2004 HONDA CIVIC COUPE Owners Manual

µ
µ
µ Avoid dropping or throwing the
transmitter.
Press this button once
to unlock the driver’s door. Push it
twice to unlock the other doors. If
you do not open any doors within 30
seconds, they will automatically
relock.
Pressthisbuttonfor
about one second to attract attention;
thehornwillsoundandtheexterior
lights will f lash f or about 30 seconds.
To cancel panic mode, press any
other button on the remote
transmitter or turn the ignition
switch to ON (II). Do not immerse the transmitter in
any liquid.
If you lose a transmitter, the
replacement needs to be
reprogrammed by a Honda dealer.
Press this button once to
lock all doors. Some exterior lights
will f lash. When you push LOCK
twice within 5 seconds, you will hear
a beep to verify that the doors are
locked. You cannot lock it if any door
is not f ully closed or the key is in the
ignition switch. Protect the transmitter from
extreme temperature.
Standard on LX and EX models in the
U.S.,andLXandSimodelsinCanada
Remote Transmitter
Remote Transmitter Care
Inst rument s and Cont rols
UNL OCK
PA NIC
LOCK
74
LED LOCK BUTTON
UNLOCK
BUTTON PANIC
BUTTON
——y

y
(%yy

´
Õ Ü
As required by the FCC:
This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, including
interf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f or
compliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not cause
interf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.To replace the battery, move the
round cover on the back of the
transmitter by turning it
counterclockwise with a coin. Insert
a new battery with the side facing
up. Align the mark on the cover
with the mark on the
transmitter. Set the cover in place
andturnitclockwise.
Battery type: CR2025
If it takes several pushes on the
button to lock or unlock the doors,
replace the battery as soon as
possible.
Inst rument s and Cont rols
Remote Transmitter
Replacing the Transmitter
Battery
75
ROUND
COVER
CUSHION RING
BATTERY
——y
y
(%yy

µ
To adjust the seat forward and
backward, pull up on the bar under
the seat cushion’s f ront edge. Then
trytomovetheseattomakesureit
is locked in position.To change the seat-back angle, pull
up on the lever on the outside of the
seat bottom.
Make all seat adjustments bef ore
you start driving.
See pages f or important saf ety
inf ormation and warnings about how toproperly position the seats and seat-backs. 11 13
Seats
FrontSeatAdjustments
Inst rument s and Cont rols76
——y
y
(%yy

To adjust the height of the driver’s
seat, turn the dial on the outside of
the seat bottom.To get into the rear seat on the
driver’s side, pull up on the seat-back
adjustment lever.
To get into the rear seat f rom the
passenger’s side in the U.S. DX
model, pull up the seat-back
adjustment lever. The seat-back will
tilt f orward. If more room is needed,
use the seat adjustment bar to move
the seat f orward.On all other models, push down the
release lever at the base of the seat-
back. The seat-back will tilt f orward
and the whole seat will slide f orward.
CONT INUED
OnLXandEXmodelsintheU.S.,and
LXandSimodelsinCanada
Seats
Driver’s Seat Height Adjustment Rear Seat Access
Inst rument s and Cont rols77
RELEASE
LEVER
SEAT-BACK
ADJUSTMENT LEVER
——y

y
(%yy

When you return the seat-back
upright, the seat stays in the fully
f orward position. Use the seat
adjustment bar and the seat-back
adjustment lever to move the seat to
the desired position. Make sure the
seat is f ully latched bef ore sitting in
it.
As you return the seat-back upright,
push the whole seat backward until it
latches. Make sure the seat is f ully
latched bef ore sitting in it.The head restraints help protect you
and your passengers f rom whiplash
and other injuries. They are most
ef f ective when you adjust them so
the back of the occupant’s head rests
against the center of the restraint.
Your vehicle is equipped with head
restraints in the f ront seats and the
outboard seating positions in therear. The head restraints in the f ront and
rear outboard seating positions
adjust f or height. You need both
hands to adjust the restraint. To
raise it, pull upward. To lower the
restraint, push the release button
sideways and push the restraint
down.
See page f or important saf ety
inf ormation and a warning about how toproperly position the head restraints.
On HX model in the U.S., and all
Canadian models
OnLXandEXmodelsintheU.S. 14
Seats
Head Restraints
Inst rument s and Cont rols78
FRONT
RELEASE BUTTON
——y
y
(%y
y

The lid of the console compartment
canbeusedasanarmrest.
Make sure the passenger’s hands or
fingersareawayfromthearmrest
bef ore pushing it down.The left and right halves can be
f olded separately f rom inside the
vehicle or inside the trunk. To f old
down the seat-back f rom inside the
vehicle, insert the master key in the
lock on the rear shelf . To f old down
the driver’s side, turn the key
clockwise, pull down the top of the
seat-back, then release the key. To
f old down the passenger’s side, turn
the key counterclockwise and
perf orm the same procedure.When storing cargo, you can move
therearcentershoulderbeltoutof
the way by removing the belt f rom
the guide.
CONT INUED
On LX and EX models in the U.S., and Si
models in Canada
Folding Rear Seat
Armrest
Inst rument s and Cont rols
Seats
79
GUIDE
CENTER SHOULDER BELT
——y

y
(%yy

To release the seat-back from inside
the trunk, pull the release under the
trunk panel. Push the seat-back
down, then let go of the release.
To lock the seat-back upright, push it
f irmly against the trunk panel. Make
sure it is latched in place by pulling
on the top of the seat.Make sure all rear shoulder belts are
positioned in f ront of the rear seat-
back whenever it is in the upright
position.
Do not put any heavy items on the
seat-back when it is folded.
Make sure all items in the trunk, or
items extending through the opening
into the back seat, are secured.
Looseitemscanflyforwardand
cause injury if you have to brake
hard. See on page
.
Never drive with the seat-back
f olded down and the trunk lid open.
See on
page . 122
47
Seats
Inst rument s and Cont rols
Carrying Cargo
Carbon Monoxide Hazard
80
RELEASE Pull Pull
——y

y
(%yy

Your vehicle’s windows are electri-
cally-powered. Turn the ignition
switch to ON (II) to raise or lower
any window.The driver’s door armrest has a
master power window control panel.
To open the passenger’s window,
push down on the appropriate switch
and hold it until the window reaches
the desired position. To close the
window, pull back on the window
switch. Release the switch when the
window gets to the position you want.
CONT INUED
OnLXandEXmodelsintheU.S.,andLXandSimodelsinCanada
Power Windows
Inst rument s and Cont rols81
MAIN SWITCH
DRIVER’S WINDOW SWITCH
Closing a power window on
someone’s hands or fingers can
cause serious injury.
Make sure your passenger is
away from the window before
closing it.
——y


y
(%yy