2004 DACIA SOLENZA ignition

81
INSIDE AND REAR LIGHTING
81 - 9
Cockpit fuse box
The fuses are protecting the following electric circuits:
Fuse Symbol Fu se Protected circuit
number type
F01 Free
F02 PLAF 15 A Instrument panel, cockpit UCE(ceiling lamp operation, radio
F03 20 ACockpit UCE, air conditioning climate control panel *
F04 15 ACockpit UCE, diagnostic socket, airbag UCE, anti-starting
bus h ing
F05
UC E10 A UCE injection , petrol pump relay/ignition coil, instrument panel
INJECTION
F06 10 AWindscreen wiper-washer switch (windscreen washing pump
operation), reverse driving switch, STOP switch, air
conditioning climate control panel*
F07 20 AWindscreen wiper-washer switch, UCE cockpit (windscreen
wiper timer operation), windscree n wiper motor (sto ppi ng at fix point).
F08 7,5 ALeft meeting lights, instrument panel (indicator)
F09 7,5 ARi ght meeting lights
F10 7,5 ALeft road lights, instrument panel (indicator)
F11 7,5 ARight road lights
F12 15 AAcoustic warning
F13 25 AUCE cockpit (turning lights and hazard), diagnostic socket.
F14 7,5 AFront/rear left parking lights, lighting: switches, climate control
panel, instrument panel, lighter, radio.
F15 7,5 AFront/rear right parking lights
F16 15 ALighter, radio
F17 30 AClimate control blower
F19 7,5 AFog lamp, instrument panel (indicator)
F20 25 ARear window defrosting
UC E
F21 INJECTION 5 AUCE injection
F23 30 ARight/left electric window regulator switch
F26 30 A Air conditioning climate control blower*
F28 20 AFog projectors
* for vehicles equipped with air conditioning
vnx.su

82
ACCOUSTIC WARNING - ANTI STARTING
82 - 39
Diagnostic – General
REMARK : the de coder bushing i s not
coded
DISMOUNTING – REMOUNTING
Dismoun t the half-cases under the steering
wheel, extract the bushing from the starting
contact and disconnect its connector.
CONNE CTING

Pin Denomination 1N ot in use
2 Mass
3+ After contact
4 Outlet signal
DESCRIPTION OF THE SYSTEM
By means of this system, the anti-starting is
activated few seconds after the contact has been
taken off (signalized by the blinking of the anti-
starting red indicator).
Its components are :
〈 key-head, equipped with a coded
electronic circuit (A).
OBSERVATION : the anti-starting
electronic is integrated in the remote control
printed circuit.
〈 anti-starting bushing (B), placed around the
ignition-start ing contact, equipped with an
electronic circuit having the purpose of key code
transmitting to the Cockpit Central Unit (UCH).
A
B
vnx.su

82
ACCOUSTIC WARNING - ANTI STARTING
82 - 57
Diagnostic – States interpretation
The active anti-starting state must become inactive at + After
RECOMMENDATIONS contact. The anti-starting must be active when the key is not in contact
ET017 ACTIVE although there i s a key in the ignition contact and + After contact
Check if there is not a failure before handling this state.
Check that state ET154 “+12 Volts after contact” is ACTIVE with the c ontact on.
H andle state ET154 if it is “INACTIVE “ with the contact on.
Check state ET002 “received key code” and state ET003 “valid key code” with the contact on.
If states ET002 and ET 003 are “YES”, perform the injection computer diagnostic
If state ET002 is “NO”, handle with priority this state.
If state ET002 is “YES” and state ET003 is “NO” , handle with priority ET003.
ET017
ACTIVE ANTI-STARTING
Perform again a system diagnostic
Fix all others failures
Erase the memorized failures.
AFTER REPAIRING
vnx.su

