2007 FIAT PANDA Radio CD Tape Manual

64
RADIO WITH
COMPACT DISC AND MP3 CD PLAYER
RADIO WITH
TAPES PLAYER
RADIO WITH
COMPACT DISC PLAYER
Selecting Radio/Compact Disc/CD Changer
Pressing briefly and repeatedly button
1 (SOURCE-SCAN) it is possible to select the
following functions in sequence:
❒TUNER (Radio);
❒CD (Compact Disc) (only if the Compact Disc is
inserted);
❒CHANGER (CD Changer) (only if the CD Changer
is connected).
After each change of the listening source, the display
shows the function selected: TUNER, CD or
CHANGER for about 2.5 seconds. The set will then
start playing. FUNCTIONS AND ADJUSTMENTS
Switching on
The set is switched on pressing the button/knob 18
(VOLUME ON/OFF).
If the radio is turned on with the ignition key at STOP,
it will turn off automatically after about 20 minutes. It
is however possible to turn the radio on again for
other 20 minutes by pressing the button/knob 18
(VOLUME ON/OFF).
The radio will keep the same previous settings, except
for the volume level which, if set to over 20, will
anyway be brought to 20.
Turning the radio off
Keep button/knob 18 (VOLUME ON/OFF) pressed.
051-098 ING 21-06-2007 15:49 Pagina 64

65
RADIO WITH
COMPACT DISC AND MP3 CD PLAYER
RADIO WITH
TAPES PLAYER
RADIO WITH
COMPACT DISC PLAYER
The functions that cannot be selected (e.g.: “CD”
when the compact disc is not inserted) are
automatically disabled. If CD is not inserted or the CD
Changer is not connected, pressing button 1
(SOURCE-SCAN) the display shows the message “NO
SOURCE AVAILABLE” for about 2.5 seconds; then
the radio will set automatically to “TUNER” (Radio).
Pause function
If while listening to a Compact Disc another function is
selected (e.g.: the radio), playing is stopped and when
the Compact Disc mode is resumed, it starts again
from the point in which it was stopped.
If while listening to the radio another function is
selected, when the Radio mode is resumed, it is tuned
to the last station selected.Volume adjustment
Volume level can be adjusted from min. (“VOLUME
0”) to max. (“VOLUME 66”).
Adjust volume through button/knob 18 (VOLUME
ON/OFF).
Turn the knob rightwards to increase volume and
leftwards to decrease it. Set volume is displayed for
about 4 seconds (e.g.: “VOLUME 23”).
If the volume level is changed during the broadcast of a
traffic bulletin or during use of the phone (if the voice
feature is installed), the new setting is maintained only
until the end of the bulletin or phone call.
Volume can be also adjusted during manual/automatic
tuning, AutoSTore, radio station scan or CD Changer
mode.
051-098 ING 21-06-2007 15:49 Pagina 65

66
RADIO WITH
COMPACT DISC AND MP3 CD PLAYER
RADIO WITH
TAPES PLAYER
RADIO WITH
COMPACT DISC PLAYER
SVC function
(volume changing with speed)
The SVC function makes it possible to automatically
adapt the volume level to the speed of the car,
increasing it as the speed increases to maintain the
ratio with the noise level in the passenger
compartment.
To activate the SVC function briefly press button 11
(MENU-PRESET SCAN), then use buttons 6 (
N) or
(
O) to scroll the menu stopping on the SVC function
and buttons 5 (
÷) or (˜) to switch the function
on or off selecting respectively “SVC SETTING ON”
or “SVC SETTING OFF”.
This function can be turned on or off in all the
operating modes of the device (Radio/Compact
Disc/CD Changer).
After about 4 seconds from the last adjustment the
display returns to the main radio screen.Mute function
(turning off the volume completely)
To switch on the Mute function, briefly press the
button/knob 18 (VOLUME ON/OFF). Volume will
gradually lower (Soft Mute function) and the display
will show the word “MUTE”.
To switch off the Mute function, briefly press the
button/knob 18 (VOLUME ON/OFF). Volume will
gradually become louder (Soft Mute function)
returning to the value set before switching on the
Mute function.
With the Mute function on:
❒all the other functions can be used;
❒turning the button/knob 18 (VOLUME ON/OFF)
the volume can be directly adjusted;
❒if an emergency alarm or a traffic bulletin arrives
with the TA function on, the message ignores the
Mute function;
❒an incoming call ignores the Mute function. The
Mute function will be resumed at the end of the call;
❒if with TA function on, the radio does not broadcast
traffic info, a warning beep will sound.
051-098 ING 21-06-2007 15:49 Pagina 66

