2007 FIAT IDEA lock

191
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
W W
A A
R R
N N
I I
N N
G G
L L
I I
G G
H H
T T
S S
A A
N N
D D
M M
E E
S S
S S
A A
G G
E E
S S
FUEL CUTOFF SWITCHED ON...................................... 207
CAR PROTECTION SYSTEM FAILURE -
FIAT CODE ............................................................................ 208
“DUALDRIVE” ELECTRIC POWER
STEERING FAILURE............................................................. 209
DIESEL FUEL FILTER SENSOR FAILURE ........................ 209
GLOW PLUG WARMING FAILURE ............................... 209
ABS SYSTEM FAILURE - SYSTEM
UNAVAILABLE ...................................................................... 210
RAIN SENSOR FAILURE..................................................... 210
EBD SYSTEM FAILURE - SYSTEM UNAVAILABLE ...... 211
EXTERNAL LIGHT FAILURE............................................. 212
BRAKE LIGHT FUSE FAILURE .......................................... 214
PARKING SENSOR FAILURE ............................................ 215
ANTIPINCH SYSTEM
FAILURE .................................................................................. 215
AIR BAG FAILURE................................................................ 216
TWILIGHT SENSOR FAILURE.......................................... 217
INJECTION SYSTEM FAILURE ......................................... 217
ENGINE CONTROL SYSTEM FAILURE
(EOBD) .................................................................................... 218
GENERIC FAILURE INDICATION .................................. 219 GENERAL WARNINGS ...................................................... 192
LOW BRAKE FLUID ............................................................ 193
HANDBRAKE ON ............................................................... 193
FRONT PASSENGER AIR BAG DEACTIVATED ......... 194
SEAT BELTS NOT FASTENED ......................................... 194
LOW BATTERY CHARGE................................................. 195
LOW ENGINE OIL PRESSURE ......................................... 195
ENGINE COOLANT FLUID HIGH TEMPERATURE .. 196
INCOMPLETE DOOR LOCKING ................................... 198
“DUALDRIVE” ELECTRIC POWER STEERING
SYSTEM .................................................................................. 198
SPEED LIMIT EXCEEDED ................................................. 199
FUEL RESERVE....................................................................... 199
WATER IN DIESEL FUEL FILTER ..................................... 200
GLOW PLUGS ...................................................................... 201
REAR FOGLIGHTS............................................................... 202
FRONT FOG LIGHTS ......................................................... 202
LEFT-HAND DIRECTION INDICATOR ....................... 203
RIGHT-HAND DIRECTION INDICATOR ................... 203
SIDELIGHTS AND LOW BEAMS ..................................... 204
BRAKE PAD WEAR ........................................................... 204
FOLLOW ME HOME ........................................................... 205
MAIN BEAM HEADLIGHTS............................................... 205
CRUISE CONTROL ............................................................. 206
POSSIBLE PRESENCE OF ICE ON THE ROAD ........... 206

198
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
INCOMPLETE DOOR LOCKING
The warning light on the dial turns on (on certain
versions together with the message on the
display) when one or more doors, the boot or
the bonnet are not properly shut.
Symbols
¯/˙shown on the display indicate
incomplete left/right door closing.
´
(*) Or rear
red
green
Warning
light on dialMessage on reconfigurable
multifunction displayMessage on
multifunction display
(*)
“DUALDRIVE” ELECTRIC POWER
STEERING SYSTEM
On versions with modal instrument panel the
warning light turns on when the “dualdrive”
electric power steering is activated.
On versions with comfort instrument panel, the
message CITY is displayed on the reconfigurable
multifunction display when the “dualdrive”
electric power steering is activated.
X

211
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
EBD SYSTEM FAILURE - System
unavailable
The turning on at the same time of the xand
>warning lights on the dial (on certain versions
together with the message on the display) with
the engine running indicates that the EBD system
is inefficient or unavailable.
In this case heavy braking may cause the rear
wheels to lock before time, with the possibility of
skidding.
Drive with the utmost care to the nearest Fiat
Dealership to have the system checked.
x
+
>
red
amber
Warning
light on dial Message on
multifunction displayMessage on reconfigurable
multifunction display

