2003 FIAT PALIO height

12
Adjusting the central rear seat
belt fig. 10
To tighten:
pull the end A(this
operation can be carried out also
with the seat belt already fastened).
To loosen: pull length Bholding
the buckle at right-angles to the belt.
fig. 10
P4E01607
SAFETY BELTS
The adjustments
described below must be
performed before dri-
ving. Avoid performing these
operations when the car is in
motion.
Adjusting the height
of the front seat belts
Fig. 8:
fix the loop in point Aor B
fig. 9
P4E01796
Fig. 9
To lift:
lift the loop C.
To lower: keeping the knob
pressed
D move the loop C.
fig. 8
P4E01783
To ensure maximum
protection, keep the
backrest in the upright
position, lean back into the seat
and ensure that the seat belt
adheres closely to torso and
hips. Do not use the seat belt
when the seat back is reclined.
1-19 03/03/2003 05:44 PM Page 12

23
HEAD RESTS
Front seats fig. 4
To improve passenger safety, the
height of the head restraints can be ad-
justed. They lock into place automat-
ically.
fig. 4
P4E01603
Remember that the
head restraints should be
adjusted to support the
back of your head and not your
neck. Only if they are in this po-
sition will they be able to provide
effective protection in the event
of a rear-end shunt.
DRIVING MIRROR fig. 6
This mirror can be adjusted. Move
lever
Ato shift the mirror to the fol-
lowing positions:
1)anti glare position;
2) standard position.
fig. 6
P4E01375
20-63 03/03/2003 06:02 PM Page 23

25
To unfasten the seat belts, press but-
ton
C. Guide the seat belt with your
hand while it is rewinding, to prevent
it from twisting.
The seat belt reel mechanism will
adapt the belt to the body of the per-
son wearing it, offering freedom of
movement.
When the car is parked on a steep
slope the reel mechanism may lock;
this is normal.
The reel mechanism prevents the
webbing coming out when it is jerked
or if the car brakes sharply, as in a col-
lision or when cornering at high speed.
To ensure maximum
protection, keep the
backrest in the upright
position, lean back into the seat
and ensure that the seat belt ad-
heres closely to torso and hips.
Do not use the seat belt when the
seat back is reclined.
Always adjust the height of the seat
belt to fit the person wearing it. This
could greatly reduce the risk of injury
in the case of collision.
The belt is adjusted properly when
the webbing passes approximately
halfway between the edge of the
shoulder and the neck.
ADJUSTING THE HEIGHT OF
THE SEAT BELTS
Make the height adjust-
ment when the car is sta-
tionary.
fig. 9
P4E01783
Adjust the seat belt height only when
the car is stationary.
Fig. 9: fasten the loop in Aor B.
Fig. 10: The seat belt can be adjust-
ed on four different heights.
To raise the belt: raise loop Cto
the required position.
To lower the belt: press knob (D)
and move loop (C)down to the re-
quired position at the same time.
After adjustment always check that
the seat belt is locked by pushing loop
Cdownwards without pressing knob
D.
fig. 10
P4E01796
20-63 03/03/2003 06:02 PM Page 25

53
If you want to carry a
can of petrol as a reserve,
adhere to the laws in
force. Not following precautions
increases the risk of fire in the
event of an accident. To remove the
parcel shelf
1)
Free the upper extremities A-fig.
61
of the two tie rods, withdrawing
the eyelets from the pins.
2)Free the cover pins A-fig. 62
from their seats Band remove it.
After removing, the cover can be
transversally positioned between the
front seat backs and the tipped chush-
ion of the rear seat.
IMPORTANT If the load in the
boot is fairly heavy and you are trav-
elling at night, check and adjust the
height of the dipped beam headlights
(see“ Headlights” paragraph in this
chapter).
Heavy loads which are
not securely anchored
could seriously injure pas-
sengers in the event of an acci-
dent.
We suggest you do not
drive with the tailgate
open, as the exhaust gas-
es can come inside the car via the
boot.
fig. 62
P4E01750
20-63 03/03/2003 06:03 PM Page 53

86
IF A BULB BURNS OUT
Modifications or repairs
to the electrical system
carried out incorrectly
and without bearing the features
of the system in mind can cause
malfunctions with the risk of fire.
You should have the
bulbs replaced at a Fiat
Dealership. The correct
operation and direction of the
headlights is essential for safety
and is governed by the highway
code.Only touch the metal
part when handling halo-
gen bulbs. If the transpar-
ent bulb is touched it reduces the
intensity of the light emitted and
can also reduce the life of the
bulb. If you touch the bulb acci-
dentally, rub it with a cloth moist-
ened with alcohol and leave it to
dry.
GENERAL INSTRUCTIONS
When a light is not working, check
that it has not fused before changing the
bulb.
For the location of the fuses, refer to
“If a fuse blows” in this chapter.
Before replacing a bulb that does not
work, check that the contacts are not
oxidised.
Halogen bulbs contain
pressurised gas which, if
broken, may cause small
fragments of glass to be project-
ed outwards.
Burnt-out bulbs must be replaced
with ones of the same type. Bulbs with
low power offer low illumination,
bulbs with too much power absorb
too much energy.
Always check the height of the head-
light beam after changing a bulb.
TYPES OF BULBS
Several types of bulbs are installed in
the car
fig. 12:
A. Glass bulbs
Clipped into position. Pull to remove.
B. Bayonet connection bulbs
Remove from the bulb holder by
pressing the bulb and rotating it anti-
clockwise.
C. Cylindrical bulbs
Remove by pulling away from termi-
nals.
D-E. Halogen bulbs
To remove bulb, loosen the fixing
spring from the relevant seat.
80-103 03/03/2003 06:49 PM Page 86

