2004 DODGE SPRINTER service

4 INTRODUCTIONINTRODUCTIONThis manual has been prepared with the assistance of
service and engineering specialists to acquaint you
with the operation and maintenance of your new
vehicle. It is supplemented by a Warranty Information
Booklet and various customer oriented documents.
You are urged to read these publications carefully.
Following the instructions and recommendations in
this manual will help assure safe and enjoyable
operation of your vehicle.
NOTE: After you read the manual, it should be stored
in the vehicle for convenient reference and remain with
the vehicle when sold.
When it comes to service, remember that your dealer
knows your vehicle best, has the factory-trained
technicians and genuine Mopar
® parts, and is
interested in your satisfaction.
HOW TO USE THIS MA NUA LConsult the table of contents to determine which
section contains the information you desire.
The detailed index, at the rear of this manual, contains
a complete listing of all subjects.WA RNINGS A ND CA UTIONSThis manual contains WARNINGS against operating
procedures which could result in an accident or bodily
injury. It also contains CAUTIONS against procedures
which could result in damage to your vehicle. If you do
not read this entire manual you may miss important
information. Observe all Warnings and Cautions.
WARNING!
Engine exhaust, some of its constituents, and cer-
tain vehicle components contain or emit chemi-
cals known to the State of California to cause
cancer and birth defects or other reproduction
harm. In addition, certain fluids contained in ve-
hicles, and certain products of component wear,
contain chemicals known to the State of Califor-
nia to cause cancer and birth defects or other re-
productive harm.
Freightliner-all.book Pag e 4 Monday, December 1, 2003 2:54 PM

6 INTRODUCTIONSample Incomplete Vehicle Certification Label
(Label 1)
Sample Type Plate (Label 2)
VEHICLE / ENGINE EMISSION LA BEL, SA MPLE
A ND LOCA TIONLocation: on valve cover of the engine
Sample:Important Engine Information DaimlerChrysler AG, Stuttgart, Germany
Mercedes-Benz Engine, Model
Engine Family / Engine Code
Exhaust Emission Control SystemOM 612 LA CID 164
2 MBXH2.69DJB / Code I
TC, EMC, CAC, CAT, EGR
Date of engine manufacture
Advertised output (SAE gr.)
Fuel rate at adv. Output
Valve lash cold (ins.)
Basic injection timing
Idle speed2002
115 kW (154 HP) /3800 rpm
58 - 62 mm
3 / st roke
hydr. int. tappet exh.
14.5 ± 1 degrees BTDC
680 ± 50 rpm
This engine conforms to US EPA and Canada regulations applicable
to 2004 Model Year.
This engine has a primary intended service application as a light HD
diesel engine.
This engine is not certified for use in an urban bus as defined at 40
CFR 86.093.-2. Sales of this engine for use in an urban bus is a
violation of Federal Law under the Clean Air Act.
This engine is certified to be operated on diesel fuel.
Freightliner-all.book Pag e 6 Monday, December 1, 2003 2:54 PM

88 UNDERSTANDING YOUR INSTRUMENT PANELThe multi-function indicator can be used to call up the
odometer, trip meter, clock and outside temperature,
or information such as remaining time/distance until
the next service is due, or the engine oil level.
The multi-function indicator is activated by:
Turning the key to position 2 in the ignition lock,
opening the driver’s door,
pressing one of the buttons (‘), I, ç or
æ,
switching the side lights on, refer to "Combination
Switch".1. Press the button (‘) to switch between the
odometer and the trip meter, and to reset the trip
meter.
Press the button (‘) to activate the ASSYST
maintenance computer.
2. Press the I button to switch between the time
and outside temperature and to activate the time
adjustment.
3. Press the ç to adjust (dim) the display and
instrument lighting and to adjust the clock.
4. Press the æ to adjust (brighten) the display and
instrument lighting and to adjust the clock.Freightliner-all.book Pag e 88 Monday , December 1, 2003 2:54 PM

