Page 7 of 320
Î
Î
Î
Î
Î
Î Î
Î To use the horn, press the pad around the ‘‘H’’ logo.
Only on vehicles equipped with navigation system. Ref er to the navigation system manual. If equipped.
3:
2:
1:
Your Vehicle at a Glance
4
STEERING WHEEL
ADJUSTMENT (P.76)
INSTRUMENT PANEL
BRIGHTNESS
VTM-4 LOCK
SHIFT LEVER
SEAT HEATERS
CRUISE CONTROLS
CRUISE BUTTON
VOICE CONTROL
SWITCHES
Vehicle with navigation system is shown.
VEHICLE STABILITY
ASSIST SYSTEM
OFF SWITCH
HAZARD WARNING
BUTTON
MOONROOF SWITCH
BED LIGHT SWITCH
HEADLIGHT CONTROL
DIAL
INTERIOR LIGHT
CONTROL SWITCH
HORN
(P.105)
(P.72) (P.117)
(P.73)
(P.206)
(P.163) (P.75)
(P.193)
(P.198)
(P.159) (P.163)
(P.76) (P.115) (P.101)SELECT BUTTON
RESET BUTTON
MULTI-CONTROL LEVER
(WINDSHIELD WIPERS/
WASHERS/TURN SIGNALS/
HEADLIGHT HIGH BEAMS) (P.
67)
(P.67)
REMOTE AUDIO
CONTROLS
2
3
2
1
2
——y
y
(yy
Page 74 of 320
Î
Î
Î
Î
Î
Î To use the horn, press the pad around the ‘‘H’’ logo.
If equipped.
1:
2:
Controls Near the Steering Wheel
Inst rument s and Cont rols
71
HAZARD WARNING
BUTTON
(P.76)
SHIFT LEVER
VEHICLE STABILITY
ASSIST SYSTEM
OFF SWITCH
CRUISE BUTTON
CRUISE
CONTROLS
HORN
STEERING WHEEL
ADJUSTMENT VTM-4LOCK
Vehicle with navigation system is shown. BED LIGHT SWITCH MULTI-CONTROL LEVER
(WINDSHIELD WIPERS/
WASHERS/TURN SIGNALS/
HEADLIGHT HIGH BEAMS)
MOONROOF SWITCH
SEAT HEATERS
INTERIOR LIGHT
CONTROL SWITCH
(P.105)
(P.72) (P.117)
(P.206)
(P.163)
(P.159) (P.76)(P.163)
(P.115)
INSTRUMENT PANEL
BRIGHTNESS
(P.75)
(P.193) (P.198)
(P.101)
HEADLIGHT CONTROL
DIAL
(P.73) RESET BUTTON
SELECT BUTTON (P.67)
(P.67)
REMOTE AUDIO
CONTROLS
1
2
2
2
——y
y
(yy
Page 75 of 320

µ
µ
OFF
INT: Intermittent
INT TIME ring
LO: Low speed
HI: High speed
MIST
Windshield washers
Turn signal
High beams
Flashhighbeams The multi-control lever has many
f unctions, including windshield
wipers and washers, turn signals,
headlight high beams, and headlight
high beam f lashing.
To select a position, turn the rotary
switch,pushthebuttonontheendof
the lever, or push the lever up, down,
f orward, or backward.
The wipers are not activated.
The length of the wiper interval is varied
automatically according to the
vehicle’s speed.
Vary the delay by turning the
INT TIME ring. If you turn it
to the shortest delay, the
wipers change to low speed
when the vehicle speed
exceeds 12 mph (20 km/h). The wipers run at low speed.
The wipers run at high speed. The wipers run at high speed
until you release the lever.
Push the
buttonontheendof the
multi-control lever. The
washers spray until you
release the button. The
wipers run at low speed, then
complete one more sweep
after you release the button.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. OFF:
INT :LO
HI
MIST :
Windshield Washer:
Multi-Control L ever
72
——y
y
(yy
Page 256 of 320
Check the condition of the wiper
blades at least every 6 months.
Replace them if you f ind signs of
cracking in the rubber, and areas
that are getting hard, or if they leave
streaks and unwiped areas when
used.
To replace a wiper blade:To raise the wiper arm, turn the
ignition switch to ON (II) and
activate the wipers (see page ).
When the wipers are in the
upright position, turn the ignition
switchoff tostopthewipersin
that position. Raise the wiper arm of f the
windshield.
Disconnect the blade assembly
fromthewiperarmbypushingin
the lock tab. Hold the lock tab in
while you push the blade assembly
toward the base of the arm.
1.
2. 3.
72
CONT INUED
Wiper Blades
Maint enance
253
LOCK TAB
WIPER ARMS
Do not open the hood when the wiper
arms are raised, or you will damage the
hood and the wiper arms.
—
—y
y
(yy
Page 319 of 320
Î
Î
ÎÎ
Wipers, Windshield .......................
Changing Blades .253
.....................................
Operation .72
....................................
Worn Tires .256
.....
Wrecker, Emergency Towing .286
......................
XM Satellite Radio .140
:U.S.only: Canada only
Index
X
X
—
—y
y
(y
y