2007 Lancia Musa coolant

26
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
INSTRUMENT PANEL
Modal
A – Speedometer
B – Fuel gauge with
reserve warning light
C – Engine coolant temperature
gauge with high
temperature warning light
D – Rev counter
E – Multifunction display
cmWarning lights fitted on Multijet ver-
sions only
Comfort
A – Speedometer
B – Fuel gauge with
reserve warning light
C – Engine coolant temperature
gauge with high
temperature warning light
D – Rev counter
E – Reconfigurable multifunction
display
cmWarning lights fitted on Multijet ver-
sions onlyL0D0010m
L0D0372m

ENGINE COOLANT TEMPERATURE GAUGE
The turning on of the warning light A indicates that the coolant fluid
temperature is too high; in this case, stop the engine and contact a
Lancia Dealership.
This shows the temperature of the engine coolant fluid and begins
working when the fluid temperature exceeds approx. 50°C.
Under normal conditions, the needle should hover around the middle
of the scale according to the working conditions.
IMPORTANT If the needle reaches the low temperature area with
warning light A on, this means that there is a failure. Contact a
Lancia Dealership.
28
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
If the needle reaches the red area, stop the engine immediately and contact a Lancia Dealership.
L0D0024m

91
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
CONTROLS
Air temperature
adjustment knobs H-N
Turning the knobs
clockwise or
counterclockwise,
highers or lowers the temperature of the air
required respectively in the left zone (knob N) or
right zone (knob H) of the passenger compartment.
It is possible to personalise required temperatures
(driver and passenger) with a maximum difference
of 7 °C.
The temperatures set are shown on the displays
near the relevant knobs.
Pressing button A (MONO) automatically aligns the
temperature on the front passenger’s side with that
on the driver’s side. It is therefore possible to set the
same temperature between the two zones simply
turning the knob on the driver’s side N.
This function is provided to simplify temperature
adjustment of the whole passenger compartment
when only the driver is on board.
Separate operation of the set temperatures is
automatically restored by turning knobs H or
pressing button A (MONO) again when the button
led is on.Turning the knobs clockwise or counterclockwise
until they reach the extreme selections HI or LO,
the maximum heating or cooling functions are
respectively engaged:
❒HI function (highest heating power):
this is activated by turning the temperature knob
clockwise above the max. value (32 °C). It can be
activated independently from the driver’s or
passenger’s side or both (also selecting the MONO
function).
This function can be engaged when requiring to
heat the passenger compartment as quickly as
possible, exploiting the maximum potential of the
system. This function uses the maximum
temperature of the coolant fluid, while air
distribution and fan speed are controlled according
to the system settings.
More particularly, max. fan speed will not be
immediately engaged if coolant is not hot enough;
this to prevent admitting air that is not warm
enough to the passenger compartment.
All manual settings are however possible with this
function on.

97
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
Button for fast windscreen and
front side window
demisting/defrosting F
Press this button: the climate control
system will automatically switch on
all the functions required for fast windscreen and
front side window demisting/defrosting, that is:
❒climate control system compressor on (with
proper climatic conditions);
❒air recirculation off;
❒maximum air temperature HI on both areas;
❒fan speed according to engine coolant
temperature in order to limit letting cold air into
the passenger compartment for demisting the
windows;
❒air flow directed to the windscreen and front side
window vents;
❒heated rear windowIMPORTANT The fast windscreen
demisting/defrosting function stays on for approx.
3 minutes after the engine coolant temperature
exceeds 50°C (petrol versions) or 35°C
(Multijet versions).
When the max. demisting/defrosting function is on,
the led on the relevant button and that on the
heated rear window button turn on. Message FULL
AUTO on the display will turn off.
When the max. demisting/defrosting function is on,
the only manual operations possible are manual
adjustment of the fan and switching rear window
heating off.
Press button F or air recirculation button C or
compressor button B or AUTO buttons N o H to
reset the previous system operation conditions.

