Page 105 of 173

22-09-2003
YOUR 307 CC IN DETAIL101
Closing the roof:
Carry out the preparatory operations, indicated on the previous page.
Then, press button 3until the roof closing operation is
complete, confirmed by an audible signal.
When carrying out this manoeuvre, the four windows
lower, the boot opens, the moving shelf and the roof unfoldand position themselves, the hinged covers fold, then theboot closes. Note: if you continue to press button 3once the cycle is
complete, the four windows rise again. The control buttons for the windows become operational again at the end of the roof operation. In the case of an electric or hydraulic malfunction of the
roof, it is possible to close the roof manually. Please consult the breakdown procedure described at the end of this handbook.
During roof opening and closing operations, to
avoid any risk of injury, ensure that there is no-one in the proximity of the moving parts.
Operation of the roof is the sole responsibility of
the driver.
To guarantee correct operation, do not release but-ton 3 when the roof is in an intermediate position
(neither completely open or closed). However, in the
event of danger, release the control knob and the
operation will stop instantly. Once the danger hasbeen eliminated, complete the operation.
Page 106 of 173

22-09-2003
YOUR 307 CC IN DETAIL99
OPENING THE BONNET From inside:
push the handle on the
left-hand side under the fascia. From outside: lift the catch and
raise the bonnet. Bonnet strut Secure the strut to hold the bonnet open. Before closing the bonnet, replace the strut in its housing.
To close Lower the bonnet and release it at the end of its travel. Check that thebonnet is properly locked. "Bonnet open" warning With the engine running or the vehi- cle moving, flashing of the central
"STOP"
warning light accompanied
by an audible signal and a diagram
on the multi-function display, warnsyou that the bonnet is not properlyclosed. FILLING WITH FUEL Low fuel level
When the minimum fuel level in the tank isreached, this warninglight comes on.
You can still drive approximately30 miles (50 km). Flashing of the warning light indi-cates a malfunction of the fuelgauge.
Contact a PEUGEOT dealer. The engine must be switched off when filling with fuel.
Open the fuel filler flap.
Insert the key then turn it to the left.
Remove the cap and hang it onthe hook located on the inside ofthe flap.
A label affixed to the inside of the fuelfiller flap indicates which type of fuelto use. When you fill your tank, do not con-
tinue after the third cut-off of the
pump. This could cause your vehicleto malfunction. The capacity of the tank is approxi- mately 60 litres. After filling the tank, lock the cap and close the fuel filler flap.
Page 107 of 173

22-09-2003
YOUR 307 CC IN DETAIL
102
THE LIGHTS STALK Front and rear lights Selection is by turning ring
A.
Lights off Side lights Dipped/main beam headlamps Automatic switching on of lights Dipped/Main beam change Pull the stalk towards you. Note:
with the ignition off, if the
driver's door is open, a buzzer sounds if you have left your lights on. Front fog lamps and rear fog lamp Rotate the ring Bforwards
to switch on and backwards to
switch off. The status is confirmedby the light on the instrumentpanel.
Front fog lamps (1st for-wards turn of the ring)
The front fog lamps operate with theside lights and dipped headlamps. When the main beam headlamps are switched on, the front fog lamps are
switched off. They are switched onagain when the main beam head-
lamps are switched off. Front fog lamps andrear fog lamp (2nd for-wards turn of the ring)
Note: to switch off the rear fog lamp
and the front fog lamps, turn the ringtwice backwards.
Note: when the lights are switched
off automatically or when the dipped
headlamps are switched off manual-
ly, the front fog lamps, the rear foglamp and the side lights will remainon (turn the ring backwards to switch
off the front fog lamps. The side
lights will then be switched off). "Follow me home" lighting In poor light or at night, if you leave your vehicle, the side lights anddipped headlamps can be left on forapproximately one minute.
To do this:
Ð place the key in the STOPposi-
tion,
Ð place the lights stalk in the 0posi-
tion,
Ð flash the headlamps,Ð get out of the vehicle and lock it.
In good or rainy weather, both day and night, thefront fog lamps and therear fog lamp are daz-
zling and are prohibited. Do not forget to switch them off when they are no longer needed.
Page 108 of 173

22-09-2003
YOUR 307 CC IN DETAIL103
AUTOMATIC SWITCHING ON OF LIGHTS The side lights and dipped beam headlamps switch on automatically ifthe light is poor and when the wind-
screen wipers operate continuously.
They switch off when the light becomes bright enough or the wind-
screen wipers are switched off. This function is active when the vehi-
cle is supplied to the customer.
To disarm or activate the function:
Ð Place the key in the accessories
position (1st notch),
Ð Press the end of the lights stalk for more than four seconds.
Note: In foggy weather or in snow,
the brightness sensor can detect suf-
ficient light. As a result, the lights will
not come on automatically.
The brightness sensor, coupled
with the rain sensor, is located inthe centre of the windscreen,
behind the interior mirror. It isused for automatic switching onof the lights. Operating check ActivationActivation of this function is accom- panied by an audible signal and themessage
"Automatic lighting
active" on the multifunction display.
Disarming Disarming of the function is accom- panied by an audible signal. Note: the function is temporarily
disarmed when the driver uses the manual lighting controls. If the brightness sensor does not function correctly , the system acti-
vates the function (the lights come
on). The driver is alerted by an audi-ble signal, accompanied by the mes-sage "Auto lighting fault" on the
multifunction display.
Contact a PEUGEOT dealer to have the system checked.
Direction indicators (flashers)
Left: downwards.
Right: upwards.
Page 109 of 173