UNDERSTANDING YOUR INSTRUMENT PANEL 103
4
A SSYST MA INTENA NCE COMPUTER (OPTIONA L)Function button (‘) (1)
Approximately one month or 2,000 miles (3,000 km)
before a service is due, the maintenance symbol
or
lights up when the key is turned to position 2 in the
ignition lock.If the remaining time (in days) is shown, the additional
symbol
È
also appears in the multi-function indicator.
If additional maintenance operations are due, the
maintenance indicator
or
lights up when the key is turned to position 2 in the
ignition lock.
For additional maintenance operations, see Sprinter
Service Booklet.
If a service deadline is exceeded, the display will flash
with a minus sign in front when the key is turned to
position 2 in the ignition lock.
The display will be cancelled when the
button (‘) is pressed, or automatically after
10 seconds.
The remaining time or remaining distance can also be
called up manually.
To manually call up the remaining time/distance:
Activate the multi-function indicator, refer to "Multi-
Function Indicator".
Briefly press the button (‘) twice.
Sy mb
N00.00-2387-00
Sy mb
N00.00-2156-00
Sy mb
N00.00-2388-00
Sy mb
N00.00-2157-00
Freightliner-all.book Pag e 103 Monday, December 1, 2003 2:54 PM

104 UNDERSTANDING YOUR INSTRUMENT PANELDepending on the driving style, the mileage covered
and the operating conditions, the next service due is
displayed either as a remaining distance in "mi"
(in km) or as a remaining time in "days". The length of
time between services should not exceed 2 years.
The display will be cancelled when the
button (‘) is pressed, or automatically after
10 seconds.
When a service has been performed, have the ASSYST
maintenance computer reset by an authorized Sprinter
Dealer.
Should your Sprinter for any reason not be serviced by
an authorized Sprinter Dealer, the ASSYST
maintenance computer can, in exceptional
circumstances, be reset as follows:
Turn the key to position 2 in the ignition lock and
immediately press the button (‘) twice.
Within 10 seconds, return the key to position 0 in the
ignition lock.
Press and hold the button (‘). Turn the key to
position 2 in the ignition lock. Keep the
button (‘) pressed.The maintenance indicator with the current remaining
time/distance is shown.
After about 10 seconds, an acoustic signal will sound
and the maintenance indicator is displayed with the
new remaining time/distance.
Release the button (‘).
NOTE:
The ASSYST maintenance computer provides
information on the optimum maintenance requirements.
If maintenance intervals are not observed, resulting
damage will not be covered by Warranty.
The ASSYST maintenance computer is not an engine
oil gauge.
Engine oil level – for display in instrument cluster, see
next page.
If the engine oil level indicator lamp lights up, refer to
"Engine Oil Level Indicator Lamp".
If the battery is disconnected, the time is not recorded
by the ASSYST maintenance computer. Such periods
must be considered if maintenance intervals are
measured by time.
Freightliner-all.book Pag e 104 Monday, December 1, 2003 2:54 PM

STARTING AND OPERATING
5
CONTENTS
Power assistance . . . . . . . . . . . . . . . . . . . . . . . . . . 135

Starting the Engine . . . . . . . . . . . . . . . . . . . . . . . . . 135Maximum Engine Speed . . . . . . . . . . . . . . . . . . 136Constant RPMs (Optional) . . . . . . . . . . . . . . . . 137

Stopping the Engine . . . . . . . . . . . . . . . . . . . . . . . . 138

Automatic Transmission . . . . . . . . . . . . . . . . . . . . 139Driving . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 139Accelerator Position . . . . . . . . . . . . . . . . . . . . . . 140Stopping . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 140Maneuvering . . . . . . . . . . . . . . . . . . . . . . . . . . . . 140Selector Lever Position . . . . . . . . . . . . . . . . . . . 141Gear Selection for Special Circumstances . . . . 142

Transmission Selector Lever, Manually
Unlocking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 144

Loading the Vehicle . . . . . . . . . . . . . . . . . . . . . . . . 144Loading Guidelines . . . . . . . . . . . . . . . . . . . . . . 145