84
STEERING - CONN ECTOR
84 - 1
ANT I-THEFT MECHANISM
(IGNITION-STARTING SWITCH)
The anti theft mechanism is placed on the right part of the steering column and has the purpose
to starter control, electric system connecting and disconnecting, being provided in the same time
also with a steering locking device, with anti theft lock.
DISMOUNTIN G
Disconnect the battery (-) terminal
Dismount the 3 TORX 20 attachment screws of the steering wheel half-casings.
Detach from clips the steering wheel casings and remove them.
Disconnect the anti-starting bushing connector
Remove the anti-starting bushing ( 1) located around the anti-theft mechanism.
Disconnect the connectors ( 2) of the anti-theft mechanism.
Dismount the attachment screw (3) of the anti-theft mechanism by means of a screwdriver.
Bring the key on the position and push the mobile retaining pin ( 4) and releasing of the anti-
theft mechanism. Extract the mechanism towards backwards.
REMOU NT I NG
Position the contact key in the bellow position and push the mobile pin ( 4).
Mount the mechanism in its place, attaching it by means of the mobile pin and of the screw ( 3).
Connect ( 2) the anti-theft mechanism connectors.
Position and mount the anti-star ting bushing (1) around the anti-theft mechanism.
Connect the anti starting bushing connector.
Mount the steering wheel half-casings.
Connect the battery (-) terminal.
Check the operation of the anti-theft mechanism.
Anti-theft mechanism
vnx.su

88
WIRING
88 - 2
AIRBAG OPERATION
When setting the contact on, the airbag system
control indicator from the instrument pa nel is
lighted for 3 seconds then it is off.
UCE airbag is entering in a lookout state and
is considering the vehicle decelerations due to a
s ignal m easured by an integrated e lectronic
decelerometer.
In case of a stronger frontal impact, the
security electromechanical captor is tripping the
igniter of the pyrotechnic gas generator, which is
inflating the driver’s airbag. The airbag system is not releasing in case of a
s ide impact or a re ar impact.
When started, the pyrotechnic gas generator
is generating a detonation and some smoke.
IMPORTANT!
This system must be checked by means of the
CLIP tester, immediately when:
-a n accident did not caused the
movement, -the ve h icle was stolen or a stilling tentative
has been produced. -before selling a second hand vehicle.
AIRBAG INDICATOR FROM INSTRUMENT PANEL
This indicator is showing the operation state of
the driver’s airbag.
It is lighted for 3 seconds from contact setting
on, and then it is getting off and it staying like this.
If it is not on when setting the contact on or it is
on during vehicle driving, this is indicating a failure
in the system (see chapter “Diagnostic”) .
After driver’s airbag releasing, the airba g
indicator from the instrument panel is on and UCE
airbag is automatically bl oc king the driver’s airbag releasin
g line, memorizing the releasin g.
That is why, after an impact generating the
airbag re leasing, i t is necessary the UCE
airbag unblocking, then the computer blocking
in order to block all releasing.
The erasing of the memorized failures it is
possible only aft er data reading from “Im-
p act context” , then the shock sensor con-
tact is restored and the c ontrol “Computer
unblocking” may be performed.
UCE AIRBAG
DISMOUNTING – REMOUNTING
UCE airbag is mounted on the tunnel in
front of the gearbox lever. UCE air bag is provided with: -a security electromechanical captor,
-a decelerometer for airbag
- an ignition circuit of the pyrotechnic
system -an electric energy reserve,
-a diagnostic and memorizing circuit
of the detected failures, -a control circuit of the alert indicator
from instrumen t panel.
-A K-L communication interface with
the diagnostic socket.
UCE AIRBAG BLOCKING
Connect the CLIP tester to the vehicle,
the contact being set off. Set the contact on.
Block the UCE airbag: -select the menu “ Diagnostic”
- select and validate the vehicle type.
-s elect and validate the diagnostic
system “Airbag / Pre-tensioning systems”.
Airbag – Electronic control unit
vnx.su

