N22A200A
5. Place the jack under one of the jack-
ing points shown in the illustration. Use
the jacking point closest to the tyre to be
changed.
C-Front jacking point
N22A201A
D-Rear jacking point
NOTE
Usually set the jack at the jacking point (D).
However, if the ground clearance is insuf-
ficient at the jacking point (D), use the jack-
ing point (E).
WARNING
(1) Don’t place the jack at any posi-
tion other than the one speci-
fied. If the jack is placed at a
wrong position, the body of the
vehicle could be dented or the
jack might fall over and cause
personal injury.
(2) Avoid using the jack on a slope
or on a soft surface.
Otherwise the jack might tilt, and
the vehicle falls down, causing
an unexpected accident.
Always use the jack on a flat,
hard surface. Before placing the
jack, check to ensure that there
are no sand or pebbles on the
surface.
For emergencies
8-9
Div:
Out put date:
M40A045A
CAUTION
(1) If the tyres have arrows (A) indi-
cating the correct direction of
rotation, swap the front and rear
tyres on the left-hand side of the
vehicle and the front and rear
tyres on the right-hand side of
the vehicle separately. Keep
each tyre on its original side of
the vehicle. When fitting the
tyres, make sure the arrows
point in the direction in which
the wheels will turn when the
vehicle moves forward. Any tyre
whose arrow points in the wrong
direction will not perform to its
full potential.
(2) Avoid the combined use of dif-
ferent types of tyres.
This can affect driving safety.
Snow tyres
EL12A-DC
The use of snow tyres is recommended for
driving on snow and ice. To preserve driv-
ing stability, mount snow tyres of the same
size and tread pattern on all four wheels.
Snow tyres worn more than 50% are no
longer suitable for use as snow tyres.
Snow tyres which do not meet specifica-
tions must not be used.
CAUTION
Observe permissible maximum
speed for your snow tyres and the
legal speed limit.
NOTE
(1) The laws and regulations concerning
snow tyres (driving speed, required
use, type, etc.) vary. Find out and fol-
low the laws and regulations in driv-
ing area.
(2) If flange nuts are used on your vehicle,
change to tapered nuts when steel
wheels are used.
Tyre chains
EL23AOI
On 4WD vehicles in which the driving
power is distributed preferentially the rear
wheels, ensure that the tyre chains are fit-
ted on the rear.
Use only tyre chains which are designed for
use with the tyres mounted on the vehicle:
use of the incorrect size or type of chain
could result in damage to the vehicle body.
Before fitting tyre chains, please consult
your authorized MITSUBISHI dealer. The
maximum chain height is as follows.
Tyre size Wheel size Max. chain height
235/80R16
109S16×6JJ 22 mm
265/70R16
112H16×7JJ 22 mm
265/70R16
112S16×7JJ 22 mm
The speed limit for tyre chain is 50 km/h
(31 mph) and remove the tyre chains as
soon as possible on snow free roads.
WARNING
DO NOT use a jack when fitting the
chains, as the tyres may slip on the
icy road causing the vehicle to slip
off the jack.
Maintenance
9-16Div:
Out put date:
