RF-90
SOFT TOP
Revision: 2006 November2007 350Z
Removal and Installation of Soft Top CoverNIS0007S
REMOVAL
CAUTION:
Do not reuse used double-faced adhesive tape, nonwoven fabric, EPT seal, pad, etc.
Be careful not to damage soft top assembly during removal. Do not place it upside-down so as to
prevent cover from compression scars.
1. Remove soft top assembly from the vehicle. Refer to RF-88, "
Removal and Installation of Soft Top Assem-
bly" .
2. Set up the soft top assembly on the table.
3. Remove roof actuator (RH/LH). Refer to RF-108, "
Removal and Installation of Roof Actuator" .
4. Remove holder of 5th bow operation strut rods, and then
remove 5th bow operation strut rods.
CAUTION:
When 5th bow operating strut rods are removed, 5th bow
drops suddenly.
Perform operation while holding 5th bow.
Temporarily fix 5th bow operating strut rods on 5th bow
finisher after removal.
PIIB1283E
PIIB1285E
PIIB1284E
