2003 Peugeot 307 CC Owner's Manual

22-09-2003
PRACTICAL INFORMATION141
Fuse N¡ Rating
Functions
1 10 A Automatic gearbox reversing lights switch - Automatic gearbox starting inhibitor relay control - Manual gearbox reversing lights switch -
Vehicle speed sensor.
2 15 A Canister solenoid valve - Fuel pump.
3 10 A Power steering control unit - ABS or ESP control unit.
4 10 A Injection control unit - Fan unit relay control - Additional heating relay control -
Automatic gearbox control unit - Automatic gearbox sequential control -
Automatic gearbox shiftlock relay.
5Ð Not used.
6 15 A Front fog lamps.
7Ð Not used.
8 20 A Fan unit relay control - Engine ECU supply.
9 15 A Left-hand dipped beam.
10 15 A Right-hand dipped beam.
11 10 A Right-hand main beam.
12 10 A Left-hand main beam.
13 15 A Horn.
14 10 A Wash-wipe pump.
15 30 A Oxygen sensors - Exhaust gas recirculation solenoid valve - Ignition coil -
Injectors supply.
16 30 A Petrol engine air pump with automatic gearbox.
17 30 A Low/high speed wiper.
18 40 A Air conditioning blower.

PRACTICAL INFORMATION
138
CHANGING A FUSE The fuse boxes are located in the lower part of the fascia (passengerside) and in the engine compartment. The spare fuses and special pliers
A
are fixed to the inside of the lid of the fascia panel fuse box. Removing and changing a fuse Before changing a fuse, you must establish the cause of the fault andhave it corrected. The fuse numbers are indicated on the fuse box.  Use the special pliers A.
Always change a faulty fuse for one of the same rating. Fascia panel fuses 
Unscrew the screw a quarter of a turn with a coin, then pull thehandle to open the cover andaccess the fuses.
Fuse no. Rating Functions
1 10 A Rear fog lamp.
2Ð Not used.
4 15 A Front electric windows - Roll-over hoops - Retractable roof.
5 15 A Left brake light including trailer.
7 30 A Rear courtesy light, front courtesy light, map reading
lights - 12 V front socket - Glove box lighting.
Correct
PliersAIncorrect
22-09-2003

22-09-2003
PRACTICAL INFORMATION139
* Fuses located inside the top of the fuse box.
Fuse no. Rating Functions
9 30 A Front electric windows - Automatic front electric windows.
10 15 A Diagnostic socket - 12 volt rear socket - Trailer.
11 20 A Audio equipment - Multi-function display - Steering wheel controls - Automatic gearbox - Retractable roof control unit.
12 10 A Front right and rear right side lights - Number plate and trailer lighting -
Central locking/alarm/hazard warning lights/ESP switches lighting -
Air conditioning/ashtray lighting - Automatic gearbox switches lighting -
Lighter.
14 30 A Door opening/closing controls - Deadlocking controls.
15 30 A Press-operation electric rear windows - Hinged covers motor.
16 10 A Engine fuse box - Alarm - Steering wheel controls - Air bags.
17 10 A Rear right brake light - 3rd brake light.
18 10 A Diagnostic socket - Steering wheel controls - Electrochromatic mirror - Brake pedal (stop) andclutch switches - Coolant level switch - Second brake switch.
19 30 A PARC shunt.
22 10 A Front left and rear left side lights - Number plate and trailer lighting.
23 15 A Alarm siren - Interior alarm control unit.
24 15 A Instrument panel - Audio equipment - Multi-function display - Air conditioning - Rear parking
assistance - Rain/brightness sensor.
26 30 A Heated rear screen.
27* Not used.
28* 40 A Retractable roof pump.

22-09-2003
PRACTICAL INFORMATION
142
CHANGING A WINDSCREEN WIPER BLADE Special front windscreen wiper position 
Within one minute of switching
off the ignition, operate thewipers stalk to position the wiperblades in the centre of the wind-screen (maintenance position).
Changing a wiper blade  Lift the wiper arm, then unclip the blade and remove it.
 Fit the new blade and push backthe arm.
Note: the shortest blade is fitted on
the vehicle's right-hand windscreenwiper arm.
To return the windscreen wipers to their normal position, switch onthe ignition and operate the wiperstalk. ECONOMY MODE FUNCTION After the engine has stopped, with the key in the accessories position,
certain functions (windscreen wiper,electric windows, courtesy lights,audio equipment etc.) can only beused for a cumulative duration ofthirty minutes, to prevent discharging
the battery.
Once the thirty minutes are over, the message
"Economy mode active"
appears on the multifunction displayand the active functions are put on
standby.
To resume the use of these functions
immediately, start the engine and letit run for a few seconds. LOAD REDUCTION FUNCTION When driving, certain functions (air conditioning, heated rear screen,
etc.) may be switched off temporari-
ly, depending on the level of batterycharge. Reactivation of these functions is automatic, once the battery charge is
sufficient. Note:
at the risk of discharging the
battery, the functions that have been
switched off may be reactivated
manually.
A flat battery will preventthe engine from starting.

