31
FRONT BEARING ELEMENTS
31 - 7
BRAKE CALIPER
DISMOUNTING
Lift the vehicle by means of a two columns
elevator.
Dismount the wheel.
Disconnect the wear sensor wire
Drain the brake fluid from the reservoir
Remove the locks and the caliper wedges;
Unscrew the rigid duct screw from the brake
flexible hose and detach the caliper assemb ly.
NOTE
If it is necessary to dismount the
caliper fork, unscrew the two attachment
s crews M 12.
When remounting the fork, replace the
Grower washers, tighten the screws at the
r equired moment of 6.5 daNm then seal
them with FIXAMED R 58. REPAIR
ING
Dismount the protection gasket.
Extract the piston using a wooden wedge and
a compressed air source. Remove the sealing gasket from its seat in the
caliper groove by means of a steel blade. Clean with alcohol the parts, replace t he
damaged ones, mounting being performed in the
dismounting reverse order, after previously all
parts have been oiled with brake fluid.
NOTE
Before remounting to t he wheel, c heck
the sealing of the caliper assembly.
TIGHTENING MOMENTS (daNm)
Wheel nuts 7,5
Rigid duct on front flexible screw 1,5
Purging screw 1
Flexible hose - caliper 2
vnx.su
