Page 392 of 933
LOWER INTERNAL ACCESSORIES
57
57 - 2
DASHBOARD
DASHBOARD VISOR
Dismount by frontal withdrawal and detachment.
LOWER DASHBOARD CASING
DISMOUNTING
Disconnect the front wiring connectors from the fuse box fixed by means of four screws on
the door (4) of the lower casing (5) and disconnect the c hoke cable.
Dismount the screw and the cage nut, which fix the lower casing on the front hood opening
control support.
Loosen the three screws that fix the lower casing on the lower side of the dashboard.
REMOUNTING
Perform in the reverse order the dismounting operations.
DISMOUNTING
For the dismounting of the dashboard assembly, perform the following operations:
Disconnect the battery.
Dismo
unt :
1. - the steering wheel and the steering wheel half-cases;
2. - dashboard visor;
3. - central console and the climate control assembly;
4. - dashboard lower casing;
5. - documents compartment;
6. - uppe r dashboard.
1
2
3
4
5
7
6
vnx.su
Page 407 of 933
HEATING
61
61 - 5
CLI
MATE CONTROL BLOWER DOES NOT WORKING
Check fuse F 01.
F01 good. Check F09.
F09 good. Check blower supply.
F01 blown. Replace the fuse.
The blower is not supplied.
Check R2 relay. The blower is supplied.
Check the air conditioning switch.
Relay R2 is damaged.
Replace the relay.The relay is not da
maged.
Broken or disconnected
relay switch wiring. Good switch.
Ma
ss wire
disconnected or brok en.Damaged switch.
Replace the switch.
DIAGNOSIS
vnx.su
Page 420 of 933
AIR CONDITIONING
62
62 - 13
Defective cooling
Is climate
blower working ?
Check the bl ower fuse and relay.
Are they defective?
Supply the blower motor
at (+12 V).
D oes it works?
Replace the climate control
switch or repair the electric
circuit.
Replace them
No
Ye s
Ye s
Change
blower.
No
No
Adequate air flow ?
Check t he a irflow fl aps
operation and the air ducts
integrity.
Compressor belt tensioning is good?
Yes Ye s
No
Any refrigerant fluid leakage
in the system ?
No
Ye s
Ye s
Is compressor clutch supplied with (+ 12 V)?
No
Ye s N o
Clutch is coupling the
compressor?
Replace the therm ostatic
expansion valve.
Ye s
No Check the electri c circ uit
for supplying and control.
Detect th
e refri ge ra nt fl ui d
leakage cause . Perform refilling.
Pressure controller is working?
Replace it.
Refacei tensiunea curelei
Replace it.
No
Ye s DIAGNOSIS
vnx.su
Page 421 of 933
AIR CONDITIONING
62
62 - 14
Correct AC system
filling.
Compressor does not work.
Ye s
Ye s No Ye s
Check the clutch coil. Damaged,
short-circuit?
Replace the
compressor.Restore the electric circuit
between E and clutch.
Is + 12 V at pol e E 5 of E relay?
Is + 12 V at pole E3 of E relay?
Is + 12 V at pole E3 of E relay?
Check fuse S6 from engine
compartment. Restore the
wiring between S6 and relay E.
No
Restore the wiring between pole
E1 of E relay a nd pole D5 of D
relay.
No
The wiring between injection
computer
and the pole E2 of E re lay is broken ?
Ye s
Repair the wiring.
Ye s
No
Check the pressure
controller electric circuit.
Injection computer does not receive
AC actuation?Yes
Check the switch electric circuit.
Pressure controller is working?
No
Replace the switch.
AC control switch is
working ?No
Ye s
Ye s
Check the pressure controller
electric circuit.
No
Replace the pressure controller.
No
DIAGNOSIS
vnx.su
Page 460 of 933
81
REAR AND INTERIOR LIGHTING
THE REAR DRIVING LAMPS NOT WORKING81 - 3Check the contact supply.
The contact is supplied;
the lamps supplying wire is disconnected
or broken.
Check the F 01 fuse.
Fu se F01 is burnt; replace t he fuse .F
01 is good:
bridge across the c ontact plugs.
Lamps a re working; replace the contact. Lamps are not working.
The contact is not supplied;
the contact supply wire is disconnected
or broken.
DIAGNOSTIC
vnx.su
Page 461 of 933
REAR AND INTERIOR LIGHTING
81
81 - 4
FOG LAMPS NOT WORKING
F 10 fuse is burnt; replace the fuse.
The relay is supplied.
Ground wire broken. Check the fuse F 10.
F
10 fuse is good.
Check the supply of the R1 relay.
The relay is supplied.
Check the lamps supply. The relay i s not supplied. Is there + 12 V
at pole 4 of the fog lamps contact ?
Disconnected wiresor defect contact. Lights switch
device
defect or F05 fuse burnt.
Lamps are not supplied .Check the fog lamps control relay.
Relay defect.
Replace the relay. Relay good. Lamps supplying
wire
broken or disconnected.
Yes No
DIAGNOSTIC
vnx.su
Page 462 of 933
81
REAR AND INTERIOR LIGHTING
81 - 5
BRAKE STOP LIGHTS NOT WORKING
Check F 01 fuse.
F 01 fuse burnt ; replace it.Fuse is good.
Bridge across the brake stop contact.
Stop lamps are lighting. Replace the contact. Stop lamps are not lighting.
Check the contact supplying.
Wire is broken: replace the wire.Contact is supplied. Lamps supply
wi re is disconnected or broken.
DIAGNOSTIC
vnx.su
Page 463 of 933

REAR AND INTERIOR LIGHTING
81COCKPIT FUSE BOX81 - 6
DISMOUNTING
Disconnect the (-) plug of the battery.
Turning the button
(4) open, then carefully remove the access little door (1) to the fuse box,
placed under left side dashboard. Dismount the attaching screws (2) of the fuse box on back of the little door.
Rotate the fuse box in order to have access at the connectors of its back then carefully discon-
nect the wiring connectors. If it is necessary the replacement of the module (3 ) attached on the
fuse box, for the fuses F11 – F16, first note the position of the wires connected to these fuses,
then perform the wires disconnecting .
Remove the fuse box.
REMOUNTING
Connect the wiring connectors to the fuse box printed circuit. Observe the form correspon-
dence of each connector with its drawing, marked on the printed circuit of the fuse box. Connect the wires corresponding to the fuses F11 – F16, if those have been previously disconnected.
Position the wires appointed for the fuses F11- F16 and the module (3) of those fuses, then
attach the fuse box on the back of the access little door (1).
Carefully mount the fuse box access little door, then close it.
Connect the (-) battery plug.
Perform functional tests, noticing the correct operation of all consumers supplied by means of
the cockpit fuse box.
OBSERVAT ION
For vehicle equipped with radio-tape player, after battery reconnecting, the radio
code must be introduced, in order to make it again running.
1
4
vnx.su