2005 HONDA ACCORD homelink

µ
The HomeLink
Universal
Transceiver built into your vehicle
canbeprogrammedtooperateupto
three remote controlled devices
around your home, such as garage
doors, lighting, or home security
systems.
If you are training HomeLink to
operate a garage door or gate, you
should unplug the motor f or that
device during training. Repeatedly
pressing the remote control button
could burn out the motor. They do not have the saf ety f eature
that causes the motor to stop and
reverse if an obstacle is detected
during closing, increasing the risk of
injury.
For quick and accurate training,
make sure the remote control
transmitter for the device (garage
door, automatic gate, security
system, etc.) has a fresh battery.
If you just
received your vehicle and have not
trained any of the buttons in
HomeLink bef ore, you should erase
any previously learned codes bef ore
training the first button.
Todothis,pressandholdthetwo
outside buttons on the HomeLink
transceiver for about 20 seconds, or
until the red indicator f lashes.
Release the buttons, then go to step1.
HomeLink stores the code in a
permanent memory. There should
be no need to retrain HomeLink if
your vehicle’s battery goes dead or is
disconnected. If your garage door
opener was manuf actured bef ore
April 1982, you may not be able to
program HomeLink to operate it. Always ref er to the operating
instructions and saf ety inf ormation
that came with your garage door
opener or other equipment you
intend to operate with HomeLink. If
you do not have this inf ormation,
contact the manuf acturer of the
equipment.
If you are training the second or
third buttons, go directly to step 1.
CONT INUED
On EX-V6 model
HomeL ink Universal T ransceiver
General Inf ormation T raining HomeL ink
Bef ore you begin
Important Saf ety Precautions
Features
155
——y

y
(%y
y

Press and hold the remote control
button and one of the HomeLink
buttons at the same time.
Unplug the garage door opener
motor f rom the house current.
Holdtheendof thegaragedoor
opener remote control 2 to 5
inches f rom HomeLink. Make
sure you are not blocking your
view of the red indicator in
HomeLink. Plug in the garage door opener
motor, then test the HomeLink
button by pushing it. If the button
does not work, repeat the
procedure to train it again. If it still
does not work, you may have a
variable or rolling code garage
door opener. See if you do by
pressing and holding the
HomeLink button you just trained.
If the red indicator blinks for 2
seconds then stays on, you have a
rolling code garage door opener.
Go to ‘‘Training with a Rolling
Code System’’ (see page ).
Repeat these steps to train the
other two HomeLink buttons to
operate any other remotely-
controlled devices around your
home (lighting, automatic gate,
security system, etc.).
When the red indicator f lashes
rapidly, release both buttons.
HomeLink should have learned
the code f rom the remote control.
The red indicator in HomeLink
should begin f lashing. It will f lash
slowly at first, then rapidly.
2. 3. 4.
1.
5.6. 7.
157
HomeL ink Universal T ransceiver
156
The remote control you are training
f rom may stop transmitting af ter 2
seconds. This is not enough f or
HomeLink to learn the code. Release
and press the button on the remote
control every 2 seconds until HomeLink
has learned the code.
——y


y
(%y
y

For security purposes, newer garage
door opening systems use a ‘‘rolling’’
or variable code. Inf ormation f rom
the remote control and the garage
door opener are needed bef ore
HomeLink can operate the garage
door opener.
The ‘‘Training HomeLink’’
procedure trains HomeLink to the
proper garage door opener code.
The f ollowing procedure
synchronizes HomeLink to the
garage door opener so it sends and
receives the correct codes.Make sure you have properly
completed the ‘‘Training
HomeLink’’ procedure. Press the training button on the
garage door opener unit until the
indicator next to the button comes
on, then release it. The indicator
may blink, or come on and stay on.
You then have approximately 30
seconds to complete the following
steps.Press and hold the button on
HomeLink f or 3 to 4 seconds.
Press and hold the HomeLink
button again f or 3 to 4 seconds.
This should turn of f the training
indicator on the garage door
opener unit. (Some systems may
require you to press the button up
to three times.)
Press the HomeLink button again.
It should operate the garage door.
Find the ‘‘Training’’ button on your
garage door opener unit. The
location will vary, depending on
the manufacturer. 6.
2. 4. 5.
1. 3.
T raining With a Rolling Code
System
HomeL ink Universal T ransceiver
Features
157
TRAINING BUTTON
——y