136
Max speed index
Q
= up to 160 km/h.
R= up to 170 km/h.
S= up to 180 km/h.
T= up to 190 km/h.
U= up to 200 km/h.
H= up to 210 km/h.
V= up to 240 km/h.
W= up to 270 km/h.
Y= up to 300 km/h.
Load index (capacity)
60
= 250 kg
61 = 257 kg
62= 265 kg
63= 272 kg
64= 280 kg
65= 290 kg
66= 300 kg
67= 307 kg
68= 315 kg
69= 325 kg
70 = 335 kg
71= 345 kg
72= 355 kg
73= 365 kg
74= 375 kg
75= 387 kg
76= 400 kg
77= 412 kg
78= 425 kg
79= 437 kg
80= 450 kg
81= 462 kg
82= 475 kg
83= 487 kg
84= 500 kg
85= 515 kg
86= 530 kg
87= 545 kg
88= 560 kg
89= 580 kg
90= 600 kg
91= 615 kg
92= 630 kg
93= 650 kg
94= 670 kg
95= 690 kg
96 = 710 kg
97= 730 kg
98= 750 kg
99= 775 kg
100= 800 kg
101= 825 kg
102= 850 kg
103= 875 kg
104= 900 kg
1CORRECT READING
OF THE RIM fig. 6
The indications, necessary to know
the meaning of the identification ini-
tials printed on the rim, are listed be-
low.
CORRECT READING
OF THE TYRE fig. 6
The indications, necessary to know
the meaning of the identification ini-
tials printed on the tyre, are listed be-
low.
175= Nominal (S, distance in mm
between the sides).
65= height/width ratio (H/S) in per-
centage.
R= Radial tyre.
14= Diameter of the rim in inches
(Ø).
82= Load index (capacity).
T= Max speed index. Example
175/65 R 14 82 S
IMPORTANTThe light alloy
wheels are fixed with specific bolt in-
compatible with any printed steel
wheels, excluding the specific spare
wheel.
SNOW TYRES
Use reduced dimension winter tyres,
see “Snow Chains” chapter.
WHEEL GEOMETRY
Convergence of the front wheel mea-
sured between the rims: –1±1(Power
Steering), +1mm (Mechnical Steering).
The values refer to a car after running in.
WHEELS AND
TYRES
Pressed steel or alloy (as provided)
wheel rims; specific fixing bolts (di-
mensionally different and respective-
ly incompatible) for each of the two
types of rim.
IMPORTANTIn the event of dis-
crepancies between the information in
the Owner Handbook and the Log
Book, consider the specifications giv-
en in the Log Book only.
To ensure safety of the vehicle in
movement, it must be fitted with tyres
of specified size and of the same make
and type on all wheels.
Versions Rim Tyre
1.2 EL-ELX-SPORT5.00Bx13 165/80 R13
1.6 16V GTX51/2 Jx14C(*) 175/65 R14
1.9 D EL-ELX5.00Bx13 165/80 R13
(*) Alloy rims
128-143 03/03/2003 07:39 PM Page 136

146
Main beam headlights
- control ..................................... 13-41
- flashing...................................... 13-42
- bulb replacement ................... 88
Maintenance
- Additional interventions ..... 108
- servicing schedule.................. 105
- servicing schedule plan......... 106
Max speeds ................................... 138
Paintwork identification
plate ............................................ 130
Paintwork
- maintenance .......................... 126
- Identification plate ............... 130
Parking ........................................... 67
Passenger compartment air vents 38
Performances ................................ 138
Periodic checks and before
long distances........................... 78
Plate light ...................................... 92
Power steering fluid level ......... 114
Pretensioners ................................ 32
Protecting emission control
devices ....................................... 74Protecting the environment ..... 63
Raising the car .......................... 99
Ready to start ............................... 8
Rear mirror
- rear view mirrors .................. 14-24
- driving mirror ......................... 23
Rear window washer
- control ..................................... 13-43
- fluid level ................................ 114
Rear window wiper
- controls.................................... 13-43
- blades ...................................... 127
- sprayer ..................................... 124
Rev counter................................... 34
Reversing lights
(bulb replacement) ................. 90
Roof rack ....................................... 55
Safe driving
- travelling ................................. 70
- driving with ABS ................... 73
- driving in rain.......................... 71
- driving at night ...................... 71
- driving in the mountains ...... 72- driving in fog ........................... 71
- driving on snow and ice .... 72
- before driving ........................ 69
Seat belts ........................................ 12-24
- general warnings .................... 27
- use ..................................... 12-24-26
- maintenance .......................... 28
- adjusting the height of the
seat belts ................................ 12-25
Seats
- cleaning .................................... 127
- adjustments ............................. 11-22
Side/tail lights
- control .................................... 13-41
- front bulb replacement ...... 89
- rear bulb replacement.......... 90
Side/tail lights
- control ..................................... 13-42
- front bulb replacement ...... 89
- side bulb replacement ......... 89
- rear bulb replacement.......... 90
Snow chains ................................. 77
Sound system ............................... 60
- aerial ......................................... 62
- standard equipment .............. 61
144-152 03/03/2003 07:30 PM Page 146