2007 Lancia Musa check oil

40
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
INITIAL CHECK
Turning the ignition key to MAR, the multifunction display shows the message “Checking”: the diagnostic
phase of all the electronic systems on the car has started. This lasts few seconds: if no faults are detected, when
the engine has started, the display shows the “Check OK” message.
See section “Warning lights and messages” if faults are found.
Is the
engine
started?YES
If no failures are
present
The “Service schedule” includes vehicle maintenance every 20,000 km (or 12,000 mi) or every year; this is shown automatically,
with the ignition key at MAR, starting from 2,000 km (or 1,240 mi) or 30 days from this deadline and it is shown again every 200
km (or 124 mi) or 3 days. For 1.3 Multijet versions, see “Care and Maintenance” in section “Service schedule to change engine oil
and filter and air cleaner. When a programmed maintenance interval (coupon) is near to come, turning the ignition key to MAR, will
display the message “Service” followed by the number of km, or days to go before car servicing. “Scheduled servicing” message is
displayed in km, miles or days according to the approaching service interval. Contact a Lancia Dealership to carry out any service
operation provided by the “Service schedule” or “Annual inspection plan”, and to reset the display.
If the display shows a failure
message, see details in section
“Warning lights and messages”.
Standard
screen display or
NO

130
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
TAILGATE CLOSING
First lower the tailgate using the appropriate handles, as shown in the
figure, and then push the tailgate until it clicks into place.
IMPORTANT If option “Independent boot” is on, before closing the
boot check whether you have with you the ignition key since the boot
will be locked automatically.
L0D0105m
The addition of objects (speakers, spoilers, etc.) on the rear shelf or boot lid, except those
envisaged by the manufacturer, may prevent the gas filled struts at the sides of the boot from
working properly.
WARNING
WARNING
When using the boot, make sure the loads do not exceed the permitted weight (see
“Technical specifications” chapter). Also make sure the items in the boot are
arranged properly to prevent them being thrown forwards and injuring
passengers should you brake sharply.
Never travel with objects on the rear shelf to prevent them being thrown forwards
and injuring passengers in case of accident or sharp braking.

247
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
❒flashing- indicates the possibility of damage to the catalyst (see
“EOBD system” in section “Dashboard and controls”).
If the light flashes, it is necessary to release the accelerator pedal to
lower the speed of the engine until the warning light stops flashing;
continue the journey at moderate speed, trying to avoid driving
conditions that may cause further flashing and contact Lancia
Dealership as soon as possible.U
amber
amber
8:30
continued from previous page
If with ignition key at MAR, the
Uwarning light does not turn on or if it turns on with fixed light
or flashing when the car is travelling (on certain versions together with the message on the display),
contact Lancia Dealership as soon as possible. Warning light
Uoperation can by checked by traf-
fic agents by proper equipment therefore, comply with laws and regulations in force in the country
where you are driving.
GENERIC FAILURE INDICATION
The warning light on the dial comes on when the engine oil pressure
sensor is faulty and, for Multijet versions with modal instrument
panel, also when a failure is detected in diesel fuel sensor. Contact
Lancia Dealership as soon as possible.
è
Warning
light on
dial Message on
multifunction
display

293
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
Thousands of km
Check and adjust handbrake lever stroke
Check exhaust emissions/smoke
(1.3 Multijet and 1.9 Multijet versions)
Check exhaust emissions (petrol versions)
Check antievaporation system (petrol versions)
Change fuel filter cartridge (“green filter”) (diesel versions)
Change air cleaner cartridge (petrol versions)
Change air cleaner cartridge (1.9 Multijet versions) (❏)
Top up fluids
(engine coolant, brakes, windscreen washer, battery, DFN etc.)
Check timing belt conditions (■)
Replace timing belt (*) (■)
Change spark plugs (petrol versions)
Check engine control system operation
(through diagnosis socket)
Change engine oil and oil filter (❏)
Change engine oil and oil filter (Multijet version with DPF) (**)
Change brake fluid (or every 2 years)
Change pollen filter (or every year)
(*) Or every 4 years for particularly demanding use:
- cold/hot climates;
- driving in the city idling for a long time;
- dusty roads or roads covered with sand and/or salt
Or every 5 years, regardless of the km covered and conditions of use.
(**) Engine oil and oil filter shall be changed when the corresponding warning light turns on (see section “Warning lights and Messages”),
or in any case every 2 years.
(
❏) Every 30.000 km for 1.3 Multijet versions
(
■) Excluding 1.3 Multijet versions
20 40 60 80 100 120 140 160 180
●● ● ●
●● ● ●
●● ● ●
●●
●●●
●●●
●●●●● ●●●●
●●●●● ●●●●
●●
●
●● ● ●
●● ● ●
●●●●● ●●●●
(●)(●)(●)(●)(●)(●)(●)(●)(●)
●●●
●●●●● ●●●●

