 The seat will move to this  position even if someone else has moved it to a  different  seating position and  locked the
vehicle with a  different  remote control.
 This feature will work in the same way with all of the remote control transmitters (up to 3) that you use with your
vehicle.
pg. 83 Interior
Front seats
NOTE:  This feature will not function if you lock your vehicle with the key.
WARNING!
ProCarManuals.com 

 Because the driver's seat can be  adjusted with the ignition off, children should never be  left unattended in the
vehicle.
 Movement of the seat can be  STOPPED at any  time by pressing any  button on the power seat control panel.
 Do not adjust the seat while driving. The seat should be  adjusted so that the brake pedal can be  depressed  fully. In
addition, position the seat as far rearward as comfort and  control allow.
 The seat rails on the floor  must  not be  obstructed in any  way when the seat is in motion.
Programming the memory (option)
Three different  seating and  door mirror positions can be  stored  in the driver seat's memory.
The following example explains how button 1 can be  programmed. Buttons 2 and  3 can be  programmed in the same
way.
To program (store) a  seat position in button 1:
- Move the seat to the desired position using the seat adjustment controls (see the previous  page).
- Press and  hold down the MEM (memory) button.
- With the MEM button depressed,  press button 1 briefly to store  the seat's current position.
To move the seat to the position that it was in when button 1 was programmed:
Press and  hold down button 1 until the seat stops moving.
As a  safety precaution, the seat will stop automatically  if the button is released before the seat has reached the preset
position.
pg. 84 Interior
Interior lighting
Reading lights and courtesy light
ProCarManuals.com 

1. Driver's side front  reading lamp
2. Courtesy lights
3. Passenger's  side front  reading lamp
The reading lights can be  switched on or off by pressing buttons  1 or 3.
The courtesy light can be  turned on or off by pressing button 2.
4. Driver's side rear reading light
5. Passenger's  side rear reading light
The rear reading lights can be  switched on and  off by pressing buttons  4 or 5.
Automatic function
The reading lights and  courtesy lights will switch off automatically  approximately 10 minutes after the engine has been
turned off. The lights can be  turned off sooner by pressing the respective buttons.
The courtesy lights come on automatically
1 and  remain on for approximately 30 seconds when:
 The vehicle has been unlocked from  the outside with the remote control or key
 If the engine has been switched off and  the ignition key  has been turned to position 0
The courtesy lights will come on and  remain on for approximately 10 minutes when:
 One of the doors is opened (assuming the courtesy lighting has not previously been switched off)
The courtesy lighting will go off when:
 The engine is started
 The vehicle is locked from  the outside with the remote control or key
The automatic  function can be  disconnected by pressing button 2 for more than 3 seconds.
Briefly pressing the button again automatically  reconnects the function.
The courtesy light timer periods  can be  changed. Contact your Volvo retailer.
1. This  function  is light dependent and is only  activated in  dark  conditions.
pg. 85 Interior
Interior lighting
ProCarManuals.com 

2 0 0 7
VOLVO S60
Locks and alarm
pg. 95 Locks and alarm
Keys 96
Remote control97
Locking and  unlocking100
Child safety locks102
Alarm103
pg. 96 Locks and alarm
Keys
Two types of keys are provided with your vehicle; master keys and  a  service (valet) key.  The master key,  the remote
control, and  the central locking button may all be  used to lock and  unlock all of your vehicle's locks.
The service key  will operate  only the driver's door and  the ignition switch. It is intended  to help deter unwanted entry
into the glove compartment and  trunk.
 Turn  the key  once to unlock the driver's door only.
ProCarManuals.com 

 Turn  the key  again (within 10 seconds) to unlock all doors and  the trunk.
 One turn with the key  towards lock in the drivers door locks all doors and  the trunk.
 Use the switch on the driver's door armrest to lock/unlock the vehicle from  the inside.
WARNING!
If the doors are locked while driving, this  may hinder rapid access to the occupants of the vehicle in the event of an
accident. (Also see information on "Child  safety locks")
NOTE:  To help prevent accidentally locking the keys in the vehicle, the central locking system is designed to unlock
the doors immediately if the key  is left in the ignition switch, the vehicle is locked using the lock button on the door
and  the door is then closed. A sound from  the lock will be  audible  at this  time.
Please note that this  function will  not unlock the doors if the engine is running.
Immobilizer (start inhibitor)
Each of the keys supplied with your vehicle contains a  coded transmitter. The code in the key  is transmitted to an
antenna in the ignition switch where  it is compared  to the code stored  in the start inhibitor  module. The vehicle will
start only with a  properly coded key.
Each key  has a  unique code, which  your Volvo retailer uses if new keys are required. A maximum of six remote
controls/keys can be  programmed and  used for one  vehicle. If you misplace a  key,  take the other keys to an  authorized
Volvo retailer for reprogramming as an  antitheft measure.
NOTE:  This device complies with part 15 of the FCC rules.  Operation is subject to the following condition: (1) This
device may not cause harmful interference, and  (2) this  device must  accept any  interference received,  including
interference that may cause undesired operation.
pg. 97 Locks and alarm
Remote control
Your vehicle is equipped with two coded remote control transmitters with integrated ignition keys called Key
Integrated Remote (KIR). These transmitters use a  radio frequency that will enable you to lock/unlock all doors and  the
trunk from  a  distance of 10- 15 feet (3-5 meters).
The transmitters will also activate or allow "keyless"  entry into the passenger  compartment or the trunk. They will also
activate or deactivate your vehicle's alarm system(s). The vehicle can also be  locked/  unlocked with the key.
If one  of the transmitters is misplaced, contact your nearest authorized Volvo retailer for replacement.
ProCarManuals.com