2003 MITSUBISHI SHOGUN trip computer

Change of display modePressing the“DISP”button shows modes
1 to 5 in order.
1. Trip computer information
(for petrol−powered vehicles only)
→page 4-46
2. Climate information→page 4-47
3. Audio information→page 6-2, 6-17
4. Date and time→page 4-53
5. Air conditioning→page 4-57
D92A052A
Basic operationsWhen the key is turned to“ACC”, the
screen switches on automatically.
Use the“DISP”button to select the desired
display.
WARNING
Don’t use the system for prolonged
periods while the engine is idling in
poorly ventilated areas such as
indoor garage, as you may suffer
injury as a result of exhaust gas inha-
lation.
CAUTION
(1) The display should not be oper-
ated or observed for prolonged
periods while driving, as a traf-
fic accident may result.
(2) When operating the system, stop
the vehicle in an area where
parking is permitted.Instruments and controls
4-41
Div:
Out put date:

D92A059A
Trip computer information
(For petrol-powered vehicles only)
ED92F-G
The following information will be dis-
played from the trip computer system.
1. Average speed
2. Average fuel consumption
3. Driving rangeNOTE
(1) This display is not show for
diesel-powered vehicles.
(2) If this display is shown for
diesel-powered vehicles, there may be
a setting error, or the display may show
the wrong information. Be sure to reset
the car type.
(3) If this display is not shown for
petrol-powered vehicles, there may be
an error in the car type setting.
(4) If the body type“SHORT”or“LONG”is
wrongly selected when selecting
petrol-powered vehicles, the display
may show the wrong information.
Be sure to set the car type again.
→Refer to“Resetting the car type”on
page 4−64.
1. Average speed
2. Average fuel consumption
These values show the average speed (in
km/h or mph) and the average fuel con-
sumption (in L/100 km, or km/L) since the
display was reset. If you reset the display
at the time when you want to start the mea-
surements, average fuel consumption from
that point of time can be displayed.
To reset the display push the“RESET”
function button.NOTE
(1) When the system cannot provide a defi-
nite value for the average speed, this
display shows“
km”.
(2) Average fuel consumption varies
according to the conditions under which
a vehicle is travelling (road condi-
tions, the manner in which the vehicle
is being driven, etc.).
Observe this display for reference
because the fuel consumption dis-
play may differ from the actual fuel con-
sumption.
3. Driving range
This value shows the distance (in km or
miles) that can be driven on the fuel
remaining in the fuel tank.
When the driving range mode is dis-
played and the driving range drops below
50km/h (30miles), the display will blink
orange.
Instruments and controls
4-46Div:
Out put date:

D92M013A
2. When the car type has been selected,
press the“SET”function button.
D92M014A
3. When the car type setting has been
completed, the monitor will revert as fol-
lows.
In case of the petrol-powered vehicle is
selected :
Trip computer information display
D92M015A
In case of the diesel−powered vehicle is
selected :
Adjust the compass displayInstruments and controls
4-63
Div:
Out put date:

D92M016A
In case the petrol-powered vehicle is
selected incorrectly
1. Press the“DISP”button to display the
“Trip computer information”display.
D92K021A
2. Press the“RESET”function button for
more than 5 seconds.
D92M017A
3. This display will appear, set the car type,
refer to the“Car type setting”on page
4-62.Instruments and controls
4-65
Div:
Out put date: