Page 97 of 539
Page 98 of 539
SECTION 1 – 3
79
INSTRUMENTS AND CONTROLS
Gauges, meters and service reminder
indicators
Fuel gauge80
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . .
Engine coolant temperature gauge 80
. . . . . . . . . . . . . . . . . . . . . . . . . .
Tachometer 81
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . .
Odometer and trip meter 82
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Service reminder indicators and warning buzzers 82
. . . . . . . . . . . . . .
Multi−information display 90
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Compass 105
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . . . . . . . .
Instrument panel light control 109
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Page 99 of 539

GAUGES, METERS AND SERVICE REMINDER INDICATORS
80
FUEL GAUGE
13L062d
Low fuel level warning light
The gauge indicates the approximate quantity of fuel
remaining in the tank when the ignition switch is on.
It is a good idea to keep the tank over 1/4 full.
If the fuel level approaches “E” or the low fuel level warning light\
comes on, fill the fuel tank as soon as possible.
On inclines or curves, due to the movement of fuel in the tank,
the fuel gauge needle may fluctuate or the low fuel level
warning light may come on earlier than usual.
If the fuel tank is completely empty, the malfunction indicator
lamp comes on. Fill the fuel tank immediately.
The indicator lamp goes off after driving several times. If the
indicator lamp does not go off, contact your Lexus dealer as
soon as possible. See the inner back cover for fuel capacity and recommended
fuel selection.
ENGINE COOLANT
TEMPERATURE GAUGE
13L151
Normal range
The gauge indicates the engine coolant temperature when
the ignition switch is on. The engine operating
temperature will vary with changes in weather and engine
load.
If the needle points to the red zone or higher, stop your vehicle
and allow the engine to cool.
Your vehicle may overheat during severe operating conditions,
such as:
Driving up a long hill on a hot day.
Reducing speed or stopping after high speed driving.
Page 100 of 539
GAUGES, METERS AND SERVICE REMINDER INDICATORS
81
Idling for a long period with the air conditioning on in
stop−and−go traffic.
Towing a trailer.
NOTICE
Do not remove the thermostat in the engine cooling
system as this may cause the engine to overheat. The
thermostat is designed to control the flow of coolant
to keep the temperature of the engine within the
specified operating range.
Do not continue driving with an overheated engine.
See “If your vehicle overheats” on page 404.
TACHOMETER
13L144
The tachometer indicates engine speed in thousands of
rpm (revolutions per minute). Use it while driving to
prevent engine over revving.
Driving with the engine running too fast causes excessive
engine wear and poor fuel economy. Remember, in most
cases the slower the engine speed, the greater the fuel
economy.
NOTICE
Do not let the indicator needle get into the red zone. This
may cause severe engine damage.
Page 101 of 539

GAUGES, METERS AND SERVICE REMINDER INDICATORS
82
ODOMETER AND TRIP METER
13L145
This meter displays the odometer and two trip meters. To
change the mode indication, push the “ODO/TRIP” button
briefly. Each time you push the button, the mode changes
in order from the odometer to trip meter A to trip meter B,
then to the odometer.
The odometer records the total distance the vehicle has
been driven. The twin trip meter records two different
distances independently.
For example, you can use one meter to calculate the fuel
economy and the other to measure the distance on each trip.
To change the trip meter indication from one trip to the
other, push the “ODO/TRIP” button. To set the trip meter
A to zero, display the meter A reading, then push the
“RESET” button. The same applies for the trip B meter.
The data of trip meters will be cancelled if the electrical power
source is disconnected.
SERVICE REMINDER INDICATORS AND WARNING BUZZERS
IF THIS INDICATOR OR
BUZZER COMES ON ...DO THIS.
(a)or
If parking brake is off,
stop immediately and
contact Lexus dealer.
(b)
(Indicator and buzzer)
Fasten driver’s seat
belt.
(c)Fasten front
passenger’s seat belt.
(d)Take vehicle to Lexus
dealer immediately.
(e)Stop and check.
Page 102 of 539
GAUGES, METERS AND SERVICE REMINDER INDICATORS
83
IF THIS INDICATOR OR
BUZZER COMES ON ...
DO THIS.
(f)orTake vehicle to Lexus
dealer.
(g)See multi− information
display.
(h)or
Take vehicle to Lexus
dealer.
If brake system
warning light is also
on, stop immediately
and contact Lexus
dealer
(i)Close all doors.
(j)Low fuel level
warning lightFill up tank.
IF THIS INDICATOR OR BUZZER COMES ON ...DO THIS.
(k)Key reminder
buzzerRemove key.
Page 103 of 539

