Page 174 of 891

IGNITION AND INJECTION
17
17 - 80
PR030 ENRICHING ADAPTATION IN OPERATION
PR031 ENRICHING ADAPTATION AT IDLING
RECOMMEND AT IONS No failure must be present or memorized.
Perform the steps for memorizing the adaptation values by the injection
computer.
Erase the computer memory. A t warm, when idling adjustment, observe the se paramete rs :
- If one of t hese parameters is moving towards the minimal limit, there is not sufficient petrol or there
is t oo much air.
- If one of the se paramete rs is moving towards the minimal limit, there is too much petrol or there is
not sufficient air.
(See chapter “ Enriching adaptive correction) for the exact limit values)
Ensure the cleaning condition and the good operation of :
- fuel filter
- fuel pump
- fuel circuit
- fuel tank
- air supply piping
- air filter
- spark plugs
C heck :
- Engine compressions
- Valves cle arance
- Ignition
Diagnostic – Parameters interpretation
AF TER Restart the conformity checking from the beginning.
REPARATION
vnx.su
Page 179 of 891

IGNITION AND INJECTION
17
17 - 85
ALP 2 STARTING PROBLEMS engine is not starting or is difficulty starting)
RECOMMEND AT IONS Do not consult this diagnostic but before performing a complete
checking by means of the CLI P tester.
Ch eck that starter is well operating
Ch eck there is petrol in the fuel tank (fuel indicator failure).
Ensure that vehic le is supplied with adequate fuel.
Ch eck tha t supply cir cuit hoses are not broken (espe cially further to a dismounting)
Ch eck the condition of the fuel filter
Ch eck the condition of the fuel tank
Ch eck that fuel tank aeration is taking place.
Ch eck the electric supply of the fuel pump.
Ch eck the good operation of the choke sensor.
Ch eck the motor of the idling regula tor.
In order to unblock it, you may slightly hit it.
Disconnect the connection hose between the canister purging valve and the intake manifold.
Cl amp the connection hose in order to stop the air passing.
If there are no more disturbances, the cause is the canister purging valve.
Ch eck the spark plugs and ignition coil condition
Ch eck tha t these eleme nts are specific to that vehicle.
Ch eck that the exhaust route is not clogged and the catalyst is not clogged.
Ch eck the engine compressions
Ch eck the flywheel condition
Ch eck the distribution setting on.
AFTER Perform a checking by means of the CLI P tester.
REPARATION
Fa ilure locating algorithm
vnx.su
Page 180 of 891

IGNITION AND INJECTION
17
17 - 86
ALP 3 IDLING PROBLEMS (unstable idling)
RECOMMEND AT IONS Do not consult this diagnostic but before performing a complete
checking by means of the CLI P tester.
C heck if there is petrol in the fuel tank (fuel indicator failure)
C heck if the vehic le is supplied with adequate fuel
C heck tha t supply cir cuit hoses are not broken (espe cially further to a dismounting)
C heck the condition of the fuel filter
C heck the condition of the fuel tank
C heck that fuel tank aeration is taking place.
C heck the connection and the condition of the idling regulator connector.
Re place the connector if necessary.
C heck the motor of the idling regulator
In order to unblock it, you may slightly hit it.
Disconnect the connection hose between the canister purging valve and the intake manifold.
Cl amp the connection hose in order to stop the air passing.
If there are no more disturbances, the cause is the canister purging valve.
C heck the spark plugs and ignition coil condition
C heck tha t these eleme nts are specific to that vehicle.
C heck that the exhaust route is not clogged and the catalyst is not clogged.
Check, by means of the oil dipstick, that oil level is not too high.
C heck for lack of sealing at servo-brake (noise).
C heck the intake manifold condition
C heck if the valve body is not clogged
C heck the engine compressions.
C heck the engine flywheel condition
C heck the distribution setting on.
AFTER Perform a checking by means of the CLI P tester.
REPARATION
Fa ilure locating algorithm
vnx.su
Page 181 of 891