67
RADIO WITH
COMPACT DISC AND MP3 CD PLAYER
RADIO WITH
TAPES PLAYER
RADIO WITH
COMPACT DISC PLAYER
Soft Mute function
When the Mute function is turned on or off, the
volume lowers or increases gradually (Soft Mute
function). The Soft Mute function is also activated
when one of the six preselection buttons, the 12
button (BAND-AUTOSTORE) or the 18 button
(ON/OFF VOLUME) is pressed.
Tone adjustment (bass/treble)
Proceed as follows:
❒briefly and repeatedly press the 8 (AUDIO-
LOUDNESS) button until the display shows “BASS”
or “TREBLE”;
❒press 6 (
N) or (O) to increase/decrease the basses
or trebles.
Pressing the buttons briefly the change is gradual by
steps. Pressing longer, changing is faster.
The bass/treble levels (–6 to +6) will appear on the
display for approximately 4 seconds.
After about 4 seconds from the last adjustment the
display returns to the main radio screen.Balance adjustment
Proceed as follows:
❒briefly and repeatedly press the 8 (AUDIO-
LOUDNESS) button until the display shows
“BALANCE” (select Balance function);
❒press button 6 (
N) to increase the sound from the
right speakers or button 6 (
O) to increase the
sound from the left speakers.
Pressing the buttons briefly the change is gradual by
steps. Pressing longer, changing is faster. For few
seconds the display shows the levels of balancing from
RIGHT+9 to LEFT+9 (RIGHT =right speakers, LEFT
= left speakers).
Fader adjustment
Proceed as follows:
❒briefly and repeatedly press the 8 (AUDIO-
LOUDNESS) button until the display shows
“FADER” (select Fader function);
❒press button 6 (
N) to increase the sound from the
rear speakers or button 6 (
O) to increase the
sound from the front speakers.
051-098 ING 21-06-2007 15:49 Pagina 67

68
RADIO WITH
COMPACT DISC AND MP3 CD PLAYER
RADIO WITH
TAPES PLAYER
RADIO WITH
COMPACT DISC PLAYER
Pressing the buttons briefly the change is gradual by
steps. Pressing longer, changing is faster. For few
seconds the display shows the levels of fader from
REAR+9 to FRONT+9 (REAR = rear speakers,
FRONT = front speakers).
Select “CENTER” to set at the same value the front
and rear outputs.
NOTE Audio adjustments (Bass, Treble, Fader,
Balance) will deactivate in the following cases (after
having performed the required adjustments, values will
be stored):
❒after about 4 seconds from last adjustment;
❒pressing button 8 (AUDIO LOUDNESS) again;
❒adjusting or deactivating a function requiring info
display;
❒activating a new function (e.g.: TA, Tel Mute or
inserting a CD).
IMPORTANT On versions not fitted with rear
speakers, the Fader function shall be set to “F” (front)
to avoid sound system output power reduction and
volume muting if Fader is set to = R+9.Loudness function
The Loudness function improves the sound volume
when listening at low level, increasing the basses and
trebles. It is cut off when the volume is set to
maximum.
To switch the function on/off, keep button 8 (AUDIO-
LOUDNESS) pressed until hearing the “beep”. The
function condition (on or off) is shown on the display
for few seconds by “LOUDNESS ON” or
“LOUDNESS OFF”.
TELEPHONE PROVISION
(where provided)
If the vehicle is equipped with a free-hands kit, the car
radio volume control is connected, when a telephone
call is received, to the telephone input, thus preventing
listening to the tuned station or the CD. The
telephone sound is always received to a set volume;
yet, it can be adjusted during conversation, by means
of button/knob 18 (VOLUME ON/OFF).
The fixed telephone volume can be adjusted through
the “PHONE” function of the menu (see paragraph
“MENU”).
051-098 ING 21-06-2007 15:49 Pagina 68