GAUGES, METERS AND SERVICE REMINDER INDICATORS
84
(a) Brake System Warning Light
This light comes on in the following cases when the ignition
switch is in the “ON” position.
When the parking brake is applied ...
This light comes on for a few seconds when the ignition switch
is turned to the “ON” position even after the parking brake is
released.
When the brake fluid level is low ...
CAUTION
It is dangerous to continue driving normally when the
brake fluid level is low.
Have your vehicle checked at your Lexus dealer in the
following case:
The light does not come on even if the parking brake is
applied when the ignition switch is in the “ON” position.
The light does not come on even if the ignition switch is
turned on with the parking brake released.
A warning light turning on briefly during operation does not
indicate a problem.
CAUTION
If either of the following conditions occurs, immediately
stop your vehicle at a safe place and contact your Lexus
dealer.
The light does not turn off even after the parking
brake is released while the engine is running.
In this case, the brakes may not work properly and
your stopping distance will become longer. Depress
the brake pedal firmly and bring the vehicle to an
immediate stop.
The brake system warning light remains on together
with the “ABS” warning light.
In this case, not only the anti lock brake system will
fail but also the vehicle will become extremely
unstable during braking.
Page 104 of 539

GAUGES, METERS AND SERVICE REMINDER INDICATORS
85
(b) Driver’s Seat Belt Reminder Light andBuzzer
The light and buzzer act as a reminder to have the driver buckle
up the seat belt.
Once the ignition switch is turned to “ON” or “START”, the
reminder light flashes and buzzer sounds if the driver’s seat
belt is not fastened. Unless the driver fastens the belt, the light
continues flashing and the buzzer stops after about 4 to 8
seconds.
(c) Front Passenger’s Seat Belt ReminderLight
The light acts as a reminder to have the front passenger buckle
up the seat belt.
Once the ignition switch is turned to “ON” or “START”, the
reminder light flashes if a passenger sits in the front passenger
seat and does not fasten the seat belt. Unless the front
passenger fastens the belt, the light continues flashing.
However, if a front passenger uses an additional seat cushion,
the indicator light may not flash even when the seat belt is not
buckled up.
If luggage or other load is placed on the front passenger seat,
depending on its weight and how it is placed on the seat, the
built−in sensor in the seat cushion may detect the pressure,
causing the reminder light to flash.
(d) SRS Warning Light
The indicators come on when the ignition switch is turned
to the “ON” position. It goes off after about 6 seconds.
This means the SRS airbags and seat belt pretensioners
are operating properly.
This warning light system monitors the airbag sensor
assembly, front airba g sensors, side and curtain shield airbag
sensor assemblies, curtain shield airbag sensor assemblies,
driver’s seat position sensor, driver’s seat belt buckle switch,
occupant detection sensor, front passenger’s seat belt buckle
switch, seat belt pretensioner assemblies, inflators, warning
light, interconnecting wiring and power sources.
If any of the following conditions occurs, this indicates a
malfunction somewhere in the parts monitored by the warning
light system. Contact your Lexus dealer as soon as possible
to service the vehicle.
When the ignition switch is turned to the “ON” position, the
light does not come on or remains on for more than 6
seconds.
The light comes on while driving.
If the light stays on, it indicates that the SRS driver and front
passenger airb ags, SRS side and curtain shield airbags and/or
seat belt pretensioners have a problem.