Page 6 of 216
II
99
1
8
2
3
7
9
10
1617
465
11
14
13
12
15
1819
IN BRIEF
1. Head-up display cavity
2. Steering column adjustment
3. Controls - Lighting / Direction indicators / Rear foglamps /
Voice recognition
4. Instrument panel
5. Horn
6. Controls - Wipers
7. Front passenger's airbag deactivation
8. Driver's seat adjustment controls and memories
9. Controls - Windows / Rear view mirrors / Child safe ty
10. Driver's airbag
11. Controls at the steering wheel - Speed limiter and Cruise
control
12. Electric parking brake
13. Suspension controls - Ground clearance adjustment/
Sport mode
14. Automatic gearbox SPORT/SNOW mode controls
15. Head-up display controls
16. Oddments tray
17. F u e l fl a p c o n t r o l
18. Ignition switch
19. Controls - Radio controls under the steering wheel
D A S H B O A R D
Page 28 of 216
31
II
23
1
S E A T B E L T S W A R N I N G L A M P
OPERATION
The driver's and the front and rear passengers' seats have sensors that detect non-fastening/unfas-tening of the seat belts.
The fastened/non-fastened status of the seat belts for each type of seat is indicated by the illumination o r fl a s h i n g o f t h e w a r n i n g l a m p s 1, 2 and 3.
FUNCTIONING OF THE SYSTEM OF DETECTION
Driver's and front passenger's seats
When you switch on the ignition:If the driver's seat belt is not fastened, the warning lamp If1 illuminates in the instrument panel.If the passenger's seat belt is not fastened, the warning lamp If3 lights up.
A b o v e 2 0 k m / h ( 1 2 m p h ) , i f t h e s e a t b e l t i s u n f a s t e n e d t h e w a r n i n g l a m p fl a s h e s , a c c o m p a n i e d b y a m e s s a g e a n d a s o u n d s i g n a l f o r a r o u n d 2 m i n -utes. After that, warning lamps 1 and/or 3 remain on.
Rear passengers' seats
When you switch on the ignition, warning lamp 2 lights up to make the driver and any passengers aware.
Once the doors are closed and the engine started, a message tells you the fastening status of the rear belts for 30 seconds.
After this time, if one or more of the rear belts are not fastened:The warning lamp 2 comes on if your speed is less than approx. 20 km/h ( 1 2 m p h ) .The warning lamp 2 fl a s h e s , a c c o m p a n i e d b y a m e s s a g e a n d a s o u n d signal, for about two minutes if your speed is greater than around 20 km / h ( 1 2 m p h ) .Note:The detection of non-fastening of rear seat belts is deactivated when you switch off the ignition or if one of the vehicle's doors is opened.
A child seat installed on the front passenger's seat may not be detected.
Page 33 of 216
36
II
13
24
A
B
S P E E D L I M I T E R
SELECTION OF THE SPEED LIMITER
To select the speed limiter, press on button 1 to display in zone A of your instrument panel the symbol B for the speed limiter.
The last speed memorised is also displayed.
TO ADJUST THE MAXIMUM SPEED
Provided the engine is running, you can select your maximum speed, with short or long presses on:Button 3 to increase the speed or
Button 4 to decrease the speed.
Remark:
Successive presses will allow to modify the speed in steps of 1 km / h (1 m p h ) a n d a c o n t i n u o u s p r e s s i n s t e p s o f 5 k m / h ( 3 m p h ) .
ACTIVATION OF THE MAXIMUM SPEED
When the desired maximum speed is displayed, press button 2 to activate the speed limiter.
Page 34 of 216
37
II
S P E E D L I M I T E R
DEACTIVATION
To deactivate the maximum speed, press button 2.
The information “OFF” will appear in the instrument panel.
This action does not cancel the memorised speed, which remains displayed in the instrument panel.
TEMPORARY OVERRIDE OF THE MAXIMUM SPEED
The accelerator pedal has a switch at the end of its travel. By pressing the pedal hard down to activate this switch at any time you can go faster than the memorised maximum speed.
D u r i n g t h e t i m e t h e l i m i t s p e e d i s b e i n g e x c e e d e d , t h e d i s p l a y e d s p e e d fl a s h e s .
You have only to release the accelerator pedal to return belo w the maximum speed, to restore the function.Note: If during speed limitation the system cannot keep to the maximu m speed (especially on a steep descent or if y o u a c c e l e r a t e t o o h a r d ) , t h e s p e e d fl a s h e s . A d a p t y o u r s p e e d a s n e c e s s a r y .