ANNUAL INSPECTION SCHEDULE
For cars with an annual mileage of below 20,000
km (for example about 15,000 km) the following
yearly inspection programme is provided:
❒check tyre conditions/wear and adjust pressure if
required (including the spare wheel);
❒check lighting system operation (headlights,
direction indicators, hazard lights, boot lights,
passenger compartment lights, warning lights,
etc.);
❒check windscreen/washer
(nozzles/and blade position regulation)
❒check front disk brake pad conditions and wear;
❒sight inspect the conditions of: engine, gearbox,
transmission, pipes and hoses (exhaust - fuel -
brakes), rubber parts (boots, sleeves, bushes, etc;
❒check for bonnet and boot lock cleanness, lever
cleanness and lubrication;
❒check battery charge;
❒visual check on various drive belt conditions;
❒top up fluid levels (engine coolant, brakes,
windscreen washer, battery, etc.);
❒change engine oil;
❒change engine oil filter;
❒replace pollen filter (where provided).
ADDITIONAL CHECKS
Every 1,000 km or before long journeys, check and
top up if required:
❒engine coolant fluid level;
❒brake fluid level;
❒windscreen washer fluid level;
❒tyre pressure and conditions.
Every 3,000 km check and top up if required:
engine oil level.
You are recommended to use FL Selenia products,
designed and produced specifically for Lancia cars
(see table “Capacities” in section “Technical
specifications”).
294
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE

297
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
CHECKING FLUID
LEVELS
IMPORTANT When topping up
take care not to confuse the
various types of fluids: they are
all incompatible with one
another and could seriously
damage the car.
IMPORTANT Never smoke
while working in the engine
compartment: gas and
inflammable vapours may be
present, with the risk of fire.
L0D0206m
L0D0259m
1.416Vversions
1.48Vversions (where provided)
1 Engine coolant - 2 Engine
oil- 3 Brake fluid - 4 Battery -
5 Windscreen/rear window

ENGINE OIL
Checking engine oil
Check the oil level a few minutes (about 5) after the engine has
stopped, with the car parked on level ground.
Check that the level is within the MIN and MAX marks on the
dipstick. The interval between the MIN and MAX marks corresponds
to about one litre of oil.
Topping up engine oil
If the oil level is near or even below the MIN mark, add oil through
the filler neck, until reaching the MAX mark. Oil level shall never
exceed the MAX mark.
IMPORTANT If a routine check reveals that the oil level is above the
MAX mark, contact Lancia Dealership to have the correct level
restored.
IMPORTANT After adding or changing the oil, let the engine turn
over for a few seconds and wait a few minutes after turning it off
before you check the level.
299
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
L0D0208m
L0D0209mL0D0326m
1.416Vversions
1.3 Multijet versions 1.9 Multijet versions
L0D0258m1.48Vversions
(where provided)

ENGINE COOLANT FLUID
The coolant level shall be checked with cold engine and shall be
included between the MIN and MAX mark on the reservoir.
If the level is low, pour slowly a mixture of 50% distilled water and
50% FL Selenia PARAFLU UP through the filler neck.
A 50-50 mixture of PARAFLU UP and distilled water gives freeze
protection to –35°C.
IMPORTANT Do not remove the reservoir cap when the engine is hot:
you risk scalding yourself.
301
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
L0D0210m
L0D0211m
1.48V(where provided)-
1.416Vversions
1.3 and 1.9 Multijet versions
DUAL FUNCTION SYSTEM GEARBOX HYDRAULIC
SYSTEM OIL
To have the oil level checked contact Lancia Dealership only.
WARNING
The cooling system uses PARAFLU UP antifreeze. Do not add fluid having
different specifications from that already existing. PARAFLU UP cannot be mixed
with other types of fluids. Should other fluids be added, do not start the engine
and contact Lancia Dealership as soon as possible.
The cooling system is pressurised. If necessary, replace the cap only with another
genuine one, otherwise system efficiency could be compromised.
WARNING