2002 HONDA S2000 Owners Manual

If you are changing the bulb on
the driver’s side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger’s side, turn
the steering wheel to the left.Pull the inner f ender cover back.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket.Install the new bulb in the socket.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Testthelightstomakesurethe
new bulb is working.
Put the inner f ender in place.
Install the two holding clips. Lock
each clip in place by pushing on
the center.
Use a f lat-tipped screwdriver to
remove the three holding clips
f rom the inner f ender.
1.
2. 3. 4. 5.6. 7. 8. 9.
Lights
Maint enance
Replacing Front Turn Signal and
Side Marker L ight Bulbs 202

Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
Put the bulb holder back into its
hole in the lens, and turn it
clockwise until it locks.
Testthelightstomakesurethe
new bulb is working.
Use a small f lat blade screwdriver
to pry caref ully on the back edge
of the side turn signal assembly
until it pops out of the body.
Turn the bulb holder one-quarter
turn counterclockwise to remove it
from the lens. Put the side turn signal assembly
back into the body, front first.
Push on the back edge until it
snaps into place.
1. 2. 3. 4. 5. 6.
Lights
Maint enance
Replacing a Side T urn Signal Bulb
203

Open the trunk. Determine which of the f our bulbsis burned out: stop/taillight, back-
up light, turn signal, or side
marker.Remove the socket by turning it
one-quarter turn counterclockwise.
Remove the fasteners from the
trunk lining. To remove a f astener,
push on the center of the head
until it pops in. Then pull it out.
Pull the lining back. Remove the burned out bulb. To
remove the stop/taillight, back-up
or side marker light bulb, pull the
bulb straight out of its socket. To
remove the turn signal light bulb,
push it in and turn it
counterclockwise until it unlocks.
1. 2. 3.
4.
5. 6.
Lights
Maint enance
Replacing Rear Bulbs 204

Install the new bulb in the socket.
Testthelightstomakesurethe
new bulb is working.
Push the socket into the light
assembly and turn it clockwise
until it locks.
Install the trunk lining and secure
it with the fasteners. To reinstall a
f astener, reset the f astener by
pushing on the pointed end until it
pops back almost f lush with the
f ingers on the housing. Put the
f astener in the hole of the trunk
lining and push on the center until
it locks (the center is flush with
the head).
7. 8. 9.
10.
Lights
Maint enance205

Insert a flat-tipped screwdriver
between the lef t edge of the lens
and the housing. The lens will
come down.Put the lens back into the light
assembly, right side f irst. Push on
the lef t edge until it snaps into
place.
Testthelightstomakesurethe
new bulb is working.
Pull the bulb straight out of its
socket. Push the new bulb in until
it bottoms in the socket.
1.
2. 3. 4.
Lights
Maint enance
Replacing a Rear License Plate Bulb 206

Open the trunk. Pull down the
trunk light cover.
Remove the bulb by pulling it
straight out of its metal tabs.
Push the new bulb into the metal
tabs.
Push the cover back in place.
Removethelensbycarefully
prying on the f ront edge of the
lens near both sides.
Remove the bulb by pulling it
straight out of its metal tabs.
Push the new bulb into the metal
tabs. Snap the lens back in place.
1.
2. 3.
4.
1.2.3.
Lights
Maint enance
Replacing the T runk L ight Bulb
Replacing an Interior L ight Bulb
207

Block the rear wheels.
Disconnect the battery.If possible, run the engine f or a
while periodically (pref erably once
amonth).
Support the f ront wiper blade
arms with a f olded towel or rag so
they do not touch the windshield.
To minimize sticking, apply a
silicone spray lubricant to all door
and trunk seals. Also, apply a
vehiclebodywaxtothepainted
surfaces that mate with the door
and trunk seals.
Fill the f uel tank.
Change the engine oil and f ilter
(see page ).
Wash and dry the exterior
completely.
Cleantheinterior.Makesurethe
carpeting, floor mats, etc. are
completely dry.
If you need to park your car f or an
extended period (more than one
month), there are several things you
should do to prepare it f or storage.
Proper preparation helps prevent
deterioration and makes it easier to
get your car back on the road. If
possible, store your car indoors.
If the car is to be stored for a
longer period, it should be
supported on jackstands so the
tires are of f the ground.
Leave one window open slightly (if
the car is being stored indoors).Coverthecarwitha‘‘breathable’’
cover, one made f rom a porous
material such as cotton.
Nonporous materials, such as
plastic sheeting, trap moisture,
which can damage the paint.
If you store your car f or 12 months
or longer, have your Honda dealer
perf orm the inspections called f or in
the 24 months/30,000 miles (48,000
km) maintenance schedule as soon
as you take it out of storage (see
page ). The replacements called
f or in the maintenance schedule are
not needed unless the car has
actually reached that time or mileage.
Raise the convertible top cover.
Leave the parking brake off. Put
the transmission in Reverse. 165
154
Maint enance
St oring Your Car
208

.................................
Exterior Care . 210
.....................................
Washing . 210
.......................................
Waxing . 211
....................
Aluminum Wheels . 212
..........................
Paint Touch-up . 212
..................................
Interior Care . 213
...................................
Carpeting . 213
.................................
Floor Mats . 213
.........................................
Fabric . 214
...........................................
Vinyl . 214
.......................................
Leather . 214
.............................
Rear Window . 214
...................................
Seat Belts . 214
....................................
Windows . 215
..........................
Air Fresheners . 215
....................
Corrosion Protection . 215
.................................
Body Repairs . 217
Regular cleaning and polishing of
your Honda helps to keep it ‘‘new’’
looking. This section gives you hints
on how to clean your vehicle and
preserve its appearance: the paint,
brightwork, wheels, and interior.
Also included are several things you
candotohelppreventcorrosion.
Appearance Care
Appearance Care
209