IGNITION AND INJECTION
17
17 - 87
ALP 4 INTEMP ERATE ACCELERATION OR DECELERATION
(engine unstable running)
RECOMMEND AT IONS Do not consult this diagnostic but before a complete checking by
means of the CLIP tester
Ch eck if air filter is not deformed.
Ch eck if there is petrol in the fuel tank (fuel indicator failure)
Ch eck if the vehic le is supplied with adequate fuel
Ch eck tha t supply cir cuit hoses are not broken (espe cially further to a dismounting)
Ch eck the condition of the fuel filter
Ch eck the condition of the fuel tank
Ch eck that fuel tank aeration is taking place.
Disconnect the connection hose between the canister purging valve and the intake manifold.
Cl amp the connection hose in order to stop the air passing.
If there are no more disturbances, the cause is the canister purging valve.
Ch eck the spark plugs and ignition coil condition
Ch eck tha t these eleme nts are specific to that vehicle.
Ch eck that the exhaust route is not clogged and the catalyst is not clogged.
Ch eck the se aling of the exhaust manifold.
Ch eck, by means of the oil dipstick, that oil level is not too high.
Ch eck for lack of sealing at servo-brake (noise).
Ch eck the intake manifold condition
Ch eck if the valve body is not clogged
Ch eck the engine compressions.
Ch eck tha t brake calipers, drums and bearings are not gripped.
Ch eck that tires are inflated
Ch eck the engine flywheel condition
Ch eck tha t cooling system is properly operating
AFTER Perform a checking by means of the CLI P tester.
REPARATION
Fa ilure locating algorithm
vnx.su
Page 184 of 891
IGNITION AND INJECTION
17
17 - 90
ALP 7ENGINE N OISE
Failure locating algorithm
AFTERPerform a road test then a checking by means of CLIP tester.
REPARATIONFix possible detecetd failures.
RECOMMEND AT IONSDo not use these information but after performing complete
checking by means of CLIP tester.
Check the followings:
- lack of a ir leak;
- pre-heating spark plugs;
- injection pump setting on;
- injectors;
- injection pump;
- engine;
- combustion pre-chambers.
vnx.su
Page 185 of 891
IGNITION AND INJECTION
17
17 - 91
ALP 8SM OKE
Failure locating algorithm
AFTERPerform a road test then a checking by means of CLIP tester.
REPARATIONFix possible detected failures.
RECOMMEND AT IONSDo not use these informations but after performing complete
checking by means of CLIP tester.
Check the followings:
- injection pump setting on;
- injectors;
- injection pump;
- lack of a ir leak;
- pre-heating spark plugs;
- engine.
vnx.su
Page 186 of 891
IGNITION AND INJECTION
17
17 - 92
ALP 9LACK OF PE RF O RM ANCES
Failure locating algorithm
AFTERPerform a road test then a checking by means of CLIP tester.
REPARATIONFix possible detected failures.
RECOMMEND AT IONSDo not use these informations but after performing complete
checking by means of CLIP tester.
Check the followings :
- fuel conformity;
- lack of air circuit clogging, supply circuit and fuel circuit;
- lack of fuel leak and air leak;
- injection pump setting on;
- engine compression;
- injectors;
- injection pump;
- pre-heating spark plugs.
vnx.su
Page 522 of 891

80
BATTERY - FRONT HEADLIGHTS
80 - 1
CHECKING
It is recommended to check the following: -cr acks or breaches of the ba ttery box (c ase)
- battery upper part cleanness
- plugs condition
It is required to strictly check the following:
-lack of plugs sulfate composite
- proceed, is necessary to their cleaning and then greasing with neutral grease;
- correct wiring plugs tightening at the battery plugs. The existence of an imperfect contact
may generate i ncidents at engine starting or a t battery charging, sparks producing risk being
possible to occur, which may cause the battery explosion;
- check the electrolyte level;
- check that a eration holes of the access plugs are not closed.
For the batteries provided with access plugs, which may be dismounted, proceed as follows:
-r emove the plugs;
- check the electrolyte level in each element;
-i f necessary, refill the level, using only distilled water, till maximum 1.5 cm above the
plates;
-check that a eration holes of the access plugs are not closed
ATTENTION !
N ever fill up with electrolyte, but only with distilled wat er.
PRECAUTIONS
It is important to know that: -the battery contains sulfuric acid which is a dangerous substance
- during battery chargi ng, oxygen a nd hydrogen are produc ed, so c heck t hat aera tion
holes of the access plugs are not closed The mixture of these two gases is forming a detonate gas,
which may lead to the explosion risk. 1. DANGER = ACID
The sulfuric acid solution is a very aggressive, toxic and corrosive product. This is a ttacking
the skin, the clothes and may lead to the corrosion of most of the metals. Also, it is very important, that, when you handle a battery , to consider the following precautions:
- protect the eyes by using protective glasses;
- wear anti-acid gloves and clothes.
Battery
vnx.su