69
RADIO WITH
COMPACT DISC AND MP3 CD PLAYER
RADIO WITH
TAPES PLAYER
RADIO WITH
COMPACT DISC PLAYER
The only buttons active during phone calls are:
❒18 (VOLUME ON/OFF): radio
on/off and volume adjustment;
❒14 (AF-TA): traffic information.
While the sound is off for a phone call, the display
shows the word “PHONE”.
During a telephone call, all functions, except for
AutoSTore and Search (operating mode selection) are
disabled.
The sound of the phone call will be interrupted in the
case of transmission of a traffic bulletin or a PTY31
announcement; if wishing to interrupt the bulletin
press button 14 (AF-TA).
With sound system on and engine off (ignition key to
STOP), the sound system will not turn off during a
phone call but it will turn off automatically at the end
of the conversation.RADIO (Tuner)
When the set is turned on the last function selected
before turning off is played (Radio, Compact Disc or
CD Changer).
To select the Radio source while listening to a
Compact Disc, press briefly and repeatedly button 1
(SOURCE-SCAN) until this function is selected.
When Tuner is on, the display will show the selected
station name (RDS stations only) or frequency, the
frequency band (e.g.: FM1) and the preselection button
number (e.g.: P1 = station stored on button 1).
051-098 ING 21-06-2007 15:49 Pagina 69

70
RADIO WITH
COMPACT DISC AND MP3 CD PLAYER
RADIO WITH
TAPES PLAYER
RADIO WITH
COMPACT DISC PLAYER
Selecting the frequency band
If in the Radio mode, briefly and repeatedly press
button 12 (BAND-AUTOSTORE) to select the
required reception band.
Every time the button is pressed the following bands
are selected in sequence “FM1”, “FM2”, “FMT”,“MW”
and “LW” shown by the respective wording on the
display.
The last station selected in the respective frequency
band will be tuned specially if the station is not stored
on the presetting buttons.
If selected station is stored on one of the presetting
buttons, the display will show the presetting number
for few seconds; then the display will show again the
station frequency.
The FM band is divided into sections: FM1, FM2 and
FMT. The FMT reception band is reserved to the
stations stored automatically with the AutoSTore
function.
The radio is always ready to receive stations in the
RDS mode (Radio Data System).Presetting buttons
The buttons with symbols from 1 to 6 (“16”, “15”,
“13”, “10”, “7”, “9”) make it possible to set the
following presettings:
❒18 in the FM band (6 in FM1, 6 in FM2, 6 in FMT);
❒6 in the MW band;
❒6 in the LW band;
❒6 types of PTY programming (only in the FM mode
when PTY is selected).
To call a preset station, choose the required frequency
band and then press briefly the corresponding preset
button (from 1 to 6). For a few seconds the display
will show the number of the station preset and the
related frequency before showing the frequency band
and the name of the RDS station.
If the PI code (Program Index) can no longer receive at
the frequency allocated to a preset button, the radio
will start searching this PI on another frequency as
soon as the car leaves the area covered by the
previous frequency. The display will show “SEARCH”.
051-098 ING 21-06-2007 15:49 Pagina 70

71
RADIO WITH
COMPACT DISC AND MP3 CD PLAYER
RADIO WITH
TAPES PLAYER
RADIO WITH
COMPACT DISC PLAYER
Should it be not possible to receive the PI stored on a
frequency after searching along the whole band, the
radio will tune to the stored frequency.
Pressing the respective preset button for longer than 2
seconds will store the tuned station (the sound system
will always store the frequency and the PI code).
Storing is confirmed by a beep.
Storing the last station heard
The radio automatically keeps in storage the last
station heard for each reception band, which is then
tuned when the radio is turned on or the reception
band is changed.
Automatic tuning
Briefly press button 6 (
N) or (O) to start
automatically searching the tuning for the next station
that it is possible to receive in the direction chosen.
If button 6 (
N) or (O) is pressed for longer, quick
searching takes place: upon having tuned in to the first
well receivable station, the tuner stops for about 1
second (in Mute) before quick searching continues.
When the button is released, the tuner stops on the
next receivable station.If the TA function is on (traffic information), the tuner
only searches stations which broadcast traffic bulletins.
If the PTY function is on, the tuner only searches PTY
stations. When searching, the display alternatively
shows the type of programme and the word “SEEK”.
If the station on which the tuner stops is one of the
stations stored with the preset buttons, the display will
show the presetting number for a few seconds.
Manual tuning
This allows manual station searching in the chosen
band.
Proceed as follows:
❒Select the band with button 12 (BAND-
AUTOSTORE): FM1, FM2, FMT, MW or LW;
❒Press briefly and repeatedly button 5 (
÷) or
(
˜) to start searching in the chosen band.
Pressing one of the buttons 5 (
÷) or (˜)
longer obtains fast forward searching, which is
stopped when the button is released.
To turn on manual tuning search it is necessary to turn
off the PTY and AF (alternative frequencies), if on.
If the station tuned is a station stored with the preset
buttons, the display will show the presetting number
for a few seconds.
051-098 ING 21-06-2007 15:49 Pagina 71