2004 ISUZU TF SERIES Throttle Position Sensor

3.5L ENGINE DRIVEABILITY AND EMISSIONS 6E-135
Flash
Code Code Type DTC Name DTC Setting Condition Fail-Safe (Back Up) Recovery Condition Related Failure Parts Related
ECM Pin
No. Related
Multiple
DTC
P1171 D Fuel Supply System Lean
During Power Enrichment
(Bank 1) B21/
B22/
-
44
P1172 D Fuel Supply System Lean
During Power Enrichment
(Bank 2) 1. No DTC relating to MAF sensor, IAT sensor,
ECT sensor, TPS, CMP sensor, CKP sensor,
VSS, injector control circuit, ignition control
circuit, O2 sensor circuit low voltage & high
voltage (bank 1 & 2) and O2 sensor circuit no
activity (bank 1 & 2).
2. Engine speed is between 1000rpm and
6000rpm.
3. Intake air temperature is below 70
C.
4. Engine coolant temperature is between 30
C
and 120
C.
5. Engine load is between 150 and 255.
6. Throttle position output is more than 2.22V
and fluctuation is below 0.28V.
7. Except fuel cut operation.
8. O2 sensor output voltage below 250mV for 10
seconds. No fail-safe function.
O2 sensor output voltage is
more than 520mV for 5
seconds.
1. Sensor harness open or short to ground
circuit.
2. O2 sensor malfunction.
3. MAF sensor output is incorrect. 4. Air intake
line malfunction.
5. IAC valve malfunction.
6. Low fuel pressure.
7. Injector malfunction.
8. ECM malfunction.
B23/
B24 -
P0201 A Injector 1 Control Circuit
A36 - P0202 A Injector 2 Control Circuit
B3 - P0203 A Injector 3 Control Circuit
A35 - P0204 A Injector 4 Control Circuit
B4 - P0205 A Injector 5 Control Circuit
A34 -
31
P0206 A Injector 6 Control Circuit 1. No DTC relating to CMP sensor and CKP
sensor.
2. Under sequential injection.
3. Injection pulse is between 2.5ms and 7.5 ms.
4. Except fuel cut operation.
5. Engine speed is between 600rpm and
2000rpm.
6. 30 injection signals are not detected
consecutively. No fail-safe function. 30 injection signals are
detected consecutively. 1. Injector harness open circuit, short to ground
or short to voltage.
2. Injector malfunction.
3. ECM malfunction.
B5 -

6E-142 3.5L ENGINE DRIVEABILITY AND EMISSIONS
MULTIPLE DTC SETS TROUBLESHOOTING AIDS
An open or short to voltage circuit in the sensor ground circuit between the ECM terminal A22 and splice will cause
one or more of following DTCs to be set:





P0406 (Flash Code 32): EGR Circuit High





P0118 (Flash Code 14): Engine Coolant Temperature Sensor High Input

A short to ground circuit in the sensor power supply circuit between the ECM terminal A24 and splice will cause one
or more of following DTCs to be set:





P0122 (Flash Code 21): Throttle Position Sensor Low Input





P0336 (Flash Code 29): Crankshaft Position Sensor Circuit Range/Performance (58X)





P0337 (Flash Code 29): Crankshaft Position Sensor Circuit No Signal (58X)


RTW46EMF000201

3.5L ENGINE DRIVEABILITY AND EMISSIONS 6E-143
An open or short to voltage circuit in the sensor ground circuit between the ECM terminal B39 and splice will cause
one or more of following DTCs to be set:





P0103 (Flash Code 61): Mass Air Flow Sensor Circuit High Input





P0113 (Flash Code 23): Intake Air Temperature Sensor High Input





P0123 (Flash Code 21): Throttle Position Sensor High Input





P0341(Flash Code 41): Camshaft Position Sensor Circuit Range/Performance





P0342 (Flash Code 41): Camshaft Position Sensor Circuit No Signal

An open circuit in the sensor power supply circuit between the ECM terminal B27 and splice will cause one or more of
following DTCs to be set:





P0122 (Flash Code 21): Throttle Position Sensor Low Input





P0342 (Flash Code 41): Camshaft Position Sensor Circuit No Signal

A short to ground circuit in the sensor power supply circuit between the ECM terminal B27 and splice will cause one
or more of following DTCs to be set:





P0122 (Flash Code 21): Throttle Position Sensor Low Input





P0336 (Flash Code 29): Crankshaft Position Sensor Circuit Range/Performance (58X)





P0337 (Flash Code 29): Crankshaft Position Sensor Circuit No Signal (58X)

A short to ground circuit in the sensor signal circuit between the ECM terminal B28 and sensor will cause one of
following DTC to be set:





P0337 (Flash Code 29): Crankshaft Position Sensor Circuit No Signal (58X)


RUW46EMF000101

3.5L ENGINE DRIVEABILITY AND EMISSIONS 6E-145
DIAGNOSTIC TROUBLE CODE (DTC) P0101 (FLASH CODE 61) MASS AIR
FLOW SENSOR CIRCUIT RANGE/PERFORMANCE

RUW46EMF000101

Condition For Setting The DTC and Action Taken When The DTC Sets
Flash
Code
Code Type DTC Name DTC Setting Condition Fail-Safe (Back Up)
61 P0101 B Mass Air Flow Sensor
Circuit
Range/Performance
1. No DTC relating to barometer sensor, TPS, CMP sensor, CKP sensor and MAF sensor (low input & high input).
2. Engine speed is between 2800rpm and 4500rpm.
3. Throttle position sensor output voltage is between 1V and 3V.
4. Intake air temperature is between -14
C and 70
C.
5. Air flow amount below 0.04g/s (small air) or more than 177g/s (large air).
Above conditions are met for 3 seconds.
No fail-safe function.