The function will re-engage when your speed has returned below the desired maximum.
TO CANCEL THE FUNCTIONGive a long press on button 1.
Or stop the engine.Or
The speed that you chose is memorised. The information disappea rs from the instrument panel.
I f t h e r e i s a m a l f u n c t i o n , t h e m e m o r i s e d s p e e d w i l l fl a s h a n d t h e w a r n i n g l a m p “OFF” will come on permanently in the display.
Contact a CITROËN dealer.
Page 35 of 216
38
II
0
0
13
24
A
C
C R U I S E C O N T R O L
SELECTION OF CRUISE CONTROL
This driving assistance function allows you to drive at the speed of your choice without the need to action the accelerator.
Cruise control is available in the higher gears only, for speeds greater than 40 km/h (24 mph).Note: Information relating to the cruise control is displayed in zone A of your instrument panel.
To activate cruise control, press button 1 to display in zone Aof your instrument panel the symbol C for cruise control.
The cruise speed is then memorised. The cruise speed will be displayed in zone A in the instrument panel.
At the time you select the function, no cruise speed has yet been memorised.
TO SELECT A CRUISE SPEED
Accelerate to the desired speed, then give a short press on button 3 or button 4.
You can then release the accelerator pedal. The vehicle will automatically keep to that chosen speed.Note: The vehicle speed may vary slightly from that memorised.
Temporary override of the cruise speed
While cruise control is in operation, it is always possible to go above the cruise speed simply by pressing the accelerator pedal (for example to over- t a k e a n o t h e r v e h i c l e ) . T h e s p e e d d i s p l a y e d fl a s h e s . Y o u h a v e o n l y t o r e l e a s e the accelerator pedal to return to your cruise speed.Note: If during cruise control the system cannot keep to the cruise speed ( e . g . o n a s t e e p d e s c e n t ) , t h e n t h e s p e e d fl a s h e s . I f n e c e s s a r y , b r a k e t o curb your speed.
Page 36 of 216
39
II
C R U I S E C O N T R O L
These actions bring up the information “OFF” in the instrument panel.
Adjustment of the memorised speed while cruise control is in operation
To adjust the memorised speed, displayed in zone A, press:Button 3 to increase the speed or
Button 4 to decrease the speed.
Remark: Successive presses will allow to modify the s p e e d i n s t e p s o f 1 k m / h ( 1 m p h ) a n d a c o n t i n u o u s p r e s s i n s t e p s o f 5 k m / h ( 3 m p h ) .
Deactivation of cruise control with memo-rised speed
You can deactivate cruise control:Either by pressing the brake pedal or the clutch Eitherpedal.
Or by the OrESP or ASR systems being active.Or by pressing button Or2.Note: Cruise control is deactivated if the gear lever is in neutral (position N).
Page 45 of 216
48
IISTOP
STOP
0
STOP
STOP
49/54
ADBCA
STST
B
KJIHGFEB
KJIHGFEB
CAB
STST
DA
B
I N S T R U M E N T P A N E L
Remark: Certain types of screen may adversely affect the readability of t he instrument panel.
A Signalling warning lampsB Operational warning lampsC Cruise control/speed limiter informationD Fuel gaugeE Trip mileage recorderF Total mileage recorder, maintenance indicator
G Speed indicatorH Display of automatic gearbox informationI Display of suspension sport modeJ Rev counterK Reset button for trip mileage recorder and mainte-nance indicator
INSTRUMENT PANEL - PETROL VERSION
INSTRUMENT PANEL - DIESEL VERSION
Page 47 of 216
54
II
B
AC
D
NIGHT DRIVINGA fi r s t p r e s sA on the DARK button puts the display on standby. Only the time and the temperature remain displayed.
A second pressA switches off the display and the instrument panel, except for information concerning:
The speed indicator.The automatic gearbox.Cruise control / Speed limiter if this has been activated.Note:
Temporary l i g h t i n g o f t h e d i s p l a y f o r m o d i fi c a t i o n o f a u d i o - C D a d j u s t -emporaryments and air conditioning.The display lights up if any of the other buttons on the display is pressed. To revert to night driving, press just once on button DARK.DARKDARKAll the displays come on if there is an alert.AllA third pressA returns you to normal lighting.
