Page 2719 of 3870
Fig. 9: Removing And Installing Exhaust Manifold (Right Bank)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2004 Mitsubishi Endeavor Limited 2004 ENGINE Intake And Exhaust - Endeavor
Page 2720 of 3870
Fig. 10: Identifying Special Tool
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2004 Mitsubishi Endeavor Limited 2004 ENGINE Intake And Exhaust - Endeavor
Page 2721 of 3870
Required Special Tool
:
MD998770: Oxygen sensor wrench
REMOVAL SERVICE POINT << A >>HEATED OXYGEN SENSOR REMOVAL Use special tool MD998770 to remove the oxygen sensor.
Fig. 11: Using Special Tool (MD998770) To Remove Oxygen Sensor
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
INSTALLATION SERVICE POINT
2004 Mitsubishi Endeavor Limited 2004 ENGINE Intake And Exhaust - Endeavor
Page 2722 of 3870
>>A<< HEATED OXYGEN SENSOR INSTALLATIONUse special tool MD998770 to install the oxygen sensor.
Fig. 12: Using Special Tool (MD998770) To Install Oxygen Sensor
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
INSPECTION Check the following points; replace the part if a problem is found. EXHAUST MANIFOLD CHECK 1. Check for dama
ge or crackin
g of an
y part.
2004 Mitsubishi Endeavor Limited 2004 ENGINE Intake And Exhaust - Endeavor
Page 2723 of 3870
2. Using a straight edge and a feeler gauge, check for distortion of the cylinder
head installation surface.
Standard value: 0.15 mm (0.006 inch) or less
Limit: 0.20 mm (0.008 inch) EXHAUST PIPE AND MAIN MUFFLER REMOVAL AND INSTALLATION Fig. 13: Removing And Installing Exhaust Pipe And Main Muffler
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
SPECIFICATIONS FASTENER TIGHTENING SPECIFICATIONS
2004 Mitsubishi Endeavor Limited 2004 ENGINE Intake And Exhaust - Endeavor
Page 2724 of 3870
Fig. 14: Fastener Tightening Specifications (1 Of 2)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2004 Mitsubishi Endeavor Limited 2004 ENGINE Intake And Exhaust - Endeavor
Page 2725 of 3870
Fig. 15: Fastener Tightening Specifications (2 Of 2)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
SERVICE SPECIFICATION SERVICE SPECIFICATION ITEM
STANDARD
VALUE
LIMIT
Manifold distortion of the installation surface
mm (in)
0.15 (0.006) or less
0.20
(0.008)
2004 Mitsubishi Endeavor Limited 2004 ENGINE Intake And Exhaust - Endeavor
