2003 FIAT PALIO remove seats

11
KEYS
A set of 2 keys are provided with
the car for
fig. 5:
– ignition;
– locking/unlocking the front doors;
– locking/unlocking the boot.
STEERING COLUMN LOCK
It is automatically locked when the
ignition key is removed. It is
unlocked when the key is turned to
MAR; lightly move the steering
wheel in either direction if the rota-
tion of the key is difficult.
fig. 5
P4E02062
HEAD RESTS
Adjust the headrest fig. 7such that
the nape, and not the neck, rests on
them, making sure that they are
locked in the desired position. Refer
to the “Getting to know the car”
chapter.
SEATS
All adjustments must
be made when the car is
stationary.
Seat adjustment fig. 6.
A- To move the seat forwards or
backwards.
B- Seat back inclination adjust-
ment.
fig. 7
P4E01603
fig. 6
P4E01989
1-19 03/03/2003 05:44 PM Page 11

Once you have released the lever,
check that the seat is firmly locked in
the runners by trying to move it back
and forth. Failure to lock the seat in
place could result the seat moving sud-
denly and the driver losing control of
the car.
Adjusting the reclining seat
back
Turn knob B-fig. 3until the back
reaches the reclination you desire.
Do not remove the seats
nor carry out mainte-
nance and/or repair oper-
ations on them. Improper oper-
ations can compromise safety de-
vice operation. Always go to a Fi-
at Dealership.
22
Moving the seat backwards or
forwards
Lift the lever A-fig. 3and push the
seat forwards or backwards; you are
in the correct position for driving
when your hands are resting on the
steering wheel rim and your arms are
slightly bent.
Only make adjustments
when the car is station-
ary.
STEERING COLUMN LOCK
Engagement:
After turning the key
to position STOP or PARK remove it
and turn the steering wheel till it locks .
To release: Gently move the steer-
ing wheel from side to side as you turn
the ignition key to
MAR.
Never remove the igni-
tion key while the car is
moving. The steering
wheel will automatically lock as
soon as you turn it. This also ap-
plies when the car is being towed.
INDIVIDUAL SET-
TINGS
FRONT SEATS fig. 3
fig. 3
P4E01989
20-63 03/03/2003 06:02 PM Page 22

Do not use the ashtray
as a waste paper basket:
the paper could catch fire
if it comes in contact with a cig-
arette butt.
47
ASHTRAY
For the front seats fig. 46
Open flap Apulling it backwards.
The ashtray can be removed.
fig. 46
P4E02033
For the rear seats fig. 47
For the rear seats, there is a foldaway
ashtray on the side panel.
To use it, turn it towards the direc-
tion shown by the arrow.
To remove the ashtray, press on the
retaining tab.
fig. 47
P4E01624
fig. 48
P4E02034
SUNVISORS
These are positioned to the sides of
the rearview mirror. They can be
swung up or down or pivoted side-
ways.
On the back of the driver’s sun visor
there is a document-pocket, and a
courtesy mirror is fitted on the back
of the passenger’s sunvisor
fig. 48.
20-63 03/03/2003 06:03 PM Page 47

50
Do not keep the switch
pressed when the window
is completely wound up
or down.
Improper use of the
electrical windows can be
dangerous.
Before and during their opera-
tion ensure that no passengers
are at risk from the moving glass
either by personal objects getting
caught in the mechanism or by
being injured by it directly.
Always remove the ignition key
when you get out of the car to
prevent the electric windows be-
ing operated accidentally and
constituting a danger to the peo-
ple left in the car.
fig. 54
P4E02012
Rear electric windows
Inside the handle of each door there
is a button
A-fig. 54to activate the
relevant window.
Press the switch to lower the win-
dow.
Pull the switch to raise the window.
Additional buttons to control the rear
windows from the front seats are lo-
cated near the gear lever on the cen-
tral console:
B - rear left-hand window button;
C - rear right-hand window button;
D - rear door enable button (the
lights in the rear window buttons will
go out when the window winders are
disabled).
Manual window winders fig. 55
Use the appropriate handleA to
wind the window up or down.
fig. 55
P4E01791
20-63 03/03/2003 06:03 PM Page 50

