SRS-44
FRONT PASSENGER AIR BAG MODULE
Revision: 2006 November2007 350Z
FRONT PASSENGER AIR BAG MODULEPFP:K8515
Removal and InstallationNHS0000V
REMOVAL
CAUTION:
Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait at least
3 minutes.
Always work from the side of or under front passenger air bag module.
Do not use air tools or electric tools for servicing.
1. Remove cluster lid C. Refer to IP-14, "
(Q) Cluster Lid C" .
2. Remove instrument passenger panel lower and knee protector (RH). Refer to IP-13, "
(L) Instrument Pas-
senger Panel Lower" .
3. Disconnect passenger air bag module connector.
4. Remove hexagon bolt, and then remove instrument passenger
panel upper assembly.
5. Remove fixing nuts, and then remove front passenger air bag
module.
CAUTION:
Always place front passenger air bag module with caution label side facing upward.
Do not insert any foreign objects (screwdriver, etc.) into front passenger air bag module.
Do not disassemble front passenger air bag module.
Do not use old bolts after removal; replace with new bolts.
Replace front passenger air bag module if it has been
dropped or sustained an impact.
Do not expose the front passenger air bag module to tem-
peratures exceeding 90°C (194°F).
Do not allow oil, grease or water to come in contact with the
front passenger air bag module.
After front passenger air bag module inflates, the instru-
ment panel assembly should be replaced.Passenger air bag module connector : (1)
PHIA1247E
PHIA1248E
SBF814E
