6. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is DTC C1201, C1206, C1211 or C1216 set?
YES: Go to Step 1.
NO: The procedure is complete.
DTC C1223: SUSPENSION OF SNSR. ACTIVE CHECK
2004 Mitsubishi Endeavor LS
2004 BRAKES Traction Control, Active Skid Control System - Endeavor
Fig. 240: Wheel Speed Sensor Output Voltage Measurement Grap
h
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
POINTS IN WAVEFORM MEASUREMENT Fig. 241: Points In Waveform Measurement Specification
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
HYDRAULIC UNIT CHECK Required Special Tools:
MB991958: Scan Tool (MUT-III Sub Assembly)
MB991824: Vehicle Communication Interface (V.C.I.) MB991827: MUT-III USB Cable MB991910: MUT-III Main Harness A
NOTE: The Wheel speed sensor cable moves in relation to motion
of the front or rear suspension. Therefore, it is likely that it
has an open circuit only when driving on rough roads but it
functions normally when driving on smooth roads. It is
recommended to observe sensor output voltage waveform
also under special conditions, such as driving on a rough
road.
2004 Mitsubishi Endeavor LS
2004 BRAKES Traction Control, Active Skid Control System - Endeavor
