2007 CHEVROLET MONTE CARLO Owners Manual

Your vehicle has a power driver’s seat. The
control is located on the outboard side of the
seat cushion. To adjust the seat, do any of the
following:
Move the seat forward or rearward by sliding
the control forward or rearward.
Raise or lower the front part of the seat
cushion by moving the front of the control
up or down.
Raise or lower the rear part of the seat
cushion by moving the rear of the control
up or down.
Manual Lumbar
The driver’s seat has manual lumbar. The lever
is located on the outboard side of the seat near
the front of the seat cushion. Lift up on the
lever repeatedly to increase lumbar support.
Push down on the lever repeatedly to decrease
lumbar support.
Driver’s Seat with Manual Lumbar,
Power Seat Control, and Manual Recline shown
9

Heated Seats
If your vehicle has this
feature, the buttons that
control temperature for
the driver’s and front
passenger’s seats are
located on the climate
control panel. See
Climate Control System
on page 164.
Press the button once to warm the seat to a high
temperature. Both lights below the heated seat
symbol will come on. Press the button a
second time to reduce the seat to a lower
temperature. The bottom light will be lit. Press
the button a third time to turn the heated seat off.
The heated seat feature will need to be turned
on each time the ignition is turned off and back
on again.
Reclining Seatbacks
{CAUTION:
You can lose control of the vehicle if
you try to adjust a manual driver’s seat
while the vehicle is moving. The sudden
movement could startle and confuse you,
or make you push a pedal when you do
not want to. Adjust the driver’s seat only
when the vehicle is not moving.
{CAUTION:
If the seatback is not locked, it could
move forward in a sudden stop or crash.
That could cause injury to the person
sitting there. Always push and pull on
the seatback to be sure it is locked.
10

The seats have manual reclining seatbacks.
The lever used to operate them is located on
the outboard side of the seats.
To recline the seatback, do the following:
1. Lift the recline lever.
2. Move the seatback to the desired position,
then release the lever to lock the seatback
in place.
3. Push and pull on the seatback to make sure
it is locked.To return the seatback to an upright position, do
the following:
1. Lift the lever fully without applying pressure
to the seatback and the seatback will return
to the upright position.
2. Push and pull on the seatback to make sure
it is locked.
Driver’s Seat with Manual Lumbar,
Power Seat Control, and Manual Recline shown
11

{CAUTION:
Sitting in a reclined position when your
vehicle is in motion can be dangerous.
Even if you buckle up, your safety belts
cannot do their job when you are reclined
like this.
The shoulder belt cannot do its job
because it will not be against your body.
Instead, it will be in front of you. In a
crash, you could go into it, receiving neck
or other injuries.
The lap belt cannot do its job either. In a
crash, the belt could go up over your
abdomen. The belt forces would be there,
not at your pelvic bones. This could cause
serious internal injuries.
For proper protection when the vehicle is
in motion, have the seatback upright.
Then sit well back in the seat and wear
your safety belt properly.
Do not have a seatback reclined if your vehicle is
moving.
12

Head Restraints
Adjust the head restraint so that the top of the
restraint is at the same height as the top of
the occupant’s head. This position reduces the
chance of a neck injury in a crash.Pull the head restraint up
to raise it. To lower the
head restraint, press the
button, located on the
top of the seatback, and
push the restraint down.
13

Seatback Latches
There is a lever located on the back of both front
seats near the top on the outboard side.
These are used to fold the seatbacks forward
for easy entry and exit of the rear seats. The
front passenger’s seat has an easy entry feature
which allows the entire seat to move forward.
SeeEasy Entry Seat on page 15.To fold the seatback forward, lift the lever and
push the seatback forward.
{CAUTION:
If the seatback is not locked, it could
move forward in a sudden stop or crash.
That could cause injury to the person
sitting there. Always push and pull on the
seatback to be sure it is locked.
To return the seatback to the upright position,
push the seatback rearward until it locks in place.
Push and pull on the seatback to make sure it
is locked.
Passenger’s Seat shown, Driver’s Seat similar
14

Easy Entry Seat
The front passenger seat is designed to make it
easy to get into and out of the rear seat.
1. Lift the lever on the back of the right front
seat and tilt the seatback forward.
2. Push on the seatback to slide the seat
forward. The seat is now in the position
for easy entry/exit.
3. Return the seatback to the upright position to
lock it. Slide the seat fully rearward to lock it
into its original position.4. Make sure the safety belt is routed correctly
through the front safety belt guide.
15

{CAUTION:
If the easy entry right front seat is not
locked, it can move. In a sudden stop or
crash, the person sitting there could be
injured. After you have used it, be sure to
push rearward on an easy entry seat to be
sure it is locked.
5. Try to slide the entire seat back and forth to
make sure the seat is locked into place.
Rear Seats
Split Folding Rear Seat
You can fold either side of the seatback down for
more cargo space. Make sure the front seat is
not reclined. If it is, the rear seatback will not fold
down all the way.
Notice:Folding a rear seat with the safety
belts still fastened may cause damage to the
seat or the safety belts. Always unbuckle
the safety belts and return them to their normal
stowed position before folding a rear seat.
To lower the rear
seatback, pull forward
on the seat tab
located on the outboard
side of the seatback
cushion and fold
the seatback down.
This will allow
you direct access
to the trunk.
16