RESET MEMORY FUNCTION ± TC002-03 Revised May 5, 2003
Page 3 of 3
1. Disconnect the negative battery cable for 5 minutes.
2. Reconnect battery cable.
3. Start the engine and warm it up to normal operating temperatures before test±driving.
4. Perform a thorough test drive with several accelerations from a stop with ªlight
throttleº application until proper transmission shifting is verified.Reset
Procedure 2
ECM CALIBRATION: SHIFTING ENHANCEMENT ± TC004-03 Revised August 4, 2003
Page 5 of 6
2. Connect the Diagnostic Tester to the vehicle and select CURRENT ECU CAL from
the ECU REPROGRAM MAIN MENU. Determine the vehicle's current ECU
calibration (see Figure 2).
± The sample screen prints seen below are the 12.01a software version and may
differ from subsequent software versions.
Figure 2. Determining Current ECU Calibration
ECU REPROGRAM
MAIN MENU
1: GET CAL FROM PC
2: CURRENT ECU CAL
3: UPDATE ECU CAL
4: CAL ON TESTER
5: CLEAR CAL DATA
A
CURRENT ECU CAL
B
CALIBRATION ID
33341300
53328300
NOTE:
If Calibration ID matches ªPrevious Calibration IDº as shown in Calibration
Identification Chart on page 3, proceed with flash reprogramming.
If Calibration ID matches ªNew Calibration IDº as shown in Calibration Identification
Chart, this vehicle has already been programmed. Refer to TIS for diagnostic
procedures applicable to any stored DTCs.
3. If ECU calibration ID is not the same as the ªNew Calibration IDº listed previously,
proceed to Flash Reprogram ECM (PCM).
4. Flash Reprogram ECM (PCM)
Follow the procedures outlined in Lexus TSIB No. SS001±01,
ªECU Flash
Reprogramming Process,º
and flash the ECM (PCM) with the new calibration
file update.
NOTE:
If the ªCheck Engineº light is ON when the ignition is turned back on to begin the
reprogramming process, a scan tool cable problem exists. Refer to TSIB No.
SS001±01,
ªECU Flash Reprogramming Process.º
Repair
Procedure
(Continued)