HOW TO WARM UP THE ENGINE AFTER IT
HAS JUST STARTED (petrol and Multijet versions)
Proceed as follows:
❒Drive off slowly, letting the engine turn at
medium revs. Do not accelerate abruptly;
❒Do not drive at full performance for the initial
kilometres. Wait until the coolant temperature
gauge starts moving.
EMERGENCY START-UP
If the instrument panel warning light
Ystays on
with fixed light, the emergency start-up can be
performed by using the CODE card code
(see section “In an emergency”).STOPPING THE ENGINE
Turn the ignition to STOP while the engine is idling.
IMPORTANT After a taxing drive, you should allow
the engine to “catch its breath” before turning it off
by letting it idle to allow the temperature in the
engine compartment to fall.
186
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
Never bump start the engine by pushing, towing or coasting downhill. This could cause fuel to
flow into the catalytic exhaust system and damage it beyond repair.
A quick burst on the accelerator before turning off the engine serves absolutely no practical
purpose, it wastes fuel and is damaging especially to turbocharged engines.
Remember that the servobrake and power steering are not operational until the
engine has been started, therefore much effort than usual is required on the brake
pedal and steering wheel.
WARNING

209
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
WARNING LIGHTS AND MESSAGES
GEAR NOT AVAILABLE ....................................... 228
MANOEUVRE NOT ENABLED ............................ 229
PRESS BRAKE PEDAL – REPEAT
MANOEUVRE ....................................................... 230
ENGAGE N ........................................................... 231
REAR FOGLIGHTS .............................................. 232
FRONT FOG LIGHTS ........................................... 232
LEFT-HAND DIRECTION INDICATOR ................ 232
RIGHT-HAND DIRECTION INDICATOR .............. 232
SIDELIGHTS AND LOW BEAMS ......................... 233
FOLLOW ME HOME ............................................ 233
MAIN BEAM HEADLIGHTS ................................. 233
CRUISE CONTROL .............................................. 234
POSSIBLE PRESENCE OF ICE ON THE ROAD .. 234
FUEL CUTOFF
SWITCHED ON .................................................... 235
CAR PROTECTION SYSTEM FAILURE -
LANCIA CODE ..................................................... 236
“DUALDRIVE” ELECTRIC POWER
STEERING FAILURE............................................ 237
DIESEL FUEL FILTER SENSOR FAILURE ......... 237
GLOW PLUG WARMING FAILURE...................... 237
ABS SYSTEM FAILURE - SYSTEM
UNAVAILABLE ..................................................... 238
RAIN SENSOR FAILURE ...................................... 238 GENERAL WARNINGS ......................................... 211
LOW BRAKE FLUID............................................. 212
HANDBRAKE ON ................................................. 212
FRONT PASSENGER AIR BAG DEACTIVATED... 213
SEAT BELTS NOT FASTENED............................. 213
LOW BATTERY CHARGE .................................... 214
LOW ENGINE OIL PRESSURE ............................ 214
ENGINE COOLANT FLUID HIGH
TEMPERATURE ................................................... 215
INCOMPLETE DOOR LOCKING .......................... 217
“DUALDRIVE” ELECTRIC POWER
STEERING SYSTEM ............................................ 217
SPEED LIMIT EXCEEDED ................................. 218
FUEL RESERVE ................................................... 218
WATER IN DIESEL FUEL FILTER ...................... 219
GLOW PLUGS ...................................................... 220
ASR - WHEEL ANTISKID SYSTEM ..................... 220
BRAKE PAD WEAR ............................................. 220
LOW TYRE PRESSURE ...................................... 221
GLOW FLAT TYRE ............................................. 222
REDUCE GEARS .................................................. 224
MANUAL MODE NOT AVAILABLE...................... 224
AUTOMATIC MODE NOT AVAILABLE ................ 225
CLUTCH OVERHEATING .................................... 226
PRESS BRAKE PEDAL – DELAYED STARTING ... 227

215
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
ENGINE COOLANT FLUID HIGH TEMPERATURE
Turning the ignition key to MAR the warning light on the dial turns
on, but it should go off after few seconds.
The warning light turns on (together with the message on the display)
when the engine is overheated. If the warning light comes on when
driving, proceed as follows:
❒normal driving conditions: stop the car, switch off the engine and
check whether the water level in the reservoir is not below the MIN
mark. Otherwise wait for few seconds to allow engine cooling, then
open slowly and carefully the cap, top up coolant and check
whether its level is falling between MIN and MAX marks in the
reservoir. Check visually any leak. If when restarting the warning
light comes on again, contact a Lancia Dealership;
ç
continues on next page
red
Warning
light on
dial Message on
multifunction
display

216
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
Warning
light on
dialMessage on
multifunction
display
❒car heavy duty(e.g.: towing trailer uphill or fully laden car):
decrease speed, if the warning light stays on, stop the car. Wait for
2 or 3 minutes leaving the engine on and slightly accelerated to
further activate the circulation of the coolant fluid, then switch the
engine off. Check proper coolant level as described previously.
IMPORTANT Under severe use of the car, keep the engine on and
slightly accelerated for few minutes before switching it off.ç
continued from previous page
red