2002 Peugeot 307 Break Dag wipers

STEERING WHEEL
STALKS LIGHTING
Front and rear lights (ring A)Lights off. Side lights on.
Dipped/ main beam headlampson. Automatic switching on of lights*
Front fog lamps * and rear foglamp
Turn the ring towards the front to switch on and towards the rear to
switch off. The on/off status isshown by the indicator light onthe instrument panel. Vehicles fitted with a rear foglamp (ring B)
Rear fog lamp.
Vehicles fitted with front foglamps and a rear fog lamp(ring C) Front fog lamps (first rota-tion of the ring forwards).
Front fog lampsand rear fog lamp(second rotation ofthe ring
forwards)
* According to specification WINDSCREEN WIPERS Front
2 Rapid wipe (heavy rain)
1 Normal wipe (moderately heavy rain)
AUTO Automatic wipe*
0 Stop
Single wipe
Wash-wipe: pull the stalktowards you. Rear
Stop Intermittent W ash-
wipe wipe
Automatic wipe*In the AUTO position,
the system automatically adjusts the wiper timingto the intensity of therainfall.
7274
YOUR 307 AT A GLANCE5

AUTOMATIC SWITCHING ON OF LIGHTS* Side lights and dipped beam head- lamps switch on automatically if the
light is poor, or during operation of
the windscreen wipers. They switch
off as soon as the light becomesbright enough or the windscreenwipers stop. Note :In foggy weather the bright-
ness sensor can detect sufficient
light. As a consequence, the lights
wil not come on automatically. This function is active when the
vehicle is supplied to the customer.
To disarm or activate the function: Start with the key in the accesso- ries position (1st notch),
Press the end of the stalk formore than two seconds.
Note: after the ignition is switched
off and depending on the brightness,the lights remain on for 45 secondsor until the vehicle is locked. Do not cover the brightness sen- sor located in the centre of thefascia. It is used for automaticswitching on of the lights. Operating check
Triggering of the sensorAcivation of this function is accom- panied by an audible signal"Automatic lighting''
on the multi-
function display. The light also comes on as soon as the driver changes the stalk positionto 0. Disarming Disarming of the function is accom- panied by an audible signal Note: the function is temporarily
disarmed when the driver uses the manual lighting controls. If the brightness sensor does not function correctly , the system acti-
vates the function (the lights comeon). The driver is alerted by an audible signal, accompanied by the messa-ge "Automatic switching on of
lights faulty" .
Contact a PEUGEOT dealer to havethe system checked.
*According to specification
YOUR 307 IN DETAIL 73

Automatic timed windscreen wipers* In the AUTOposition, the wind-
screen wipers operate automatically and adapt their speed to the intensi-ty of the rainfall.
Operating check ActivationWhen the function is activated, the message "Automatic windscreen
wiping active" appears on the mul-
tifunction display. Switching off
Switching off the function is accom- panied by an audible signal. In the event of malfunction, the driver is informed by an audible signal andthe message "Auto windscreen
wiper faulty" on the multifunction
display. In the event of malfunction in the
AUTO position, the windscreen
wiper will operate in intermittentmode.
Contact a PEUGEOT dealer to have the system checked.
* According to specification
WINDSCREEN WIPER STALK Front windscreen wipers
2 Fast wipe (heavy rain)
1 Normal wipe (moderately heavy rain)
AUTO Automatic wipe*
0 Off
Single wipe (press downwards) Operation In position
1or 2, when the vehicle
stops, the windscreen wiper changes to a lower wiping speed, then resumesits initial speed when the vehicle startsagain. When the ignition has been swit- ched off for more than a minute with
the control in the AUTO* position, itis necesary to reactivate this func-tion. To do this, move the control to any
position, then move it back to the
AUTO* position.
Screenwash and headlamp wash* Pull the windscreen wiper stalk towards you. The windscreen wash then the wind- screen wipers operate for a fixed
period. The headlamp wash ope-rates simultaneously for a fewseconds, only if the dipped beam
or main beam headlamps are on.
YOUR 307 IN DETAIL
74

Maintenance position This position enables the wiper blade to be removed.
In the minute following switching off of the ignition, any action on the stalkpositions the wipers in the centre ofthe windscreen (winter parking, clea-ning, replacing the blades).
To reposition the wipers after this has been done, switch on the ignitionand operate the stalk.
* According to specification
YOUR 307 IN DETAIL75
When using an automatic car wash, switch off theignition or check that thewiper control is not in theautomatic position.
In winter it is advisable to wait forthe windscreen to completelyclear of ice before operating theautomatic wipe. Rear windscreen wiper
Turn ring
Ato the first notch for inter-
mittent wiping. Rear windscreen wash
Turn ring Apast the first notch; the
windscreen wash then the wind- screen wiper operate for a specifiedtime.