2005 HONDA ACCORD ignition

[x] Cancel search: ignition

Page 73 of 289

HONDA ACCORD 2005 CL7 / 7.G Owners Manual µµ
µ
µ
CONT INUED
Press this button once to
lock both doors. Some exterior lights 
will f lash once. When you push
LOCK twice within 5 seconds, you
will hear a beep to verify that the
doors ar

Page 79 of 289

HONDA ACCORD 2005 CL7 / 7.G Owners Manual µ
See pages f or important saf ety
inf ormation and warnings about how toproperly position the seats and seat-
backs. 11 13
On all V6 models, and the 4-cylinder EX
with Leather model
The controls f

Page 84 of 289

HONDA ACCORD 2005 CL7 / 7.G Owners Manual Make sure all rear shoulder belts are 
positioned in f ront of the rear seat-
back whenever the seat-back is in its
upright position. 
Make sure all items in the trunk, or 
items extending through the

Page 85 of 289

HONDA ACCORD 2005 CL7 / 7.G Owners Manual µ
CONT INUED
Turn the ignition switch to ON (II) 
to raise or lower either window. To
open the window, push the switch
downandholdit.Releasetheswitch
when you want the window to stop.
Pull back on t

Page 88 of 289

HONDA ACCORD 2005 CL7 / 7.G Owners Manual To tilt up the back of the moonroof , 
press and hold the center button
( ). To close the moonroof ,
press and hold the upper part of the
switch ( ). To open the
moonroof , press and hold the lower
pa

Page 89 of 289

HONDA ACCORD 2005 CL7 / 7.G Owners Manual Push or pull the adjustment knob 
right, left, up, or down to move the
mirror. 
When you f inish, turn the 
adjustment knob to the center
(of f ) position. This turns of f the
adjustment knob to keep

Page 90 of 289

HONDA ACCORD 2005 CL7 / 7.G Owners Manual To apply the parking brake, pull the 
lever up f ully. To release it, pull up
slightly, push the button, and lower
the lever. The parking brake
indicator on the instrument panel
should go out when the

Page 95 of 289

HONDA ACCORD 2005 CL7 / 7.G Owners Manual These sockets are intended to supply 
power f or 12 volt DC accessories
that are rated 120 watts or less (10
amps). 
To use an accessory power socket, 
the ignition switch must be in
ACCESSORY (I) or