22-09-2003
YOUR 307 CC IN DETAIL103
AUTOMATIC SWITCHING ON OF LIGHTS The side lights and dipped beam headlamps switch on automatically ifthe light is poor and when the wind-
screen wipers operate continuously.
They switch off when the light becomes bright enough or the wind-
screen wipers are switched off. This function is active when the vehi-
cle is supplied to the customer.
To disarm or activate the function:
Ð Place the key in the accessories
position (1st notch),
Ð Press the end of the lights stalk for more than four seconds.
Note: In foggy weather or in snow,
the brightness sensor can detect suf-
ficient light. As a result, the lights will
not come on automatically.
The brightness sensor, coupled
with the rain sensor, is located inthe centre of the windscreen,
behind the interior mirror. It isused for automatic switching onof the lights. Operating check ActivationActivation of this function is accom- panied by an audible signal and themessage
"Automatic lighting
active" on the multifunction display.
Disarming Disarming of the function is accom- panied by an audible signal. Note: the function is temporarily
disarmed when the driver uses the manual lighting controls. If the brightness sensor does not function correctly , the system acti-
vates the function (the lights come
on). The driver is alerted by an audi-ble signal, accompanied by the mes-sage "Auto lighting fault" on the
multifunction display.
Contact a PEUGEOT dealer to have the system checked.
Direction indicators (flashers)
Left: downwards.
Right: upwards.
Page 110 of 173

22-09-2003
YOUR 307 CC IN DETAIL
104
After the ignition has been switched off, if the stalk was in awipe position, you must reactivatethis function:
Ð move the stalk to any position,
Ð then move it back to the required
position.
Special position of the front windscreen wiper
In the minute following switching off of the ignition, any action on the stalkpositions the wipers in the centre ofthe windscreen. This action enables you to position the wiper blades for winter parking,cleaning or replacement (See sec-tion "Practical information -Changing a wiper blade").
To park the wipers after this has been done, switch on the ignitionand operate the stalk.
Windscreen wash Pull the wipers stalk towards you. The windscreen wash, then the windscreen wipers, operate for afixed period.
WINDSCREEN WIPER STALK
Front windscreen wiper with intermittent wipe 2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
I Intermittent wipe.
0 Off.
Single wipe (press downwards).
In the Intermittent position, the wip-
ing speed is in proportion to the vehi-cle speed. Front windscreen wiper with automatic wipe
2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
AUTO Automatic wipe.
0 Off.
Single wipe (press downwards).
In the AUTOposition, the wiping
speed is in proportion to the intensityof the rainfall.
Page 111 of 173
22-09-2003
YOUR 307 CC IN DETAIL105
Automatic windscreen wipers In the
AUTOposition, the wind-
screen wipers operate automatically and adapt their speed to the inten-
sity of the rainfall.
Operating check ActivationWhen the function is activated, the message "Automatic wiping
active" appears on the multi-func-
tion display. Disarming In the event of malfunction , the dri-
ver is informed by an audible signal and the message "Auto wiper fault"
on the multi-function display. In the AUTOposition, the wind-
screen wiper will operate in intermit- tent mode.
Contact a PEUGEOT dealer to have the system checked. Do not cover the rain sen-sor located on the wind-screen behind the interior
mirror.
When using an automatic carwash, switch off the ignition orcheck that the wiper stalk is not inthe automatic position.
In winter, it is advisable to wait for the windscreen to completelyclear of ice before operating theautomatic wipe.
Page 112 of 173
22-09-2003
YOUR 307 CC IN DETAIL105
Automatic windscreen wipers In the
AUTOposition, the wind-
screen wipers operate automatically and adapt their speed to the inten-
sity of the rainfall.
Operating check ActivationWhen the function is activated, the message "Automatic wiping
active" appears on the multi-func-
tion display. Disarming In the event of malfunction , the dri-
ver is informed by an audible signal and the message "Auto wiper fault"
on the multi-function display. In the AUTOposition, the wind-
screen wiper will operate in intermit- tent mode.
Contact a PEUGEOT dealer to have the system checked. Do not cover the rain sen-sor located on the wind-screen behind the interior
mirror.
When using an automatic carwash, switch off the ignition orcheck that the wiper stalk is not inthe automatic position.
In winter, it is advisable to wait for the windscreen to completelyclear of ice before operating theautomatic wipe.