2004 Peugeot Partner VU Dag coolant

1.Power steering reservoir
2. Windscreen and headlamp* wash reservoir
3. Coolant reservoir 4.
Brake fluid reservoir
5. Battery
6. Air filter 7.
Dipstick
8. Engine oil reservoir
* According to destination.
1.9 LITRE (70 bhp) DIESEL ENGINE
PRACTICAL INFORMATION
86
22-12-2003

PRACTICAL INFORMATION87
22-12-2003
1.
Power steering reservoir
2. Windscreen and headlamp* wash reservoir
3. Coolant reservoir 4.
Brake fluid reservoir
5. Battery
6. Air filter 7.
Dipstick
8. Engine oil reservoir
* According to destination.
2 LITRE (90 bhp) TURBO DIESEL HDI ENGINE

PRACTICAL INFORMATION
88
22-12-2003
CHECKING THE LEVELS Oil level Check the level regularly and top up
between changes. The maximum consumption is 0.5 l per 1 000 km. Check the level with the vehicle on level ground, engine cold, using the oillevel gauge on the instrument panel orthe dipstick. Dipstick
There are two marks on the dipstick: A=maximum
Never fill past this mark.B= minimum
To maintain the reliability of engines and emissioncontrol systems, the useof additives in engine oilis prohibited. Viscosity selection In all cases, the oil selected must meet the manufacturer's requirements.
Brake fluid level:
Ð The level must always be between the DANGER and MAXI-
MUM marks in the reservoir.
Ð If the level drops substantially, contact a PEUGEOT dealer
immediately.
Fluid change:
Ð Must be carried out according to the manufacturer's servicing schedule.
Ð Use fluids recommended by the manufacturer, which fulfil DOT4standards.
Note: Brake fluid is harmful to health
and very corrosive. Avoid all contactwith the skin. Cooling system Use the fluid recommended by the
manufacturer. When the engine is warm, the tem- perature of the coolant is controlled
by the engine fan. As this fan canoperate with the ignition keyremoved and because the coolingsystem is pressurised, wait for atleast one hour after the engine hasstopped before carrying out anywork. Slacken the cap to the first notch torelease the pressure to prevent anyrisk of scalding. When the pressurehas dropped, remove the cap andtop up the level. Note:
The coolant does not need to
be changed. Used oil Do not dispose of used oil, brake fluid or coolant into drains or into theground. Power steering reservoir  Open the reservoir, with the engine at ambient temperature.The level should always beabove the MIN. mark and closeto the MAX. mark.
Windscreen and headlamp* wash level For best quality cleaning and for
your safety, we advise that youuse products recommended by
PEUGEOT.
* According to destination.
Oil change According to the information given in
"PEUGEOT SERVICING" .
Note: avoid used oil coming into
prolonged contact with the skin.

PRACTICAL INFORMATION103
22-12-2003
TOWING A TRAILER,
CARAVAN, BOAT etc.
Only use original PEUGEOT tow bars that have been tested andapproved from the design stage ofyour vehicle. The tow bar must be fitted by a
PEUGEOT dealer.
Your vehicle is basically designed for transporting people and luggage but it
may also be used for towing a trailer. Driving with a trailer subjects the towing vehicle to more significantstress and its driver must be particu-larly careful. Air density decreases with altitude, thus reducing engine performance.
Above 1 000 metres, the maximum
towing load must be reduced by 10 %
and so on for every 1 000 metres ofaltitude.Driving advice Distribution of loads:
Distribute the
load in the trailer so that the heaviest items are as close as possible to theaxle and the nose weight approachesthe maximum permitted withoutexceeding it. Cooling: Towing a trailer on a slope
increases the temperature of the coolant. As the fan is electrically controlled, its cooling capacity is not dependenton the engine speed.
On the contrary, use a high gear to lower the engine speed, and reduceyour speed. The maximum towing load on a long slope depends on the gradient andthe outside temperature. In all cases, pay attention to the coolant temperature. If the warning light comes on, stop
the vehicle and switch off the engineas soon as possible. Tyres:
Check the tyre pressures
of the towing vehicle and of the
trailer, observing the recommendedpressures. Braking: Towing increases the braking
distance. Lights: Check the electrical signalling
on the trailer. Side wind: Take into acount the
increased sensitivity to side wind.