y
(%y
y

As required by the FCC:This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, including
interf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f or
compliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not cause
interf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.
Youshoulderaseallthreecodes
bef ore selling the vehicle.
Totrainanalreadyprogrammed
HomeLink button with a new device,
you do not have to erase all the
memory. Train the selected button
over the existing memory code
f ollowing the steps under .
Toerasethecodesstoredinallthree
buttons, press and hold the two
outside buttons until the red
indicator begins to f lash, then
release the buttons.
If you have problems with training
the HomeLink Universal Transceiver,
or would like inf ormation on home
products that can be operated by
HomeLink, call (800) 355-3515. On
the Internet, go to
www.homelink.com.
HomeLink
is a registered
trademark of Johnson Controls, Inc.
HomeL ink Universal T ransceiver
Erasing Codes Customer Assistance
Retraining a Button
‘‘T raining
HomeL ink’’
158
——y


y
(%y

y

ÎÎÎÎ...............
Gas Mileage, Improving . 166
..........................................
Gasohol . 160 .........................................
Gasoline . 160
...........................................
Gauge . 65
.....................
Low Fuel Indicator . 60
................
Octane Requirement . 160
........................
Tank, Ref ueling . 161
................
Gas Station Procedures . 161
Gauges
...
Engine Coolant Temperature . 65
...............................................
Fuel . 65
Gearshif t Lever Positions ..........
Automatic Transmission . 179
..............
Manual Transmission . 176
........................................
Glove Box . 96
Gross Axle Weight Rating
.....................................
(GAWR) . 191
Gross Vehicle Weight Rating .....................................
(GVWR) . 191
...
Identif ication Number, Vehicle . 272
..............
If the Engine Overheats . 258
.............
If the Engine Won’t Start . 254
Ignition
..............................................
Keys . 73
...........................................
Switch . 75
............
Timing Control System . 282
........................
Immobilizer System . 74
..............
Manual Transmission . 223
..........................
Power Steering . 226
..................
Windshield Washer . 220
...........................
Folding Rear Seat . 87
..........................
Four-way Flashers . 70
........................
Front Airbags . 9, 20, 22
..................................
Front Seat . 81, 83
................................
Adjusting . 81, 83
.........................................
Heaters . 88
.....................................
Airbags . 9, 22
.................................................
Fuel . 160
..........
Check Fuel Cap Indicator . 65
......................
Fill Door and Cap . 161
...........................................
Gauge . 65
.....................
Low Fuel Indicator . 60
................
Octane Requirement . 160
...............................
Oxygenated . 160
........................
Tank, Ref ueling . 161
...............................
Fuel Economy . 166
..............................
Fuse Locations . 267
.....................
Fuses, Checking the . 264 ............. Halogen Headlight Bulbs . 228
..............
Hazard Warning Flashers . 70
........................................
Headlights . 68
........................................
Aiming . 228
..............
Automatic Lighting Off . 69
.......
Daytime Running Lights . 69 ..................
High Beam Indicator . 61
....................
Lights On Indicator . 60
............
Low Beams, Turning on . 68
.........................
Reminder Chime . 68
........
Replacing Halogen Bulbs . 228
...................................
Turning on . 68
..............................
Head Restraints . 86
.....................
Heating and Cooling . 104
...........................
Heated Mirrors . 94
.....................................
Heater, Seat . 88
.............
High Altitude, Starting at . 175
HomeLink Universal
................................
Transceiver . 155
..
Hood, Opening and Closing the . 162
...........................
Hydraulic Clutch . 226
Index
G H
I
IV
——y


y
(%yy