53
If you want to carry a
can of petrol as a reserve,
adhere to the laws in
force. Not following precautions
increases the risk of fire in the
event of an accident. To remove the
parcel shelf
1)
Free the upper extremities A-fig.
61
of the two tie rods, withdrawing
the eyelets from the pins.
2)Free the cover pins A-fig. 62
from their seats Band remove it.
After removing, the cover can be
transversally positioned between the
front seat backs and the tipped chush-
ion of the rear seat.
IMPORTANT If the load in the
boot is fairly heavy and you are trav-
elling at night, check and adjust the
height of the dipped beam headlights
(see“ Headlights” paragraph in this
chapter).
Heavy loads which are
not securely anchored
could seriously injure pas-
sengers in the event of an acci-
dent.
We suggest you do not
drive with the tailgate
open, as the exhaust gas-
es can come inside the car via the
boot.
fig. 62
P4E01750
20-63 03/03/2003 06:03 PM Page 53

61
STANDARD EQUIPMENT
The system consists of:
- radio power supply cables;
- cables for speakers and tweeters on
front doors;
- cables for rear speakers on lug-
gage cover supports.
- Aerial wire;
- radio housing;
- front speaker housing (on front
doors);
- rear speaker housing (on luggage
cover supports).The radio must be mounted in the
proper housing occupied by the cov-
er A-fig. 69, which can be removed
operating the two tongues in the
points
B.
The power wires, speaker and aeri-
al connection wires can be found in
the compartment.For the front speakers, use the seats
on the object-holder pocket of the door
panel. To have access, unscrew the
screws indicated in
fig. 70.
For the tweeters, use the pressure-
fit seatings shown in
fig. 71.
The rear speakers must be posi-
tioned under the side supports of the
luggage cover
fig. 72.
fig. 69
P4E02040
fig. 70
P4E01751
fig. 71
P4E02042
fig. 72
P4E011752
20-63 03/03/2003 06:03 PM Page 61

67
With handbrake engaged and igni-
tion key at
MAR, the instrument pan-
el warning light
x
comes on.
To disengage the handbrake:
1)Slightly lift the handbrake and
press release button
A.
2)Keep the button pressed in and
lower the lever. Warning light
x
will
go out.
3)To prevent accidental movement
of the car, this procedure should be
carried out with the brake pedal
pressed down.
HANDBRAKE fig. 1
The handbrake lever is situated be-
tween the two front seats.
Pull the handbrake lever upwards un-
til the car cannot be moved. Four or
five clicks are generally enough when
the car is on level ground while nine
or ten may be required if the car is
on a steep slope or loaded.
IMPORTANTIf this is not the
case, take the car to a
Fiat Dealer-
ship
to have the handbrake adjusted.
Never leave unsuper-
vised children in the car.
Always remove the key
from the ignition switch and take
it with you when you get out of
the car.
fig. 1
P4E02046
PARKING
Stop the engine, engage the hand-
brake and engage first gear if the car
is faced uphill or reverse gear if it is
faced downhill in compliance with the
national Highway Code and leave the
wheels steered towards the road bor-
ders or the kerb. Block the wheels
with a wedge or a stone if the car is
parked on a steep slope.
Do not leave the ignition key at
MARbecause it drains the battery.
Always remove the key when you
leave the car.
64-79 03/03/2003 06:45 PM Page 67

127
Detergents pollute wa-
ter. The car must there-
fore be washed in an area
equipped for the collection and
purification of the liquids used
while washing.
IMPORTANT
The engine com-
partment should be washed while the
engine is cold and with the ignition key
at
STOP. After washing make sure
that the various protections (e.g. rub-
ber boots and various guards) have
not been removed or damaged.
IMPORTANTTo prevent damage
to the electric heater element, wipe the
inside of the heated rear window gen-
tly in the same direction as the ele-
ments.
Engine compartment
At the end of each winter season,
carefully clean the engine compart-
ment. Have this done at a garage.
INTERIORS
Periodically check that water has not
collected under the mats (from dip-
ping shoes, umbrellas etc.) which could
cause the steel to rust
CLEANING SEATS AND
FABRIC COMPONENTS
– Remove dust with a soft brush or
vacuum cleaner.
– Brush the seats with a damp
sponge with water and a neutral soap.
Never use flammable
products (petroleum
ether or petrol) to clean
the inside of the car. Electro-
static charges generated by rub-
bing while cleaning could cause
fires.
Do not keep aerosol
cans in the car. There is
the risk they might ex-
plode. Aerosol cans must never
be exposed to a temperature
above 50°C; when the weather
starts to get hot the temperature
inside the car might go well be-
yond that figure.
PLASTIC PARTS INSIDE THE
CAR
Use special products designed not to
alter the appearance of the compo-
nents.
IMPORTANTDo not use alcohol
or petrol to clean the glass of the in-
strument panel.
104-127 03/03/2003 06:53 PM Page 127