22-09-2003
PRACTICAL INFORMATION143
BATTERY
To charge the battery using a battery charger:
Ð Disconnect the battery,
Ð Follow the instructions for use given by the battery charger manufacturer,
Ð Reconnect starting with the negative (Ð) terminal,
Ð Check that the terminals and connectors are clean. If they are covered with sul-
phate (white or greenish deposit), disconnect them and clean them.
To start the vehicle from another battery:
Ð Connect the red cable to the positive (+) terminals of the two batteries,
Ð Connect one end of the green or black cable to the negative (Ð) terminal of the slave battery,
Ð Connect the other end of the green or black cable to an earth point on the bro- ken down vehicle as far as possible from the battery,
Operate the starter, let the engine run.
Wait for the engine to return to idle, then disconnect the cables.
It is advisable to disconnect the battery if the vehicle is not to be used for a period of more than one month.Ð Before disconnectingthe battery, you must wait for 2 minutes afterswitching off the ignition.
Ð Never disconnect a terminal when the engine is running.
Ð Never charge a battery without first disconnecting the terminals.
Ð
Close the windows and retractableroof before disconnecting the bat-
tery. If the windows do not operatenormally following reconnection of
the battery, they must be reini-tialised (see section "Reinitialisationof the electric windows)
.
Ð After every reconnection of the battery, switch on the ignition andwait 1 minute before starting toallow the electronic systems tobe initialised. If slight difficultiesare experienced after this,please contact a PEUGEOT
dealer.

22-09-2003
PRACTICAL INFORMATION
144
TOWING YOUR VEHICLE
Without lifting (4 wheels on the ground)
You must always use a tow bar. The removable towing eye is inside the spare wheel. From the front: 
Unclip the cover, by pressing the bottom part,
 Screw in the towing eye as far as it will go.
From the rear: Unclip the top of the cover using a coin,
 Screw in the towing eye as far as it will go.
Lifting (2 wheels only on the ground) It is preferable to raise the vehicle with a professional lifting device. Special features of the automatic gearbox When towing with four wheels on the ground, the following rules must beobeyed:
Ð lever in position
N,
Ð tow the vehicle at less than 30 mph (50 km/h) over a maximum dis- tance of 30 miles (50 km).
Ð do not add oil to the gearbox.
When towing with theengine switched off, thereis no braking or steeringassistance.

22-09-2003
PRACTICAL INFORMATION145
TOWING A TRAILER,
CARAVAN, BOAT etc.
Only use original PEUGEOT tow bars that have been tested andapproved from the design stage ofyour vehicle. The tow bar must be fitted by a
PEUGEOT dealer.
Your vehicle is primarily designed for transporting people and luggagebut it may also be used for towing a
trailer. Driving with a trailer subjects the towing vehicle to more significantstress and its driver must be particu-larly careful. Air density decreases with altitude, thus reducing engine performance.Above 1 000 metres, the maximumtowing load must be reduced by
10 % and so on for every
1 000 metres of altitude. The rear parking assistance function will be disarmed automatically whena towbar is fitted.Driving advice Distribution of loads:
Distribute the
load in the trailer so that the heaviest items are as close as possible to theaxle and the nose weight approach-es the maximum permitted withoutexceeding it. Cooling: towing a trailer on a slope
increases the temperature of the coolant. As the fan is electrically controlled, its cooling capacity is not dependenton the engine speed.
On the contrary, use a high gear to lower the engine speed and reduceyour speed. The maximum towing load on a long slope depends on the gradient andthe outside temperature. In all cases, pay attention to the coolant temperature. If the warning light comes on, stop
the vehicle and switch off the engineas soon as possible. Tyres:
check the tyre pressures of
the towing vehicle and of the trailer,observing the recommended pres-sures. Braking: towing increases the braking
distance.Lights: check the electrical sig-
nalling on the trailer.Side winds: take into acount the
increased sensitivity to side wind.

22-09-2003
PRACTICAL INFORMATION
146
REMOVING THE MAT When removing the mat on the dri- ver's side, push the seat as far backas possible and unscrew the fixings. When refitting, position the mat and replace the fixings by pressing themin.