Removal
IRemove propeller shaft.
Insert plug into transfer or transmission after removing pro-
peller shaft.
IRemove axle shaft. Refer to RA section.
CAUTION:
IBe careful not to damage spline, sleeve yoke and front oil
seal when removing propeller shaft.
Installation
IFill final drive with recommended gear oil.
SPD123
REMOVAL AND INSTALLATION (Rear final drive Ð H233B)
PD-13
Removal
IDrain oil from transfer and transmission.
IRemove front and rear propeller shafts Ð Refer to PD section.
IInsert plug into oil seal after removing propeller shaft.
CAUTION:
Be careful not to damage spline, sleeve yoke and rear oil seal,
when removing propeller shaft.
IRemove torsion bar Ð Refer to removal and installation of
lower link in FA section. Then remove fifth crossmember.
IRemove transfer control lever from transfer outer shift lever.
IRemove transfer from transmission.
WARNING:
Support transfer while removing it.
Installation
IApply recommended sealant to mating surface to transmission.
Recommended sealant:
Nissan genuine part (KP610-00250) or equivalent
ITighten bolts securing transfer.
Bolt No.Tightening torque
N×m (kg-m, ft-lb)mm (in)
q
131 - 41 (3.2 - 4.2, 23 - 30) 45 (1.77)
q
231 - 41 (3.2 - 4.2, 23 - 30) 60 (2.36)
SMT478A
NMT010
SMT495A
SMT496A
REMOVAL AND INSTALLATION
TF-7
