Page 51 of 314
50
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
INDEPENDENT BOOT UNLOCKING (Indep. Boot)
If (ON), when unlocking the door, the boot stays closed and therefore protected: to unlock the boot press button
Ron the key with remote control.
If (OFF), the boot is unlocked together with the doors.
The car is delivered with this function set to “OFF”.
R
Q
See “Initial check”
and “Access to
menu screen”
Menu screen
– + – +
Use buttons + or – to select
ON/OFF.
Set selection flashes.
R
Return to menu
screen Return to menu
screenReturn to previously
displayed
screen, e.g.:
Q Q
Q= Press “MODE” button for less than two seconds
R= Press “MODE” button for over two seconds
Q
Q
RR
Page 52 of 314
51
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
DRIVER’S DOOR UNLOCKING (Unlock. Fda.)
This function:
❒when activated (ON) enables to open just the driver’s door through remote control pulse
❒when deactivated (OFF) enables simultaneous door opening through remote control pulse.
The car is delivered with this function set to “OFF”.
R
Q
See “Initial check”
and “Access to
menu screen”
Menu screen
– + – +
Use buttons + or – to select
ON/OFF.
Set selection flashes.
R
Return to menu
screen Return to menu
screen
Q
Q
Return to previously
displayed
screen, e.g.:
Q= Press “MODE” button for less than two seconds
R= Press “MODE” button for over two seconds
Q
Q
RR
Page 69 of 314
WARNINGAny adjustment of the steering wheel position must be carried out only with the
car stationary and the engine turned off.
STEERING WHEEL ADJUSTMENT
The steering wheel can be adjusted both in height (A) and axially (B).
Proceed as follows:
❒release the lever pulling it towards the steering wheel (position 2);
❒adjust the steering wheel as required;
❒lock the lever pushing it forwards (position 1).
68
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
F0H0055m
WARNINGIt is absolutely forbidden to carry out whatever after-market operation involving
steering system or steering column modifications (e.g.: installation of anti-theft
device) that could badly affect performance and safety, cause the lapse of
warranty and result in car non-compliance with the regulations in force.
Page 70 of 314

69
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
F0H0041m
F0H0042m
SEAT ADJUSTMENT
FRONT SEATS
Moving the seat backwards or forwards
Lift the lever (A) and push the seat forwards or backwards: in the driving
position the arms should rest on the rim of the steering wheel.
Always check that the seat is firmly locked in the runners by trying to
move it back and forth.
Seat height adjustment (driver’s side) (where provided)
Move repeatedly lever (B) upwards or downwards to achieve the
required height.
IMPORTANT Adjustment must be carried out only seated in the driver’s
seat with the car at a standstill.
Back rest angle adjustment
Move lever (D) as shown by the arrow, set the back rest in the required
position, then release the lever.
Lumbar adjustment (where provided)
Turn knob (C) clockwise or counterclockwise to increase or decrease
lumbar adjustment.
After adjustments, always check that the seat is firmly locked in the runners.WARNING
Page 72 of 314
71
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
F0H0047m
REAR SLIDING SEAT
Adjustments from inside the car
Moving the seat backwards or forwards
Lift lever (A) or lever (B) respectively to adjust the required seat section,
then push the seat backwards or forwards.
Back rest angle adjustment
Use lever (C) to set the back rest as required then release the lever.
To prevent malfunctioning: always press lever (C) down completely.
REAR FIXED SEAT (where provided)
For tilting the seat, see paragraph “Boot extension”
F0H0252m
F0H0253m
Adjustments from the boot
Moving the seat backwards or forwards
Use handles (F) and (G) to adjust the required seat section, then push the
seat backwards or forwards.
WARNINGAfter adjustments, always check that the
seat is firmly locked in the runners.
Page 73 of 314

72
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
F0H0049m
Back rest angle adjustment
Use lever (A) or lever (B) to adjust the required back rest section, then
release the lever.
Central seat back rest adjustment from inside the car
To set the central seat back rest in horizontal position:
❒operate lever (D) (one per side)
❒lower the central seat back rest down completely
❒release the lever.
With central seat back rest completely lowered on the cushion and
relevant head restraint removed (as shown in the figure), it is possible to
use the glass holder (A) (where provided).
To bring the central back rest back to vertical position: use again lever
(D) (one per side) and set it in line with rear side seat backs, until the
securing clip (E) locks into place
F0H0051m
Once you have released the lever, check
that the seat is firmly locked in the
runners by trying to move it back and
forth. Failure to lock the seat in place
could result in the seat moving suddenly.
WARNING
F0H0050m
Page 74 of 314
73
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
For maximum safety, keep the back of your seat upright, lean back into it and
make sure the seat belt fits closely across your hips.WARNING
F0H0255m
Central seat back rest adjustment from the boot
Pull band (F) and push forward the top of the back rest at the same time
until releasing the locking clip. Bring the back rest to horizontal position
then, release band (F). Reverse this procedure to reset the back rest in
vertical position. Check for clip locking into place.
Page 77 of 314
76
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
HEAD RESTRAINTS
FRONT SEATS
Head restraints are adjustable in height.
To adjust the head restraint height: pull it upwards or press button (A)
and push it downwards. Make sure it is properly locked in place.
Head restraint removal
To extract the head restraint press button (B).
F0H0052m
F0H0237m
WARNING
If side-bags are fitted, the use of seat covers
not purchased at Lineaccessori Fiat is
dangerous. REAR SIDE AND CENTRAL HEAD RESTRAINTS (where
provided)
Head restraints are adjustable in height.
To raise the head restraints, move them upwards until the locking click is
heard.
Press button (C) to lower them.
Press button (D) to extract them (although this is not required for
normal configurations).
F0H0053m