221
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
DOOR OPENING/CLOSING
Emergency door locking device from outside
The doors are fitted with a device which makes it possible to close the
doors with the lock without power supply.
To close, proceed as follows:
❒insert the ignition key in the pawl (B)
❒turn the device to position 1 and close the ledge.
To open, proceed as follows:
❒insert the key in the pawl and turn it clockwise
❒open the driver’s door
❒from the vehicle inside open the remaining doors by operating the
levers located in the handles.
F0H0247m

229
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
It is of vital importance to communicate that the tyre has been repaired using the
quick tyre repair kit. Hand the instruction brochure to the personnel charged with
treating the tyre repaired with the kit.WARNING
❒if reaching the tyre pressure specified in paragraph “Inflation pressure”
in section “Technical Specifications”, start driving immediately;
❒after driving for about 10 minutes stop and check again the tyre pres-
sure; pull up the handbrake;
❒if at least 1.8 bar pressure is read, restore proper pressure (with engine
running and handbrake on) and restart;
❒drive with the utmost care to the nearest Fiat Dealership.
FOR CHECKING AND RESTORING PRESSURE ONLY
The compressor can be also used just for restoring pressure. Disconnect
the quick connection and connect it directly to the tyre valve; in this way the
cylinder is not connected to compressor and the sealing fluid will not flow
into the tyre.
CYLINDER REPLACEMENT PROCEDURE
To replace the cylinder proceed as follows:
❒disconnect connection A;
❒turn counter-clockwise the cylinder to replace and raise it;
❒fit the new cylinder and turn it clockwise;
❒connect connection Ato the cylinder and fit the transparent tube Bin-
to the proper space.
F0H0359m
F0H0360m

238
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
IMPORTANT The headlight inner surface may be lightly misted over: this
is not a fault but a natural fact due to low temperature and the level of
air humidity. It will disappear as soon the headlights are turned on. The
presence of drops inside the headlights means water infiltration,
therefore contact Fiat Dealership.
TYPES OF BULBS
Various types of bulbs are fitted to your car:
AGlass bulbs:clipped into position. Pull to remove.
BBayonet type bulbs:press the bulb, turn counterclockwise to
remove this type of bulb from its holder.
CTubular bulbs:free them from their contacts to remove.
D-EHalogen bulbs:to remove the bulb, release the clip holding the
bulb in place.
F0H0178m

241
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
MAIN BEAM HEADLIGHTS
To change the bulb, proceed as follows:
❒turn the cap (A) anticlockwise and remove it;
❒disconnect the electrical connector (B);
❒release the bulb catch (C);
❒remove the bulb (D) and change it;
❒refit the catch (C), connect the electrical connector (B) and fit the cap
(A) turning it clockwise. Put the cap ventilation outlet (H) from the
top downwards.
DIPPED BEAM HEADLIGHTS
To change the bulb, proceed as follows:
❒remove the protective cover releasing the relevant catch;
❒disconnect the electrical connector (F);
❒release the bulb catch (E);
❒remove the bulb (G) and change it;
❒fit a new bulb making the tabs of the metallic part coincide with the
grooves on the reflector, then hook the bulb holder catch (E) and re-
connect the electrical connector (F);
❒refit the protective cover correctly.
F0H0181m
C
B
D
F0H0214m
F0H0182m

242
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
F0H0183m
F0H0184m
DIRECTION INDICATORS
Front
To change the bulb, proceed as follows:
❒remove the protective cover releasing the relevant catch;
❒turn the bulb holder (A) counter-clockwise and remove it;
❒remove the bulb (B) lightly pushing it and turning it counter-clockwise
(“bayonet”);
❒replace the bulb;
❒refit the bulb holder turning it clockwise, checking that it is secured
correctly.
❒refit the protective cover correctly
Side
To change the bulb, proceed as follows:
❒lever in the point shown by the arrow to compress the catch and
remove the unit (C);
❒turn the bulb holder (D) counter-clockwise, remove the snap-fitted
bulb and change it;
❒refit the bulb holder (D) in the transparent cover, then position the
unit making sure the catch clicks into place.