2004 Acura RSX Owner's Manual

This indicator reminds you that it is
time to take your vehicle in for
scheduled maintenance.For the f irst 8,000 miles (12,800 km)
af ter the Maintenance Required
Indicator is reset, it will come on f or
two seconds when you turn the
ignition switch to ON (II).
Between 8,000 miles (12,800 km)
and 10,000 miles (16,000 km), it will
come on f or two seconds when you
f irst turn the ignition switch to ON
(II), and then f lash f or 10 seconds.
If you exceed 10,000 miles (16,000
km) without having the scheduled
maintenance perf ormed, this
indicator will remain on as a constant
reminder.
Ref er to the Maintenance Schedules
f or Normal and Severe Driving
Conditions on pages and . 159 160
Instrument Panel Indicators
Maintenance Required Indicator
Inst rument s and Cont rols54
MAINTENANCE REQUIRED INDICATOR

Your dealer will reset this indicator
af ter completing the scheduled
maintenance. If this maintenance is
done by someone other than your
Acura dealer, reset the indicator as
f ollows.Turn of f the engine.
Press and hold the select/reset
button in the instrument panel,
then turn the ignition switch to
ON (II).
Hold the button for about 10
seconds until the indicator goes
off.This indicator comes on when the
security system is set. See page
f or more inf ormation on the
security system.
1.
2.
3. 114
Instrument Panel Indicators
Security System Indicator
Inst rument s and Cont rols55
SELECT/RESET BUTTON
SECURITY SYSTEM INDICATOR

The odometer shows the total dis-
tance your vehicle has been driven.
It measures miles in U.S. models and
kilometers in Canadian models.
It is illegal under U.S. f ederal law and
Canadian provincial regulations to
disconnect, reset, or alter the
odometer with the intent to change
the number of miles or kilometers
indicated.This meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it.There are two trip meters: Trip A
and Trip B. The odometer and the
two trip meters use the same display.
Switch between these displays and
the odometer by pressing the Select/
Reset button repeatedly. Each trip
meter works independently, so you
can keep track of two dif f erent
distances.
To reset a trip meter, display it, and
then press and hold the Select/Reset
button until the number resets to
‘‘0.0’’.
Gauges
Odometer
T rip Meter
Inst rument s and Cont rols56
TEMPERATURE GAUGE TACHOMETER SPEEDOMETER FUEL GAUGE
SELECT/RESET BUTTON
ODOMETER/TRIP METER

This shows how much f uel you have.
It may show slightly more or less
than the actual amount. The needle
returns to the bottom after you turn
of f the ignition.This shows the temperature of the
engine’s coolant. During normal
operation, the pointer should rise
from the bottom white mark to about
the middle of the gauge. In severe
driving conditions, such as very hot
weather or a long period of uphill
driving, the pointer may rise to near
the upper white mark. If it reaches
the red (Hot) mark, pull safely to the
side of the road. Turn to page f or
instructions and precautions on
checking the engine’s cooling
system.
202
Fuel Gauge
T emperature Gauge
Gauges
Inst rument s and Cont rols57
Avoid driving with an extremely low
f uel level. Running out of f uel could
cause the engine to misf ire, damaging
the catalytic converter.

Controls Near the Steering Wheel
Inst rument s and Cont rols58
WINDSHIELD
WIPERS/WASHERSHORN
TILT ADJUSTMENT
HEADLIGHTS/
TURN SIGNALS
MOONROOF REAR WINDOW DEFOGGER
CRUISE CONTROL
INSTRUMENT PANEL BRIGHTNESS
HAZARD WARNING BUTTON

µ
µ
µ µ
µ
µ
µ
µ µ
The wipers are not activated.
The wipers run at low speed.
The wipers run at high speed. Rotate clockwise to turn the rear
window wiper on.
Hold past ON to turn the window
wiper on and the window washer
to spray.
OFF
Rotate counterclockwise to turn
the window wiper on and the
window washer to spray.
The length of the wiper
interval is varied automatically
according to the vehicle’s speed.
Vary the delay by turning the INT
TIME ring. If you turn it to the
shortest delay, the wipers will
change to low speed operation
when the vehicle speed exceeds 12
mph (20 km/h).
Push the right lever up or down to
select a position. MIST
OFF
INT Intermittent
LO Low
HI High
Windshield Washers
The wipers run at high
speed until you release the lever. Pull the
wiper control lever toward you and
hold it. The washers spray until
you release the lever. The wipers
run at low speed, then complete
one more sweep af ter you release
the lever.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
OFF
LO
HI
Rear Window Wiper and Washer
INT
MIST Windshield Wiper Windshield Washer
Inst rument s and Cont rols
Wipers and Washers
59

µ
µ
µ
Turn Signal
Of f
Parking and interior lights
Headlight on
High beams
Flashhighbeams Rotating the
switch on the lef t lever turns on the
parking lights, taillights, instrument
panel lights, side-marker lights, and
rear license plate lights. Turning the
switch to the ‘‘ ’’ position turns
on the headlights. If you leave the
lights on with the key removed f rom
the ignition switch, you will hear a
reminder beeper when you open the
driver’s door.
To turn on the high
beams, push the lef t lever f orward
until it clicks. The blue high beam
indicator will come on (see page ).
Pull it back to return to low beams.
To f lash the high beams, pull the
lever back lightly, then release it.
The high beams will stay on as long
as you hold the lever back. With the headlight switch off, the
high beam headlights come on with
reduced brightness when you turn
the ignition switch to ON (II) and
release the parking brake. They
remain on until you turn the ignition
of f , even if you set the parking brake.
The headlights revert to normal
operation when you turn them on
with the switch.
Push down on the
lef t lever to signal a lef t turn and up
to signal a right turn. To signal a lane
change, push lightly on the lever in
the proper direction and hold it. The lever will return to center when you
release it or complete a turn.
1.
2.
3.
4.
5.
6. 52
Turn Signal and Headlights
Headlights On
High BeamsDaytime Running L ights
(Canadian Models)
Turn Signal
Turn Signal and Headlights
Inst rument s and Cont rols60

The knob on the instrument panel
controls the brightness of the
instrument panel. Turn the knob to
adjust the brightness.Pushtheredbuttontoturnonthe
hazard warning lights (f our-way
flashers). This causes all four
outside turn signals and both
indicators in the instrument panel to
f lash. Use the hazard warning lights
if you need to park in a dangerous
area near heavy traffic, or if your
vehicle is disabled.The rear window def ogger will clear
fog,frost,andthinicefromthe
window. Push the def ogger button to
turn it on and of f . The indicator in
the button comes on to show the
def ogger is on. If you do not turn it
of f , the def ogger will shut itself of f
af ter about 25 minutes. It also shuts
of f when you turn of f the ignition.
You have to turn it on again when
you restart the vehicle.
CONT INUED
Instrument Panel Brightness, Hazard Warning Button, Rear Window Def ogger
Rear Window Def ogger
Instrument Panel Brightness Hazard Warning Button
Inst rument s and Cont rols61