6E-146 3.5L ENGINE DRIVEABILITY AND EMISSIONS
CIRCUIT DESCRIPTION
The mass air flow (MAF) sensor measures the amount
of air which passes through it into the engine during a
given time. The Engine Control Module (ECM) uses the
mass air flow information to monitor engine operating
conditions for fuel delivery calculations. A large quantity
of air entering the engine indicates an acceleration o
r
high load situation, while a small quantity or air indicates
deceleration or idle.
The MAF sensor produces a frequency signal which
can be monitored using a Tech 2. The frequency will
vary within a range of around 4 to 7 g/s at idle to around
25 to 40 g/s at maximum engine load. DTC P0101 will
be set if the signal from the MAF sensor does not match
a predicted value based on throttle position and engine
RPM.
DIAGNOSTIC AIDS
An intermittent may be caused by the following:
 Poor connections.
 Mis-routed harness.
 Rubbed through wire insulation.
 Broken wire inside the insulation.
Refer to Intermittents under service category
Symptoms.
Any un-metered air may cause this DTC to set. Check
for the following:
 The duct work at the MAF sensor for leaks.
 An engine vacuum leak.
 The PCV system for vacuum leaks.
 An incorrect PCV valve.
 The engine oil dip stick not fully seated.
 The engine oil fill cap loose or missing.


Diagnostic Trouble Code (DTC) P0101 (Flash Code 61)
Mass Air Flow Sensor Circuit Range/Performance
Step Action Value (s) Yes No
1
Was the "On-Board Diagnostic (OBD) System Check"
performed?
- Go to Step 2 Go to On Board
Diagnostic (OBD)
System Check
2
1. Connect the Tech 2.
2. Review and record the failure information.
3. Select "F0: Read DTC Infor By Priority" in "F0:
Diagnostic Trouble Code".
Is the DTC P0101 stored as "Present Failure"?
- Go to Step 3 Refer to
Diagnostic Aids
and Go to Step 3
3
1. Using the Tech2, ignition "On" and engine "Off".
2. Select "Clear DTC Information" with the Tech2 and
clear the DTC information.
3. Operate the vehicle and monitor the "F5: Failed
This Ignition" in "F2: DTC Information"
Was the DTC P0101 stored in this ignition cycle?
- Go to Step 4 Refer to
Diagnostic Aids
and Go to Step 4

3.5L ENGINE DRIVEABILITY AND EMISSIONS 6E-149
DIAGNOSTIC TROUBLE CODE (DTC) P0102 (FLASH CODE 61) MASS AIR
FLOW SENSOR CIRCUIT LOW INPUT

RUW46EMF000101

Condition For Setting The DTC and Action Taken When The DTC Sets
Flash
Code
Code Type DTC Name DTC Setting Condition Fail-Safe (Back Up)
61 P0102 A Mass Air Flow Sensor
Circuit Low Input
MAF sensor output voltage is below 0.3V. The ECM uses default mass air flow
value based on IAC valve position,
throttle position, barometer pressure
and engine speed.

6E-154 3.5L ENGINE DRIVEABILITY AND EMISSIONS
DIAGNOSTIC TROUBLE CODE (DTC) P0103 (FLASH CODE 61) MASS AIR
FLOW SENSOR CIRCUIT HIGH INPUT

RUW46EMF000101

Condition For Setting The DTC and Action Taken When The DTC Sets
Flash
Code
Code Type DTC Name DTC Setting Condition Fail-Safe (Back Up)
61 P0103 A Mass Air Flow Sensor
Circuit High Input
MAF sensor output voltage is more than 4.9V. The ECM uses default mass air flow
value based on IAC valve position,
throttle position, barometer pressure
and engine speed.

3.5L ENGINE DRIVEABILITY AND EMISSIONS 6E-179
DIAGNOSTIC TROUBLE CODE (DTC) P0121 (FLASH CODE 21) THROTTLE
POSITION SENSOR (TPS) CIRCUIT RANGE/PERFORMANCE



RUW46EMF000101

Condition For Setting The DTC and Action Taken When The DTC Sets
Flash
Code Code Type DTC Name DTC Setting Condition Fail-Safe (Back Up)
21
P0121
A
Throttle Position
Sensor
Range/Performance
1. No DTC relating to barometer sensor, ECT sensor, CMP
sensor, CKP sensor, MAF sensor and TPS (low input &
high input).
2. Engine speed is more than 2000rpm.
3. Engine coolant temperature is more than 75
C.
4. TPS output voltage is between 0.24V and 0.26V.
Above conditions are met for 3 seconds.
OR
1. No DTC relating to barometer sensor, ECT sensor, CMP
sensor, CKP sensor, MAF sensor and TPS (low input &
high input).
2. Engine speed is below 3200rpm.
3. Engine coolant temperature is more than 75
C.
4. TPS output voltage is between 4.54V and 4.56V.
Above conditions are met for 3 seconds. No fail-safe function.