89
ELECTRIC DIAGRAMS
89 - 8
Functional diagrams list index
Electric lighter
Alternator
Anti-theft system
Acoustic warning
Battery
Windscreen wiper timer
Injection computer (ECE)
Doors closing switch
Climate control panel
Hazard switch
Rear window defrosting switch
Left electric window switch
Right electric window switch
Turning signalling relay
Right rear door actuator
Left rear door actuator
Left front door actuator
Right front door actuator
Windscreen wiper-washer switch
Detona tion sensor
Atmospheric pressure sensor
RPM s ensor
Reverse driving contact
Handbrake contact
St op contact
Starte r
AC compressor clutch
Right rear lamp
Left rear lamp
Right fog headlight
Left fog headlight
Left front door contact
Right front parking lamp
Left front parking lamp
Cooling motor fan
Right rear loud speaker
Left rear loud speaker
Right front door loud speaker
Left front door loud speaker
Injector 1
Injector 2
Injector 3
Injector 4
Fuel lever transmitter and electric pump
Rear window defrosting
Electric left window actuator
Electric right window actuator
Oil pressure contact101
103
104
105
107
113
120
123
124
125
128
132
133
137
138
139
140
141
145
146
147
149
155
156
160
163
171
172
173
176
177
180
184
185
188
189
190
191
192
193
194
195
196
199
200
203
204
205
Code
Component denomination Code Component denomination209
212
213
221
222
224
225
226
227
231
234
236
238
242
244
247
255
256
261
262
267
268
272
319
320
321
326
333
371
462
503
584
597
639
649
654
700
756
778
857
887
899
927
101 6
109 1
114 0
115 6
120 2 Lights, turning lights and horn switch
Motor wi
ndscreen wiper
Ceiling lamp
Windscreen washing pump
Va l ve potentiometer
Power steering pressure controller
Diagnostic socket
Right headlamp
Left headlamp
Fog projectors control relay
Cooling motor fan control relay
Fuel pump control relay
Actuators relay
Downstream oxygen sensor
Injection water temperature sensor
DASHBOARD
Right front turning lamp
Left front turning lamp
Radio
Cooling motor fan and AC
Right side signalising lamp
Left side signalising lamp
Injection air temperature sensor
AC control panel
Cooling motor fan (for AC)
Motor fan resistance (for AC)
Speed limit indicator
Driver safety belt contact
Canister purging valve
License plate lamp
UCE decoder
AC compressor clutch control relay
Safety fuse box and engine compartment relays
STOP-S3 l amp
Step by step engine
Anti-starting bushing
Cooling blower low speed control relay
UCE airbag
Ignition coil
FLASH relay
Upstream oxygen sensor
Driver’s airbag
C hock sensor
Cockpit fuse box
I.C.P. braking system
V ehicle speed transducer
Cooling motor fan
AC pressure sensor (pressure controller)
vnx.su

89
ELECTRIC DIAGRAMS
89 - 11
Electric components location on the vehicle
In ject or 1
Inject or 2
Inject or 3
Inje ctor 4
Atmospheric pressure sensor
Detonation sensor
Starter
In jection air temperature sensor
Valve potentiometer
Upstream oxygen sensor
Step-by step engine
Alternator
Ignition c oil
Canister purging valve
AC pressure sensor (pressure controller)
Pressure controller DA
AC compressor clutch
Upstream oxygen sensor
Cooling motor fan and AC
Cooling engine fan resistance for AC
Oil pressure contact
Injec tion computer
RPM sensor
In jection water temperature sensor
Reverse driving contact
Fuse box and engine relays
Vehicle speed transducer
I CP brake system
Chock sensor
Windscreen wiper motor
Windscreen washing motor
Speed limit ind icator
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32Turning lights relay
Front door contact
Windscreen wiper timer
Left fron t door actuator
Le ft elec tric window actuator
Left fr ont door loud speaker
Cockpit fuse box
UCE d ecoder
FLASH relay
Rear window defrosting switch
Anti-starting bushing
STOP contact
Radio
Doors locking switch
Li ghter
Hazard switch
Climate control panel
Electr ic right window switch
Electr ic left window switch
UCE airbag
Diagnostic socket
Handbrake contact
Safety belt contact
Driver’s airbag
Right front door loud speaker
Electr ic right window actuator
Right front door actuator
Right rear door actuator
Right rear loud speaker
STOP-S3 lamp
Fuel level transmitter and electric pump
Left rear door loud speaker
Left r ear door actuator
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
No. Denomination
No.Denomination
vnx.su

89
ELECTRIC DIAGRAMS
89 - 14
Cockpit fuse box
The cockpit fuse box is placed in driving post left side, being attached on the dashboard lateral
side.
The fuses are protecting the following electric components and circuits:
Diagnostic socket, ceiling light, windscreen wiper motor (fix point
stopping), FLASH relay (+C)
UCE decoder, anti-starting bushing, rad io, instrument panel, climate
control panel (+C)
U.C.E. decoder, diagnostic socket, instrument panel, climate control
panel, speed limit indicator, contact STOP (+DC)
U.C.E. injection, U.C.E. airbag fuel pump relay/ ignition coil (+DC)
Reverse driving contact(+DC)
Windscreen wiper switch, windscreen wiper timer.
Left mee ting lights, instrument panel (indicator)
Right meeting lights
F02
F03
F04
F05
F06
F07
F08
F09

FUSE
NUMBERFUS E
TYPE P
ROTECTED CIRCU IT
10A
25A
15A
15A
5A
10A
10A
10A
vnx.su