Brakes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 146Service Brake . . . . . . . . . . . . . . . . . . . . . . . . . . . . 146Brake Pad Wear Indicator . . . . . . . . . . . . . . . . . 147Brake Indicator and Electronic Brake Force
Distribution (EBD) Indicator Lamp . . . . . . . . . 148Parking Brake Indicator Lamp . . . . . . . . . . . . . 149Parking Brake . . . . . . . . . . . . . . . . . . . . . . . . . . . 150Driving Systems . . . . . . . . . . . . . . . . . . . . . . . . . 151Anti-Lock Brake System (ABS) Indicator
Lamp . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 152Anti-Lock Brake System (ABS) . . . . . . . . . . . . . 153Electronic Brake Force Distribution (EBD) . . . 155Acceleration Skid Control Indicator Lamp
(ASR) and Brake Assist System (BAS)
if equipped . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 155Acceleration Skid Control (ASR) Warning
Lamp and Electronic Stability Program (ESP)–
if equipped . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 157Acceleration Skid Control (ASR) . . . . . . . . . . . 158
Freightliner-all.book Pag e 133 Monday, December 1, 2003 2:54 PM

STARTING AND OPERATING 139
5
A UTOMA TIC TRA NSMISSIONThe automatic transmission selects individual gears
automatically, dependent upon:
 Selector lever position
 Accelerator position
 Vehicle speed
The gear shifting process is continuously adapted,
dependent on the driving style, the driving situation
and the road characteristics.NOTE: When parking the vehicle or before working on
the vehicle with the engine running, apply the parking
brake and shift the selector lever into "P".
DrivingThe selector lever is automatically locked while in
position "P". To move the selector lever out of position
"P", the service brake is applied and the key in
position 2 in the ignition lock or the engine running
before the shift lock will release.
Shift selector lever to the desired position only when
the engine is idling normally and the service brake is
applied. Do not release the brake until ready to drive.
The vehicle may otherwise start creeping when the
selector lever is in drive or reverse position.
WARNING!
It is dangerous to shift the selector lever out of "P"
or
"N" if the engine speed is higher than idle speed. If your
foot is not firmly on the brake pedal, the vehicle could
accelerate quickly forward or in reverse. You could lose
control of the vehicle and hit someone or something.
Only shift into gear when the engine is idling normally
and when your right foot is firmly on the brake pedal.
Freightliner-all.book Pag e 139 Monday, December 1, 2003 2:54 PM

140 STARTING AND OPERATINGNOTE: After selecting any driving position from "N"
or "P", wait a moment to allow the gear to fully engage
before accelerating, especially when the engine is cold.A ccelerator PositionPartial throttle, for early upshifting and normal
acceleration
Full throttle, for later upshifting and rapid acceleration
Kickdown, (depressing the accelerator beyond full
throttle) for downshifting to a lower gear and
maximum acceleration. Once the desired speed is
attained, ease up on the accelerator, the transmission
shifts up again.StoppingFor brief stops, such as at traffic lights, leave the
transmission in gear and hold vehicle with the service
brake.
For longer stops with the engine idling, shift into "N"
or "P" and hold the vehicle with the service brake.
When stopping the vehicle on an uphill grade, do not
hold it with the accelerator, use the brake. This avoids
unnecessary transmission heat build up.
ManeuveringTo maneuver in tight areas, such as when pulling into
a parking space, control the vehicle speed by gradually
releasing the brakes. Accelerate gently and never
abruptly step on the accelerator.
To rock a vehicle out of soft ground (mud or snow),
alternately shift from forward to reverse, while
applying slight partial throttle.
WARNING!
Getting out of your vehicle with the selector lever
not fully engaged in position "P" is dangerous.
Also, when parked on an incline, position "P"
alone may not prevent your vehicle from moving,
possibly hitting people or objects.
Always set the parking brake in addition to
shifting to position "P".
When parked on an incline, also turn front wheel
against curb.
Freightliner-all.book Pag e 140 Monday, December 1, 2003 2:54 PM